Performance promotion of aluminum oxide capping layer through interface engineering for tunnel oxide passivating contacts
Source abstract
Abstract
High-efficiency silicon solar cells depend on passivating contact structure to decrease recombination losses at the crystalline silicon (c-Si) surface and the interface of metal/Si contact. Tunnel oxide passivating contact (TOPCon) technology is one of these structures, in which heavily doped poly-Si is placed over a SiO x layer grown directly on the c-Si wafer. The passivation performance can be further improved by depositing a thin aluminum oxide (AlO x ) layer on one side of the symmetric cell structure, which is attributed to the reduced interfacial defects, facilitated formation of carrier collector layer, and excellent field-effect passivation. Atomic layer deposition (ALD) may be utilized to produce high-quality and pinhole-free AlO x capping layers due to its controllability, homogeneity, and conformality. However, insufficient substrate surface activity is a challenge faced in AlO x deposition because it can impair Al(CH 3) 3 nucleation, resulting in an island-like growth over the first few ALD cycles, ultimately deteriorating the passivation effect of AlO x . In this study, we optimized the deposition process of ALD AlO x through a series of single-factor experiments. Subsequently, alternative substrate treatment methods were tested to compare the performance. In particular, we proposed a two-step interface engineering process (chemical mechanical polishing + RCA SC-2 treatment) to enhance the comprehensive performance of the ALD AlO x layer, achieving a high iV OC of 726 mV and low J 0 of 5.4 fA/cm 2, compared with a reference poly-Si/c-Si passivating contact ( iV OC = 703 mV, J 0 = 19.4 fA/cm 2 ). The result was interpreted in terms of gradually improving substrate surface quality and wettability, together with the gradually decreasing thickness of the interfacial oxide layer. The circumvent of the island growth mode improved the growth quality of the subsequent film, effectively compressed the ALD cycle needed for stable growth, and enhanced the passivation property. Altogether, the present data may guide further efforts to obtain high-efficiency silicon-based solar cells by arising the interface engineering.
Source: expertdata · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Silicon and Solar Cell Technologies · Integrated Circuits and Semiconductor Failure Analysis · Semiconductor materials and interfaces
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (48)
Show source-provided references
1. 24.58% total area efficiency of screen-printed, large area industrial silicon solar cells with the tunnel oxide passivated contacts (i-Topcon) design10.1016/j.solmat.2019.110258 ↗
2. A strong-oxidizing mixed acid derived high-quality silicon oxide tunneling layer for polysilicon passivated contact silicon solar cell10.1016/j.solmat.2018.09.001 ↗
3. Polysilicon passivated junctions: the next technology for silicon solar cells10.1016/j.joule.2021.02.013 ↗
4. Passivating contacts for crystalline silicon solar cells10.1038/s41560-019-0463-6 ↗
5. A silicon carbide-based highly transparent passivating contact for crystalline silicon solar cells approaching efficiencies of 24%10.1038/s41560-021-00806-9 ↗
6. Passivating contacts for high-efficiency silicon-based solar cells: from single-junction to tandem architecture10.1016/j.nanoen.2021.106712 ↗
7. Laser contact openings for local poly-Si-metal contacts enabling 26.1%-efficient POLO-IBC solar cells10.1016/j.solmat.2018.06.020 ↗
8. JinKO Solar
9. Passivating contacts and tandem concepts: approaches for the highest silicon-based solar cell efficiencies10.1063/1.5139202 ↗
10. Ultralow surface recombination of c-Si substrates passivated by plasma-assisted atomic layer deposited Al2O310.1063/1.2240736 ↗
11. Excellent passivation of highly doped p-type Si surfaces by the negative-charge-dielectric Al2O310.1063/1.2784168 ↗
12. Very low surface recombination velocities on p- and n-type c-Si by ultrafast spatial atomic layer deposition of aluminum oxide10.1063/1.3505311 ↗
13. Silicon surface passivation by ultrathin Al2O3 films synthesized by thermal and plasma atomic layer deposition10.1002/pssr.200903334 ↗
14. Atomic layer-deposited tunnel oxide stabilizes silicon photoanodes for water oxidation10.1038/nmat3047 ↗
15. Wafer-scale fabrication of conformal atomic-layered TiO2 by atomic layer deposition using tetrakis (dimethylamino) titanium and H2O precursors10.1016/j.matdes.2017.02.016 ↗
