journal article·2017-01

On the beneficial effect of Al2O3 front contact passivation in Cu(In,Ga)Se2 solar cells

Jan Keller, Fredrik Gustavsson, Lars Stolt, Marika Edoff, Tobias Törndahl

Publisher page

Abstract

This study reports on the beneficial effect of an absorber surface passivation by Al 2O 3 on the performance of Cu(In, Ga)Se 2 (CIGSe) solar cells. Here the Al 2O 3 layer is deposited by atomic layer deposition (ALD) subsequently to a CdS buffer layer. It is shown that a very thin film of about 1 nm efficiently reduces the interface recombination rate if the buffer layer is too thin to not fully cover the CIGSe absorber. An Al 2O 3 thickness of 1 nm is sufficiently low to allow current transport via tunneling. Increasing the thickness to >1 nm leads to a detrimental blocking behavior due to an exponentially decreasing tunnel current. Losses in open circuit voltage ( V oc) and fill factor ( FF) when reducing the buffer layer thickness are significantly mitigated by implementing an optimized Al 2O 3 layer. It is further shown, that the heat treatment during the ALD step results in an increase in short circuit current density ( J sc) of about 2 mA/cm 2 . This observation is attributed to a widening of the space charge region in the CIGSe layer that in turn improves the collection probability of electrons. For not fully covering CdS layers the decrease in interface defect density by the passivation contributes as well, leading to a gain of about 5 mA/cm 2 for cells without a buffer. Finally, the leakage current of the solar cell devices could be reduced when applying the Al 2O 3 layer on insufficiently covering CdS films, which proves the capability of mitigating the effect of shunts or bad diodes.
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Semiconductor materials and interfaces

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (26)

Show source-provided references
1. Cu(In,Ga)Se2 thin-film solar cells and modules – a boost in efficiency due to potassium10.1109/JPHOTOV.2014.2377516 ↗
2. Properties of Cu(In,Ga)Se2 solar cells with new record efficiencies up to 21.7%
3. Potassium-induced surface modification of Cu(In,Ga)Se2 thin films for high-efficiency solar cells10.1038/nmat3789 ↗
4. Efficiency enhancement of Cu(In,Ga)Se2 thin-film solar cells by a post-deposition treatment with potassium fluoride10.1002/pssr.201307238 ↗
5. Features of KF and NaF postdeposition treatments of Cu(In,Ga)Se2 absorbers for high efficiency thin film solar cells10.1021/acs.chemmater.5b02335 ↗
6. Potassium postdeposition treatment-induced band gap widening at Cu(In,Ga)Se2 surfaces – reason for performance leap?10.1021/acsami.5b09231 ↗
7. Alkali-templated surface nanopatterning of chalcogenide thin films: a novel approach toward solar cells with enhanced efficiency10.1021/acs.nanolett.5b00584 ↗
8. Development of rear surface passivated Cu(In,Ga)Se2 thin film solar cells with nano-sized local rear point contacts10.1016/j.solmat.2013.07.025 ↗
9. Highly reflective rear surface passivation design for ultra-thin Cu(In,Ga)Se2 solar cells10.1016/j.tsf.2014.10.050 ↗
10. Improved rear surface passivation of Cu(In,Ga)Se2 solar cells : a combination of an Al2O3 rear surface passivation layer and nanosized local rear point contacts10.1109/JPHOTOV.2013.2287769 ↗
11. Surface passivation of Cu(In,Ga)Se2 using atomic layer deposited Al2O3 Surface passivation of Cu(In,Ga)Se2 using atomic layer deposited Al2O310.1063/1.3675849 ↗
12. On the assessment of CIGS surface passivation by photoluminescence10.1002/pssr.201510081 ↗
13. Native defects in Al2O3 and their impact on III-V/Al2O3 metal-oxide – semiconductor-based devices10.1063/1.3544310 ↗
14. A chemical bonding model for the native oxides of the III–V compound semiconductors10.1116/1.571038 ↗
15. Physical and electrical properties of noncrystalline Al2O3 prepared by remote plasma enhanced chemical vapor deposition physical and electrical properties of noncrystalline Al2O3 prepared by remote plasma enhanced chemical vapor deposition10.1116/1.1379316 ↗
16. Behavior of hydrogen in high dielectric constant oxide gate insulators Behavior of hydrogen in high dielectric constant oxide gate insulators10.1063/1.1609245 ↗
17. Investigating the electronic properties of Al2O3/Cu(In,Ga)Se2 interface10.1063/1.4932512 ↗
18. Substitution of the CdS buffer layer in CIGS thin-film solar cells10.1002/vipr.201400546 ↗
19. Depth pro fi ling of a CdS buffer layer on CuInS 2 measured with X-ray photoelectron spectroscopy during removal by HCl etching10.1016/j.tsf.2011.10.144 ↗
20. Chemical bath deposition of Zn(O,S) and CdS buffers: Influence of Cu(In,Ga)Se2 grain orientation10.1063/1.4788717 ↗
21. Interface study of CuInSe2/ZnO and Cu(In,Ga)Se2/ZnO devices using ALD ZnO buffer layers10.1016/S0040-6090(03)00229-3 ↗
22. Shunt mitigation in ZnO:Al/ i-ZnO/CdS/Cu(In,Ga)Se2 solar modules by the i-ZnO/CdS buffer combination
23. 19,9/%-efficient ZnO/CdS/CuInGaSe2 solar cell with 81,2% fill factor10.1002/pip.822 ↗
24. Effect of annealing on CdS/Cu(In,Ga)Se2 thin-film solar cells10.1016/j.cap.2010.11.018 ↗
25. Investigation of rapid thermal annealing on Cu(In,Ga)Se2 films and solar cells10.1016/j.solmat.2006.04.011 ↗
26. Thin-film solar cells: device measurements and analysis10.1002/pip.518 ↗