Oxide-nitride nanolayer stacks for enhanced passivation of p-type surfaces in silicon solar cells
Source abstract
Abstract
In the quest for ultra-high-efficiency silicon solar cells, optimising surface passivation has emerged as a critical pathway to minimise losses and enhance device performance. Recent breakthroughs in aluminium oxide (AlO x ) passivation show an interface to Si with low interface defect density and high negative charge density after activation annealing at 400–450 °C, enabling low surface recombination velocities. The formation of an interfacial SiO x layer has been recognised as a key factor. In this study, we present an in-depth investigation of a SiO x /AlO x /SiN x nanolayer stack interface with Si, where the SiO x is wet chemically grown. By varying the AlO x deposition from 5 to 40 ALD cycles, we observed a reduction in interface defect density, indicating the presence of negatively charged hydrogen in the AlO x layer. We reveal a distinctly different interface between Si and nanolayer stacks with or without AlO x . Activation annealing significantly reduced recombination losses for stacks with AlO x , attributed to increased charge density and decreased carrier capture velocity at the valence band-tail. We find lower electron capture rates in nanolayer stacks containing AlO x , suggesting effective passivation of donor states by negatively charged hydrogen. Additionally, the formation of new acceptor states was detected by an increase in hole capture velocity at the interface after annealing. Electron energy loss spectroscopy (EELS) identified an Al:SiO x N y layer of ∼2.5 nm thick with excess oxygen content and a mixture of tetrahedral and octahedral coordinated Al, likely contributing to the formation of acceptor defects and suggest an intrinsic link between the chemical and field-effect passivation. • An S eff below 6.33 cm/s achieved on p-type Silicon with 30 cycles of AlO x in a SiO x /AlO x /SiN x stack. • Reduced S n,VB is achieved by activation annealing and NAOS layer. • Distinctly different S n0 /S p0 ratio observed in layers with AlO x . • Formation of an Al:SiO x N y layer with excess oxygen content found after activation anneal.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Silicon and Solar Cell Technologies · Integrated Circuits and Semiconductor Failure Analysis · Advancements in Semiconductor Devices and Circuit Design
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (82)
Show source-provided references
1. Dielectric surface passivation for silicon solar cells: a review
2. State-of-the-Art passivation strategies of c-Si for photovoltaic applications: a review
3. Boron emitter passivation with Al2O 3 and Al 2 O3/SiNx stacks using ALD Al2O 310.1109/JPHOTOV.2012.2226145 ↗
4. Excellent silicon surface passivation with 5 Å thin ALD Al2O3 layers: influence of different thermal post-deposition treatments10.1002/pssr.201105188 ↗
5. Bias-voltage photoconductance and photoluminescence for the determination of silicon-dielectric interface properties in SiO2/Al2O3 stacks10.1063/5.0153204 ↗
6. Advances in the surface passivation of silicon solar cells10.1016/j.egypro.2012.02.004 ↗
7. Passivation of a metal contact with a tunneling layer10.1016/j.egypro.2012.05.010 ↗
8. Improved quantitative description of auger recombination in crystalline silicon10.1103/PhysRevB.86.165202 ↗
9. Very low surface recombination velocities on P-type silicon wafers passivated with a dielectric with fixed negative charge10.1016/j.solmat.2006.04.014 ↗
10. SiNxand AlOxNanolayers in hole selective passivating contacts for high efficiency silicon solar cells10.1109/JPHOTOV.2022.3226706 ↗
11. Material combination of tunnel-SiO2 with a (Sub-)Monolayer of ALD-AlOx on silicon offering a highly passivating hole selective contact
12. Numerical investigation of metal–semiconductor–insulator–semiconductor passivated hole contacts based on atomic layer deposited AlOx10.7567/JJAP.56.08MB08 ↗
13. Understanding surface treatment and ALD AlOx thickness induced surface passivation quality of C-Si Cz wafers10.1109/JPHOTOV.2017.2717040 ↗
14. Design rules for high-efficiency both-sides-contacted silicon solar cells with balanced charge carrier transport and recombination losses10.1038/s41560-021-00805-w ↗
15. The negative fixed charge of atomic layer deposited aluminium oxide - a two-dimensional SiO2/AlO xinterface effect10.1088/1361-6463/abf675 ↗