16. Improved stability of atomic layer deposited amorphous TiO2 photoelectrode coatings by thermally induced oxygen defects10.1021/acs.chemmater.7b02938 ↗
17. Interface engineering for the passivation of c-Si with O3-based atomic layer deposited AlOx for solar cell application
18. Engineering aluminum oxide/polysilicon hole selective passivated contacts for high efficiency solar cells10.1016/j.solmat.2020.110758 ↗
19. Interface engineering of graphene–silicon Schottky junction solar cells with an Al2O3 interfacial layer grown by atomic layer deposition10.1039/C7RA13443F ↗
20. Analysis of passivation property using thin Al2O3 layer and simulation for realization of high-efficiency TOPCon cell10.1016/j.infrared.2020.103436 ↗
21. Molecular dynamics simulation of the Al2O3 film structure during atomic layer deposition10.1080/08927020802468372 ↗
22. Interface engineering of TiO2 photoelectrode coatings grown by atomic layer deposition on silicon10.1021/acsomega.1c04478 ↗
23. Controlling the atomic layer deposition of titanium dioxide on silicon: dependence on surface termination10.1021/jp4060022 ↗
24. Atom-by-atom and sheet-by-sheet chemical mechanical polishing of diamond assisted by OH radicals: a tight-binding quantum chemical molecular dynamics simulation study10.1021/acsami.1c09468 ↗
25. Improvement in chemical mechanical polishing of 4H-SiC wafer by activating persulfate through the synergistic effect of UV and TiO210.1016/j.jmatprotec.2021.117150 ↗
26. Study on the film forming mechanism, corrosion inhibition effect and synergistic action of two different inhibitors on copper surface chemical mechanical polishing for GLSI10.1016/j.apsusc.2019.144507 ↗
27. Research on Si (100) crystal substrate CMP based on FA/O alkaline slurry10.1016/j.apsusc.2017.05.128 ↗
28. Silicon surface passivation by atomic layer deposited Al2O310.1063/1.2963707 ↗
29. Passivation performance of Al2O3 films prepared by PEALD for n-TOPCon solar cells
30. Changes in hydrogen concentration and defect state density at the poly-Si/SiOx/c-Si interface due to firing10.1016/j.solmat.2021.111297 ↗
31. Hydrogen concentration at a-Si:H/c-Si heterointerfaces—the impact of deposition temperature on passivation performance10.1063/1.5100086 ↗
32. Optimum hydrogen injection in phosphorus-doped polysilicon passivating contacts10.1021/acsami.1c17342 ↗
33. A low-temperature-grown TiOz-based device for the flexible stacked RRAM application
34. Self-limiting low-temperature growth of crystalline AlN thin films by plasma-enhanced atomic layer deposition10.1016/j.tsf.2011.11.081 ↗
35. Bipolar resistive switching characteristics of low temperature grown ZnO thin films by plasma-enhanced atomic layer deposition
36. Stability of Al2O3 and Al2O3/a-SiNx:H stacks for surface passivation of crystalline silicon10.1063/1.3264572 ↗
37. Hydrogen induced passivation of Si interfaces by Al2O3 films and SiO2/Al2O3 stacks10.1063/1.3497014 ↗
38. Dopant diffusion through ultrathin AlOx and AlOx/SiOx tunnel layer in TOPCon structure and its impact on the passivation quality on c-Si solar cells10.1016/j.solmat.2021.110970 ↗
39. Atomic layer deposition for membrane interface engineering10.1039/C8NR08114J ↗
40. Inductively coupled plasma chemical vapour deposited AlOx/SiNy layer stacks for applications in high-efficiency industrial-type silicon solar cells10.1016/j.solmat.2013.01.036 ↗
41. Aluminium oxide thin film deposited by spray coating for p-type silicon surface passivation10.1016/j.solmat.2019.03.048 ↗
42. Growth of native oxide on a silicon surface10.1063/1.347181 ↗
43. Reaction of water with hydrofluoric acid treated silicon (111) and (100) surfaces10.1116/1.575845 ↗
44. Interface engineering for highly efficient graphene-on-silicon Schottky junction solar cells by introducing a hexagonal boron nitride interlayer10.1016/j.nanoen.2016.08.028 ↗
45. Understanding surface treatment and ALD AlOx thickness induced surface passivation quality of c-Si Cz wafers10.1109/JPHOTOV.2017.2717040 ↗
46. Interface and material characterization of thin ALD-Al2O3 layers on crystalline silicon10.1016/j.egypro.2012.07.069 ↗
47. Effect of an interfacial layer on electron tunneling through atomically thin Al2O3 tunnel barriers10.1021/acsami.7b12170 ↗
48. Probing the dielectric properties of ultrathin Al/Al2O3/Al trilayers fabricated using in situ sputtering and atomic layer deposition10.1021/acsami.7b16506 ↗