Charge trapping, hydrogen accumulation, and structural rearrangement: A complete model for ultraviolet-induced degradation in TOPCon devices
Source abstract
Abstract
Tunnel oxide passivated contact (TOPCon) solar cells are susceptible to ultraviolet (UV)-induced degradation (UVID), which reduces their long-term performance. This study investigates the UVID mechanism in TOPCon lifetime structures with thin (4 nm) and thick (7 nm) AlO x layers. We use a cycle of UV exposure, dark storage, and dark annealing to track changes in chemical and field-effect passivation. During UV exposure, the chemical passivation degrades, shown by an increase in the interface defect density (D it ). We attribute this to high-energy UV photons breaking Si-H bonds within the SiN x capping layer, which releases mobile hydrogen that subsequently accumulates at the interface, thereby causing recombination-active defects. In contrast, the field-effect passivation is temporarily enhanced by charge trapping in the AlO x , which increases its negative fixed charge (Q f ). A subsequent “dark storage degradation” occurs as these charges de-trap, while the chemical damage remains unchanged. During dark annealing, the accumulated hydrogen at the interface diffuses into the silicon bulk. This reduction in interfacial hydrogen concentration restores surface chemical passivation, as confirmed by a decrease in D it . Although the chemical passivation shows a full recovery, as confirmed by a decrease in D it , the FTIR analysis reveals that the complete degradation and recovery cycle induces a permanent structural rearrangement of the dielectric stack. Furthermore, the results show that the thicker 7 nm AlOx layer provides better UVID resilience. Since the field-effect passivation behaves similarly for both thicknesses, we attribute this resilience to the thicker film acting as a more effective physical barrier, reducing the transport of mobile hydrogen to the interface. This work presents a comprehensive model that links the observed UVID to specific, underlying structural changes in the passivation stack, providing guidance to address this failure mode at the solar cell level. • UVID in TOPCon is a change in both chemical degradation and a temporary field-effect enhancement. • A secondary “dark storage degradation” is caused by the de-trapping of negative charges from the AlO x layer. • Thermal recovery induces a permanent structural transformation of the passivation stack, not a simple reversal of damage. • FTIR reveals irreversible SiN x rearrangement and a chemical transformation and densification of the interfacial oxide layer during the recovery cycle. • A thicker (7 nm) AlO x layer provides superior UVID resilience by acting as a more effective hydrogen barrier.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Silicon and Solar Cell Technologies · Photovoltaic System Optimization Techniques · solar cell performance optimization
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (34)
Show source-provided references
1. UV-induced degradation of PERC solar modules with UV-transparent encapsulation materials10.1002/pip.2861 ↗
2. UV-induced degradation of high-efficiency silicon PV modules with different cell architectures10.1002/pip.3606 ↗
3. UV-Induced degradation of industrial PERC, TOPCon, and HJT solar cells: the next big reliability challenge?10.1002/solr.202400628 ↗
4. UV-induced degradation in TOPCon solar cells: hydrogen dynamics and impact of UV wavelength10.1016/j.solmat.2025.113895 ↗
5. 2025
6. UV radiation hardness of photovoltaic modules featuring crystalline Si solar cells with AlOx/p+-type Si and SiNy/n+-type Si interfaces10.1002/pssr.201700178 ↗
7. Effects of the irradiance intensity during UV accelerated aging test on unencapsulated silicon solar cells10.1016/j.solener.2017.08.044 ↗
8. Terrestrial photovoltaic (PV) modules - design qualification and type approval
9. Short wavelength photons destroying Si–H bonds and its influence on high-efficiency silicon solar cells and modules10.1002/solr.202370153 ↗
10. High efficiency n-type silicon solar cells with passivating contacts based on PECVD silicon films doped by phosphorus diffusion10.1016/j.solmat.2019.01.005 ↗
11. A review on p-Type tunnel oxide passivated contact (TOPCon) solar cell10.1007/s42341-023-00433-z ↗
12. Dielectric surface passivation for silicon solar cells: a review
13. Excellent passivation of highly doped p-type Si surfaces by the negative-charge-dielectric Al2O310.1063/1.2784168 ↗
14. Status and prospects of Al2O3-based surface passivation schemes for silicon solar cells10.1116/1.4728205 ↗
15. Passivating contacts for crystalline silicon solar cells: an overview of the current advances and future perspectives
16. Degradation of carrier lifetime in Cz silicon solar cells10.1016/S0927-0248(00)00098-2 ↗
17. High-efficiency crystalline silicon solar cells: status and perspectives10.1039/C5EE03380B ↗
18. Ultralow surface recombination of c-Si substrates passivated by plasma-assisted atomic layer deposited Al2O310.1063/1.2240736 ↗
19. Negative charge and charging dynamics in Al2O3 films on Si characterized by second-harmonic generation10.1063/1.2985906 ↗
20. UV-stable surface passivation for crystalline silicon cells in solar modules with UV light transmitting encapsulation materials
21. Stability of Al2O3 and Al2O3/a- sinx:h stacks for surface passivation of crystalline silicon10.1063/1.3264572 ↗
22. Spectra-dependent stability of the passivation quality of Al2O3/c-Si interfaces10.1109/JPHOTOV.2017.2775147 ↗
23. Plasma damage effect on ultraviolet-induced degradation of PECVD sinx:h passivation
24. The effect of light soaking on crystalline silicon surface passivation by atomic layer deposited Al2O310.1063/1.4775595 ↗
25. Reliability of commercial TOPCon PV modules—an extensive comparative study
26. Improved parameterization of auger recombination in silicon10.1016/j.egypro.2012.07.034 ↗
27. Studying light-induced degradation by lifetime decay analysis: excellent fit to solution of simple second-order rate equation10.1109/JPHOTOV.2013.2278663 ↗
28. Measurement of the emitter saturation current by a contactless photoconductivity decay method (silicon solar cells)
29. Evaluating the impact of thermal annealing on c -Si/Al2O3 interface: correlating electronic properties to infrared absorption10.1063/1.5036738 ↗
30. Jordan
31. Passivation and depassivation of silicon dangling bonds at the Si/SiO 2 interface by atomic hydrogen10.1063/1.110758 ↗
32. Atomic hydrogen reactions with Pb centers at the (100) Si/SiO2 interface10.1103/PhysRevLett.72.2745 ↗
33. Modification of silicon nitride surfaces with GOPES and APTES for antibody immobilization: computational and experimental studies10.1088/2043-6262/6/4/045006 ↗
34. Improving the silicon surface passivation by aluminum oxide grown using a non-pyrophoric aluminum precursor10.1002/pssr.201800156 ↗