16. Electronic characteristics of ultra-thin passivation layers for silicon photovoltaics10.1002/admi.202201339 ↗
17. The origin of negative charging in amorphous Al 2 O 3 films: the role of native defects10.1088/1361-6528/ab0450 ↗
18. Surface passivation using dielectric films: how much charge is enough?
19. Influence of annealing and Al2O3 properties on the hydrogen-induced passivation of Si/SiO2 interface
20. Effective passivation of P+ and N+ emitters using SiO2/Al2O3/SiNx stacks: surface passivation mechanisms and application to industrial p-PERT bifacial Si solar cells10.1016/j.solmat.2018.07.007 ↗
21. STEM-EELS investigation of c-Si/a-AlOx interface for solar cell applications
22. Investigation of the initial deposition steps and the interfacial layer of atomic layer deposited (ALD) Al2O3 on Si10.1016/j.apsusc.2019.06.215 ↗
23. PECVD-AlOx/SiNx passivation stacks on silicon: effective charge dynamics and interface defect state spectroscopy10.1016/j.egypro.2014.08.068 ↗
24. Characterization of wet-chemically treated silicon interfaces by surface photovoltage measurements10.1007/s00216-002-1450-4 ↗
25. On the impact of interfacial SiO X-layer on the passivation properties of PECVD synthesized aluminum oxide
26. Studies on wet-chemical surface conditioning for Al2o3 passivation layers deposited with ALD
27. Impact of surface preparation prior to Al2O3 deposition for I-PERC cells
28. Reduction of the interface defect density on crystalline silicon solar cell substrates by wet-chemical preparation of Ultrathin SiOx passivation layers
29. Ultrathin SiO 2 layer formed by the nitric acid oxidation of Si (NAOS) method to improve the thermal-SiO 2/Si interface for crystalline Si solar cells10.1016/j.apsusc.2016.06.001 ↗
30. Effective use of UV-Ozone oxide in silicon solar cell applications10.1002/pssr.201800488 ↗
31. UV-ozone oxide for surface clean, passivation, and tunneling contact applications of silicon solar cells10.1109/JPHOTOV.2023.3244370 ↗
32. Nitric acid oxidation of Si to form Ultrathin silicon dioxide layers with a low leakage current density10.1063/1.1621720 ↗
33. Na-free glass for elimination of potential induced degradation
34. Progress of hydrogenation engineering in crystalline silicon solar cells: a review10.1088/1361-6463/ac9066 ↗
35. Hydrogen passivation of silicon surfaces10.1049/PBPO134E_ch3 ↗
36. A novel source of atomic hydrogen for passivation of defects in silicon
37. Properties of the C-Si/Al2O3 interface of Ultrathin atomic layer deposited Al2O3 layers capped by SiNxfor c-Si surface passivation10.1063/1.4903483 ↗
38. Thermal stability of spatial ald deposited Al 2 o 3 capped by pecvd sin
39. Industrial silicon solar cells applying the passivated emitter and rear cell (PERC) concept-A review10.1109/JPHOTOV.2016.2571627 ↗
40. On the passivation performance of SiNx, SiOxNy and their stack on c-Si wafers for solar cell applications: correlation with optical, chemical and interface properties
41. Excellent Si surface passivation by low temperature SiO2 using an Ultrathin Al2O3 capping film10.1002/pssr.201004378 ↗
42. Tuning back side passivation for enhancing the performance of PERC solar cells
43. On the role of AlOxThickness in AlOx/SiNy: H layer stacks regarding light- and elevated temperature-induced degradation and hydrogen diffusion in c-Si10.1109/JPHOTOV.2021.3075850 ↗
44. Atomic-layer-deposited Al2O3 as effective barrier against the diffusion of hydrogen from SiNx:H layers into crystalline silicon during rapid thermal annealing10.1002/pssr.202000367 ↗
45. Effect of rapid thermal annealing on the properties of PECVD SiNx thin films10.1016/j.matchemphys.2007.05.028 ↗
46. Enhanced Si passivation and PERC solar cell efficiency by atomic layer deposited aluminum oxide with two-step post annealing10.1186/s11671-019-2969-z ↗
47. Study on boron–hydrogen pairs in bare and passivated float-zone silicon wafers
48. Understanding the impact of the cooling ramp of the fast-firing process on light- and elevated-temperature-induced degradation
