ZnO:B back reflector with high haze and low absorption enhanced triple-junction thin film Si solar modules
Source abstract
Abstract
We present our development of a ZnO:B back reflector (BR) with high haze and low absorption for highly efficient triple-junction thin film Si solar modules over a large area (1.1×1.3 m2). We try to maximize light trapping by the evaluation of the use of transparent conducting oxide (TCO) and BR for high efficiency. It was verified that the configuration of SnO2:F front TCO and ZnO:B BR shows better optical properties than typical configurations for light trapping due to its high transparency at the front and high haze at the back. In addition, we noticed that the absorption of the BR has a strong influence on the solar modules. We obtained a superior ZnO:B BR with high haze and low absorption by controlling the doping gas ratio (B2H6/DEZ). As the doping gas ratio of ZnO:B BR decreases, the haze increases due to a rougher surface morphology, and the absorption decreases due to reduced free carrier absorption. The solar modules with a ZnO:B BR in a lower doping gas ratio show relatively higher Pmax for the same i-μc-Si layer thickness. This results from an increased Isc due to higher haze and lower absorption. In addition, the ZnO:B BR with a low doping gas ratio was found to be effective in reducing the i-μc-Si layer thickness because there are more chances for trapping the light at the i-μc-Si layer. We could reduce the i-μc-Si layer thickness by about 28% for the equivalent Pmax level by lowering the doping gas ratio. We successfully applied the ZnO:B BR with high haze and low absorption into a triple-junction thin film silicon solar cell and achieved a new record, improving on our previous world record.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Thin-Film Transistor Technologies · Silicon and Solar Cell Technologies · Photovoltaic System Optimization Techniques
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (26)
Show source-provided references
1. Thin film solar modules: the low cost, high throughput and versatile alternative to Si wafers10.1002/pip.704 ↗
2. Temperature dependence of protocrystalline silicon/microcrystalline silicon double-junction solar cells10.1143/JJAP.47.1496 ↗
3. Amorphous and nanocrystalline silicon-based multi-junction solar cells10.1016/j.tsf.2005.01.058 ↗
4. Basic efficiency limits, recent experimental results and novel light-trapping schemes in a-Si:H, c-Si:H and ‘micromorph tandem' solar cells10.1016/j.jnoncrysol.2004.03.074 ↗
5. Efficiency of the a-Si:H Solar cell and grain size of SnO2 transparent conductive film10.1109/EDL.1983.25686 ↗
6. M. Kambe, M. Fukawa, N. Taneda, Y. Yoshikawa, K. Sato, K. Ohki, S. Hiza, A. Yamada M. Konagai, Improvement of light-trapping effect on microcrystalline silicon solar cells by using high haze transparent conductive oxide films, in: Proceedings of the 3rd World Conference Photovoltaic Energy Conversion, Osaka, 2003, pp. 1812–1815.
7. Optical modeling of a-Si:H solar cells deposited on textured glass/SnO2 substrates10.1063/1.1487910 ↗
8. J. Meier, J. Spitznagel, S. Faÿ, C. Bucher, U. Graf, U. Kroll, S. Dubail, A. Shah, Enhanced light trapping for micro-morph tandem solar cells by LP-CVD, in: Proceedings of the 29th IEEE PVSC, New Orleans, 2002, pp. 1118–1121.10.1109/PVSC.2002.1190802 ↗
9. Solar glass with industrial porous SiO2 antireflection coating: measurements of photovoltaic module properties improvement and modeling of yearly energy yield gain10.1016/j.solmat.2003.12.004 ↗
10. Large area Si thin film solar module applying n-μc-SiOx:H intermediate layer with low refractive index10.1016/j.solmat.2013.01.042 ↗
11. LPCVD ZnO-based intermediate reflector for micromorph tandem solar cells10.1016/j.solmat.2011.03.018 ↗
12. Improved red-response in thin film a-Si:H solar cells with soft-imprinted plasmonic back reflectors10.1063/1.3256187 ↗
13. Study of back reflectors for amorphous silicon alloy solar cell application10.1063/1.347418 ↗
14. B. Yan, G. Yue, C.-S. Jiang, Y. Yan, J.M. Owens, J. Yang, S. Guha, Optical enhancement by textured back reflector in amorphous and nanocrystalline silicon based solar cells, Mater. Res. Soc. Symp. Proc. 1101 (2008) KK13-02.10.1557/PROC-1101-KK13-02 ↗
15. n-type microcrystalline silicon oxide layer and its application to high-performance back reflectors in thin-film silicon solar cells10.1016/j.cap.2012.11.017 ↗
16. Remarkable progress in thin-film silicon solar cells using high-efficiency triple-junction technology10.1016/j.solmat.2013.04.016 ↗
17. Solar cell efficiency tables (version 41)10.1002/pip.2352 ↗
18. Recent developments of silicon thin film solar cells on glass substrates10.1016/S0040-6090(98)01793-3 ↗
19. Texture etched ZnO: Al coated glass substrates for silicon based thin film solar cells10.1016/S0040-6090(99)00085-1 ↗
20. Challenges in microcrystalline silicon based solar cell technology10.1016/j.tsf.2005.12.161 ↗
21. Opto-electronic properties of rough LP-CVD ZnO:B for use as TCO in thin-film silicon solar cells10.1016/j.tsf.2007.03.130 ↗
22. Recent development on surface-textured ZnO: Al films prepared by sputtering for thin-film solar cell application10.1016/j.tsf.2007.10.029 ↗
23. Novel etching method on high rate ZnO:Al thin films reactively sputtered from dual tube metallic targets for silicon based solar cells10.1016/j.solmat.2010.11.033 ↗
24. Modeling free-carrier absorption in solar cells10.1002/(SICI)1099-159X(199707/08)5:4<229::AID-PIP164>3.0.CO;2-6 ↗
25. Polycrystalline ZnO:B grown by LPCVD as TCO for thin film silicon solar cells10.1016/j.tsf.2009.09.189 ↗
26. J. Steinhauser, Low pressure chemical vapor deposited zinc oxide for silicon thin film solar cells: optical and electrical properties (Ph.D. thesis), University of Neuchâtel, 2008.