journal article·2024-09Open access

Light induced degradation of CIGS solar cells

T.S. Vaas, B.E. Pieters, D. Roosen-Melsen, M. van den Nieuwenhof, A. Kingma, M. Theelen, C. Zahren, A. Gerber, U. Rau

Abstract

Considering warranted lifetimes of PV modules of typically 20-30 years, the performance stability of PV modules is one of the most crucial factors regarding power generation and yield. Long term outdoor performance studies depict realistic operation conditions best, but the correlated nature of e.g. irradiance and temperature impedes the physical interpretation. The possibility to control and tune the conditions in laboratory experiments enables to decompose effects, that are typically overlayed in outdoor experiments. This way, laboratory are crucial to interpret the results obtained in outdoor degradation studies. One driving force of degradation of CIGS modules is light exposure. In literature the focus of light induced degradation (LID) of CIGS modules and solar cells is on metastable changes analyzed on time scales ranging from minutes to hours. In this work we expose industrially produced encapsulated CIGS solar cells for more than 1000 h to light with varied intensity under varied temperature conditions. Such, we aim to study temperature and light intensity dependencies of the observed performance changes. Furthermore, we study the influence of applied bias by comparing LID at short and open circuit. We demonstrate that LID under short circuit conditions leads to VOC degradation, while being temperature assisted and not dependent on the irradiance intensity. CIGS solar cells kept at open circuit conditions appear to be stable under illumination. Exploiting the one diode model, we further connect the observed temperature assisted performance loss to enhanced recombination with lower ideality factor, in comparison to the dominant recombination process before degradation.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Chalcogenide Semiconductor Thin Films · Photovoltaic System Optimization Techniques · solar cell performance optimization

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (50)