49. Surface recombination of crystalline silicon substrates passivated by atomic-layer-deposited AlO X
50. Electronic and chemical properties of the C-Si/Al2O3 interface10.1063/1.3587227 ↗
51. Hydrogen content of amorphous PECVD SiNx:H films by infrared spectroscopy and hydrogen forward scattering results10.1016/0022-3093(95)00155-7 ↗
52. Controlling light- and elevated-temperature-induced degradation with thin film barrier layers10.1109/JPHOTOV.2019.2945199 ↗
53. Behavior of hydrogen in high dielectric constant oxide gate insulators10.1063/1.1609245 ↗
54. Defects at the Si/SiO2 interface: their nature and behaviour in technological processes and stress10.1016/0168-9002(96)00205-7 ↗
55. Carrier-diffusion corrected J0-analysis of charge carrier lifetime measurements for increased consistency10.1016/j.solmat.2015.06.043 ↗
56. Activation of Al2O3 surface passivation of silicon: separating bulk and surface effects
57. High surface passivation quality and thermal stability of ALD Al 2O3 on wet chemical grown ultra-thin SiO2 on silicon10.1016/j.egypro.2011.06.197 ↗
58. Controlling surface carrier density via a PEDOT:PSS gate: an application to the study of silicon-dielectric interface recombination10.1002/solr.201800172 ↗
59. On the C-Si/SiO2 interface recombination parameters from photo-conductance decay measurements10.1063/1.4979722 ↗
60. On effective surface recombination parameters10.1063/1.4886595 ↗
61. Status and prospects of Al2O3-based surface passivation schemes for silicon solar cells
62. Enhancing dielectric-silicon interfaces through surface electric fields during firing10.1016/j.solmat.2024.112799 ↗
63. Charge fluctuations at the Si–SiO2 interface and its effect on surface recombination in solar cells
64. Reaction kinetics during the thermal activation of the silicon surface passivation with atomic layer deposited Al2O310.1063/1.4865901 ↗
65. Brauer · 2022 · 451
66. Excellent C-Si surface passivation by thermal atomic layer deposited aluminum oxide after industrial firing activation10.1088/0022-3727/46/38/385102 ↗
67. Study of charges present in silicon nitride thin films and their effect on silicon solar cell efficiencies
68. Influence of stoichiometry of direct plasma-enhanced chemical vapor deposited SiN x films and silicon substrate surface roughness on surface passivation10.1063/1.1861138 ↗
69. Effect of hydrogen passivation on charge storage in silicon Quantum dots embedded in silicon nitride film10.1063/1.1894595 ↗
70. Charging effect in amorphous silicon Quantum dots embedded in silicon nitride
71. Carrier recombination at silicon-silicon nitride interfaces fabricated by plasma-enhanced chemical vapor deposition10.1063/1.369725 ↗
72. Defect states in amorphous SiNx:H compounds using thermally stimulated exo-electron emission10.1016/j.tsf.2016.10.001 ↗
73. Numerical model of P-n junctions bordering on surfaces10.1016/S0927-0248(02)00061-2 ↗
74. Chemistry of Si-SiO2 interface trap annealing10.1063/1.340317 ↗
75. Analyses and excess oxygen investigations by scanning transmission electron microscopy and electron energy loss spectroscopy at AlOx/Si interfaces in passivated emitter and rear solar cells
76. Trapped charge densities in Al2O3-based silicon surface passivation layers10.1063/1.4953141 ↗
77. Electrical characterization of the SiO2-Si system10.1016/S0167-9317(98)00265-2 ↗
78. Native point defects and dangling bonds in α-Al2O 310.1063/1.4784114 ↗
79. Silicon surface passivation by aluminium oxide studied with electron energy loss spectroscopy10.1002/pssr.201308081 ↗
80. Coordination and interface analysis of atomic-layer-deposition Al2O3 on Si(001) using energy-loss near-edge structures10.1063/1.1629397 ↗
81. Electron energy loss spectroscopy characterization of TANOS (TaN/Al 2O3/Si3N4/SiO2/Si) stacks10.1017/S1431927613012440 ↗
82. A new method to determine Si/SiO2 interface recombination parameters using a gate-controlled point-junction diode under illumination10.1016/0169-4332(87)90084-5 ↗