Effect of UV ageing on debonding of double glass laminates based on different crosslinking and thermoplastic PV encapsulants
Source abstract
Abstract
To evaluate the potential of novel thermoplastic polyolefin (TPO) encapsulants as alternative for peroxide crosslinking ethylene vinyl acetate (EVA) copolymer and polyolefin elastomers (POE), compressive shear glass laminates were prepared and characterized using EVA and POE benchmark grades and TPO film adhesives (TPO-3.5, TPO-F and TPO-UV). The specimens were exposed to Xenon arc light with an UV irradiation of 40 W/m2, a black panel temperature of 65 °C and relative humidity of 10 % for up to 3,000 h. Visual, optical, mechanical and chemical changes were assessed by light microscopy, UV–visible–near infrared (UVVISNIR) spectroscopy, compressive shear testing, as well as differential scanning calorimetry (DSC), Fourier transform infrared (FTIR) spectroscopy and X-ray photoelectron spectroscopy (XPS) on fractured surfaces. In contrast to EVA and POE laminates, enhanced birefringence was detected due to a higher degree of crystallinity of the TPO encapsulants. Nevertheless, the investigated TPO double-glass laminates revealed a significantly better ultimate mechanical shear performance at 60 °C, also after UV exposure for 3.000 h. TPO-3.5 was the best-performing grade after 3,000 h followed by TPO-UV, TPO-F, EVA and POE. While the aged and fractured EVA, POE, TPO-F and TPO-UV laminates exhibited carboxylic acid signatures differing in intensity, no carboxylic acid residues were detected on the fractured TPO-3.5 surface. TPO-3.5 is characterized by a lower melt flow index and hence, a higher average molar mass compared to TPO-F and TPO-UV. For the crosslinked EVA and POE, the test temperature was already within the melting range of the non-crosslinked, polyethylene rich phase of these peroxide crosslinked encapsulants.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Structural Analysis of Composite Materials · Polymer Nanocomposites and Properties · Silicone and Siloxane Chemistry
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (59)
Show source-provided references
1. Quantifying the cost savings of global solar photovoltaic supply chains10.1038/s41586-022-05316-6 ↗
2. Masson · 2023
3. Feldman · 2023
4. Connecting material degradation and power loss of PV modules using advanced statistical methodology10.1016/j.solmat.2023.112485 ↗
5. Fischer · 2023
6. Dependence of adhesion on degradation mechanisms of ethylene co-vinyl acetate encapsulants over the lifetime of photovoltaic modules
7. Investigation of the crack propensity of co-extruded polypropylene backsheet films for photovoltaic modules10.1016/j.solmat.2023.112438 ↗
8. Ageing characterization of commercial ethylene copolymer greenhouse films by analytical and mechanical methods10.1016/j.biosystemseng.2009.05.003 ↗
9. Structure and basic properties of photovoltaic module backsheet films10.1016/j.solmat.2015.09.060 ↗
10. 2014
11. A study of degradation mechanisms in PVDF-based photovoltaic backsheets10.1038/s41598-022-18477-1 ↗
12. Effect of global damp heat ageing on debonding of crosslinked EVA- and POE-glass laminates10.1016/j.solmat.2023.112602 ↗
13. Fundamentals, present status and future perspective of TOPCon solar cells: a comprehensive review
14. Efficient carrier-selective p- and n-contacts for Si solar cells10.1016/j.solmat.2014.05.039 ↗
15. Sustainable PV module design—review of state-of-the-art encapsulation methods10.3390/su14169971 ↗
16. Comparison of degradation behavior of newly developed encapsulation materials for photovoltaic applications under different artificial ageing tests10.3390/polym13020271 ↗
17. Acetic acid production and glass transition concerns with ethylene-vinyl acetate used in photovoltaic devices10.1016/j.solmat.2006.10.009 ↗
18. Encapsulation of PV modules using ethylene vinyl acetate copolymer as a pottant: a critical review10.1016/0927-0248(95)00150-6 ↗
19. Aging mechanisms of polymeric films for PV encapsulation10.1016/j.solener.2005.02.008 ↗
20. Methodology for local ageing and damage development characterization of solar glass/encapsulant interfaces under superimposed fatigue stresses and environmental influences10.1016/j.solmat.2022.112017 ↗
21. Spinella · 2022
22. Degradation in photovoltaic encapsulant transmittance: results of the second PVQAT TG5 artificial weathering study10.1002/pip.3551 ↗
23. PV encapsulant formulations and stress test conditions influence dominant degradation mechanisms10.1016/j.solmat.2023.112319 ↗
24. Newly developed thermoplastic polyolefin encapsulant–A potential candidate for crystalline silicon photovoltaic modules encapsulation10.1016/j.solener.2019.11.018 ↗
25. Investigation of newly developed thermoplastic polyolefin encapsulant principle properties for the c-Si PV module application10.1016/j.matchemphys.2020.122660 ↗