Show source-provided references
1. NREL · 2023
2. Stability of Cu(In,Ga)Se2 solar cells: A literature review10.1016/j.solener.2016.04.010 ↗
3. Kettle · Prog. Photovolt., Res. Appl. · 2022 · 30 · 136510.1002/pip.3577 ↗
4. Performance stability of photovoltaic modules in different climates10.1002/pip.2904 ↗
5. Performance loss rate of twelve photovoltaic technologies under field conditions using statistical techniques10.1016/j.solener.2014.02.011 ↗
6. Time-dependent open-circuit voltage in CuInSe2/CdS solar cells: Theory and experiment10.1063/1.338377 ↗
7. The effects of sweep rate, voltage bias and light soaking on the measurement of CIS-based solar cell characteristics
8. Time dependent voltage in CuInSe2 and CdTe solar cells
9. Metastable electrical transport in Cu(In,Ga)Se2 thin films and ZnO/CdS/Cu(In,Ga)Se2 heterostructures10.1016/S0375-9601(98)00401-0 ↗
10. Deep centers and fill factor losses in the CIGS devices
11. Behavior of Na and RbF-treated CdS/cu(in,ga)se2 solar cells with stress testing under heat, light, and junction bias
12. Economic lifetimes of solar panels10.1016/j.procir.2022.02.130 ↗
13. P.-O. Westin, P. Neretnieks, M. Edoff, Damp heat degradation of CIGS-based PV modules, in: 21st European Photovoltaic Solar Energy Conference, 2006, pp. 2470–2473.
14. Effects of ZnO:Al films on CIGS PV modules degraded under accelerated damp heat10.1016/j.solmat.2012.05.002 ↗
15. Damp heat and thermal cycling-induced degradation mechanism of AZO and CIGS films in Cu(In,Ga)Se2 photovoltaic modules10.1016/j.cap.2014.12.023 ↗
16. The effect of damp heat-illumination exposure on CIGS solar cells: A combined XRD and electrical characterization study10.1016/j.solmat.2016.07.051 ↗
17. Stability of CIGS solar cells under illumination with damp heat and dry heat: A comparison10.1016/j.solmat.2016.12.039 ↗
18. A study of the influence of the Ga content on the long-term stability of Cu(In,Ga)Se2 thin film solar cells10.1016/S0040-6090(03)00185-8 ↗
19. Influence of deposition pressure and selenisation on damp heat degradation of the Cu(In,Ga)Se2 back contact molybdenum10.1016/j.surfcoat.2014.05.001 ↗
20. Influence of Mo/MoSe2 microstructure on the damp heat stability of the Cu(In,Ga)Se2 back contact molybdenum10.1016/j.tsf.2016.06.028 ↗
21. Potential-induced degradation of CuIn1−xGax Se2 thin film solar cells10.1109/JPHOTOV.2013.2253833 ↗
22. In-depth analysis of potential-induced degradation in a commercial CIGS PV module10.1002/pip.3670 ↗
23. Characterization of potential-induced degradation and recovery in CIGS solar cells10.3390/en14154628 ↗
24. Investigating PID shunting in polycrystalline CIGS devices via multi-scale, multi-technique characterization10.1109/JPHOTOV.2019.2892874 ↗
25. Potential-induced degradation of Cu(In,Ga)Se2 photovoltaic modules10.7567/JJAP.54.08KC13 ↗
26. Influence of molybdenum back contact on the PID effect for Cu(In,Ga)Se2 solar cells10.3390/coatings9120794 ↗
27. Potential-induced degradation of Cu(In,Ga)Se2 can occur by shunting the front i-ZnO and by damaging the p-n junction10.1016/j.solener.2021.12.074 ↗
28. Recovery after potential-induced degradation of CuIn1−x GaxSe 2 solar cells with CdS and Zn(O,S) buffer layers10.1109/JPHOTOV.2014.2384839 ↗
29. Persistent photoconductivity in Cu(In,Ga)Se2 heterojunctions and thin films prepared by sequential deposition10.1063/1.121762 ↗
30. A model for the open circuit voltage relaxation in Cu(In,Ga)Se2 heterojunction solar cells10.1051/epjap:1999228 ↗
31. Distinguishing metastable changes in bulk CIGS defect densities from interface effects10.1016/S0040-6090(03)00189-5 ↗
32. Blue-photon modification of nonstandard diode barrier in cuinse2 solar cells10.1016/S0927-0248(98)00035-X ↗
33. The metastable changes of the trap spectra of cuinse2-based photovoltaic devices10.1063/1.363631 ↗
34. Switching of deep levels in CuInSe2 due to electric field-induced Cu ion migration10.1063/1.368651 ↗
35. Metastabilities in the electrical characteristics of CIGS devices: Experimental results vs theoretical predictions10.1016/j.tsf.2006.12.038 ↗
36. Large metastability in cu(in,ga)se2 devices: The importance of buffer properties10.1002/pip.3145 ↗
37. Using hole injection layers for decreased metastability and higher performance in cu(in,ga)se2 devices10.1016/j.solmat.2020.110597 ↗
38. Light-and bias-induced metastabilities in Cu(In,Ga)Se2 based solar cells caused by the (VSe-VCu) vacancy complex10.1063/1.2388256 ↗
39. On the magnitude of the persistent photoconductivity (PPC) effect in CIGS layers with and without sodium
40. Persistent photoconductivity in polycrystalline Cu(In,Ga)Se2 thin films: Experiment versus theoretical predictions10.1109/JPHOTOV.2015.2423491 ↗
41. Open-circuit and doping transients of Cu(In,Ga)Se2 solar cells with varying Ga content10.1063/1.4907391 ↗
42. Stability issues of Cu(In,Ga)Se2-based solar cells10.1021/jp993143k ↗
43. Similarities and critical differences in heavy alkali-metal rubidium and cesium effects on chalcopyrite Cu(In,Ga)Se2 thin-film solar cells10.1021/acs.jpcc.9b06042 ↗
44. Light soaking effects on photovoltaic modules: Overview and literature review
45. Impact of rbf-PDT on Cu(In,Ga)Se2 solar cells with cds and Zn(o,s) buffer layers10.1051/epjpv/2020005 ↗
46. Advances in CIGS thin film solar cells with emphasis on the alkali element post-deposition treatment
47. Corp · 2022
48. Pieters · 2023
49. The theory of p-n junctions in semiconductors and p-n junction transistors10.1002/j.1538-7305.1949.tb03645.x ↗
50. Determination of the mobility gap of intrinsic μc-Si: H in pin solar cells10.1063/1.3078044 ↗