journal article·2012-06

Improving the damp-heat stability of copper indium gallium diselenide solar cells with a semicrystalline tin dioxide overlayer

B. Selin Tosun, Rebekah K. Feist, Aloysius Gunawan, K. Andre Mkhoyan, Stephen A. Campbell, Eray S. Aydil

Publisher page

Abstract

Abstract While copper indium gallium diselenide (CIGS) thin film solar cells with laboratory efficiencies exceeding 20% have been reported, these high efficiencies may degrade with time as the devices are exposed to humid environments. Specifically, it is well known that water can diffuse to the CIGS–CdS–ZnO heterojunction. This penetration must be reduced or stopped to increase the solar cell lifetime. Herein, we show that tin dioxide layers deposited on top of completed CIGS solar cells can significantly increase the device lifetime by forming a barrier against water diffusion. Specifically, in accelerated damp-heat tests, our best results showed that initially 8–12% efficient CIGS solar cells did not decay from this peak efficiency even after 240 h at 85 °C and 85% relative humidity. In comparison, under identical test conditions, the solar cells without the tin dioxide layer lost nearly 80% of their initial efficiency, within 24 h after commencing the test. We deposited the tin dioxide films by radio frequency magnetron sputtering from tin dioxide targets at 5 mTorr. Semicrystalline SnO 2 films deposited at room temperature had SnO 2 nanocrystals embedded in amorphous SnO 2 without grain boundaries. The semicrystalline films exhibited better damp-heat stability than crystalline films deposited at higher temperature. We infer from the slow open circuit voltage decay that water permeation to the p–n junction is reduced when semicrystalline SnO 2 overlayers are used to protect the solar cell. We attribute this difference in damp heat stability to the lack of grain boundary water diffusion in semicrystalline SnO 2 films.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · ZnO doping and properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (19)

Show source-provided references
1. 19.9%-efficient ZnO/CdS/CuInGaSe2 solar cell with 81.2% fill factor10.1002/pip.822 ↗
2. Cu(In,Ga)Se2-based thin-film photovoltaic modules optimized for long-term performance10.1016/S0927-0248(02)00101-0 ↗
3. Stability behavior of Cd-free Cu(In,Ga)Se2 solar modules with In2S3 buffer layer prepared by atomic layer deposition10.1016/j.tsf.2004.11.056 ↗
4. Progress development of high performance CIGS modules for mass production10.1016/S0040-6090(00)01708-9 ↗
5. The change of electronic properties of CIGS devices induced by the damp heat treatment10.1016/S0040-6090(01)01510-3 ↗
6. Influence of damp heat testing on the electrical characteristics of Cu(In,Ga)(S,Se)2 solar cells10.1016/S0040-6090(01)01511-5 ↗
7. Encapsulation of Cu(InGa)Se2 solar cell with Al2O3 thin-film moisture barrier grown by atomic layer deposition10.1016/j.solmat.2010.08.021 ↗
8. Sputter deposition of semicrystalline tin dioxide films10.1016/j.tsf.2011.10.169 ↗
9. A study of the influence of the Ga content on the long-term stability of Cu(In,Ga)Se2 thin film solar cells10.1016/S0040-6090(03)00185-8 ↗
10. Influence of damp heat on the electrical properties of Cu(In,Ga)Se2 solar cells10.1016/S0040-6090(99)00820-2 ↗
11. Behaviour of Cu(In,Ga)Se2 solar cells under light/damp heat over time10.1016/S0026-2714(03)00355-X ↗
12. J. Pern, R. Sundaramoorthy, C. Dehart, S. Glynn, X. Li, I. Repins, L. Mansfield, M. Contreras, R. Noufi, T. Gessert, N.R.E.L.C.I.G.S. Cell-Level Reliability Task and Studies. 〈http://www1.eere.energy.gov/solar/pdfs/pvrw2010_poster_pern.pdf〉, May 22nd 2011.
13. RF magnetron sputtered ZnO:Al thin films on glass substrates: a study zof damp heat stability on their optical and electrical properties10.1016/j.solmat.2007.07.008 ↗
14. Stability of sputtered ITO thin films to the damp-heat test10.1016/j.surfcoat.2005.11.114 ↗
15. The dry and damp heat stability of chalcopyrite solar cells prepared with an indium sulphide buffer deposited by the spray-ILGAR technique10.1016/j.tsf.2005.11.096 ↗
16. Orientation and morphological evolution of catalyst nanoparticles during carbon nanotube growth10.1021/nn100944n ↗
17. Egerton · 2011
18. Separation of bulk and surface-losses in low-loss EELS measurements in STEM10.1016/j.ultramic.2006.09.003 ↗
19. Effects of amorphous layers on high-resolution ADF-STEM imaging10.1016/j.ultramic.2008.01.007 ↗