26. Properties and degradation behaviour of polyolefin encapsulants for photovoltaic modules10.1002/pip.3323 ↗
27. Damp heat resilient thermoplastic polyolefin encapsulant for photovoltaic module encapsulation10.1016/j.solmat.2021.111024 ↗
28. Polyolefin as PID-resistant encapsulant material in PV modules10.1016/j.solmat.2015.10.009 ↗
29. Development and implementation of a simultaneous fatigue crack growth test setup for polymeric hybrid laminates10.1016/j.engfracmech.2022.108468 ↗
30. Temperature dependent fatigue crack growth in electrical steel laminates with μm-thick epoxy layers10.1016/j.engfracmech.2022.108416 ↗
31. Environment assisted cyclic fatigue crack growth testing of polymer/inorganic laminates under strain energy release rate control10.1016/j.ijfatigue.2023.107676 ↗
32. Comparison of crosslinking kinetics of UV-transparent ethylene-vinyl acetate copolymer and polyolefin elastomer encapsulants10.3390/polym14071441 ↗
33. Terrestrial solar spectral data sets10.1016/0038-092X(83)90068-3 ↗
34. Structure–property correlations of polymeric films for transparent insulation wall applications. Part 1: solar optical properties10.1016/j.solener.2005.05.006 ↗
35. Optical properties of highly transparent polypropylene cast films: influence of material structure, additives, and processing conditions10.1002/pen.20503 ↗
36. Compressive-shear adhesion characterization of polyvinyl-butyral and ethylene-vinyl acetate at different curing times before and after exposure to damp-heat conditions10.1002/pip.2270 ↗
37. Analysis of a compressive shear test for adhesion between elastomeric polymers and rigid substrates10.1023/A:1007617102311 ↗
38. Degradation in photovoltaic encapsulation strength of attachment: results of the first PVQAT TG5 artificial weathering study10.1002/pip.3255 ↗
39. D.C. Miller, E. Annigoni, A. Ballion, J.G. Bokria, L.S. Bruckman, D.M. Burns, X. Chen, J. Feng, R.H. French, S. Fowler, C.C. Honeker, M.D. Kempe, H. Khonkar, M. Kohl, L.-E. Perret-Aebi, N.H. Phillips, K.P. Scott, F. Sculati-Meillaud, J.H. Wohlgemuth, Degradation in PV encapsulant strength of attachment: an interlaboratory study towards a climate-specific test, in: 2016 IEEE 43rd Photovoltaic Specialists Conference (PVSC), Portland, OR, USA, IEEE, 62016, 95–100.10.1109/PVSC.2016.7749556 ↗
40. Development of a method for vapour phase trimethylsilylation of surface hydroxyl groups
41. The interaction of waterborne epoxy/dicyandiamide varnishes with metal oxides10.3390/polym14112226 ↗
42. Advanced analysis of ethylene vinyl acetate copolymer materials for photovoltaic modules10.1016/j.polymertesting.2024.108381 ↗
43. Analytical evaluation of the performance of stabilization systems for polyolefinic materials. Part I: interactions between hindered amine light stabilizers and phenolic antioxidants10.1016/j.polymdegradstab.2014.09.020 ↗
44. Advances in the determination of hindered amine light stabilizers - a review10.1016/j.aca.2016.06.001 ↗
45. A molecular study towards the interaction of phenolic anti-oxidants, aromatic amines and HALS stabilizers in a thermo-oxidative ageing process10.1016/S0141-3910(02)00047-2 ↗
46. Comparison of different microclimate effects on the aging behavior of encapsulation materials used in photovoltaic modules10.1016/j.polymdegradstab.2017.03.010 ↗
47. Brune · 2023
48. Morse · 2022 · 1
49. Crosslinking reactions of ethylene vinyl silane copolymers at processing temperatures10.1002/app.1991.070420504 ↗
50. Chemical reactions in crosslinking of copolymers of ethylene and vinyltrimethoxy silane10.1002/app.1991.070420503 ↗
51. Öz · 2021 · 708
52. Aspects of the thermal oxidation, yellowing and stabilisation of ethylene vinyl acetate copolymer10.1016/S0141-3910(00)00111-7 ↗
53. Evaluation of the aging behavior of ethylene copolymer films for solar applications under accelerated weathering conditions10.1016/j.solener.2009.01.009 ↗
54. Field testing of thermoplastic encapsulants in high‐temperature installations10.1002/ese3.104 ↗
55. Multi angle laser light scattering evaluation of field exposed thermoplastic photovoltaic encapsulant materials10.1002/ese3.106 ↗
56. Infrared characteristic bands of highly dispersed silica10.1007/BF01500878 ↗
57. Surficial siloxane-to-silanol interconversion during room-temperature hydration/dehydration of amorphous silica films observed by ATR-IR and TIR-Raman spectroscopy10.1021/acs.langmuir.5b04506 ↗
58. Influence of thermal treatment on the water release and the glassy structure of perlite10.1007/s10853-006-0325-z ↗
59. Specular reflectance (SR) and attenuated total reflectance (ATR) infrared (IR) spectroscopy of transparent flat glass surfaces: a case study for soda lime float glass10.1016/j.jnoncrysol.2015.08.015 ↗