A high effciency (11.06 %) CZTSSe solar cell achieved by combining Ag doping in absorber and BxCd1-xs/caztsse heterojunction annealing
Source abstract
Abstract
Many literatures have demonstrated that a smaller amount of Ag doping in Cu 2ZnSn(S, Se) 4 (CZTSSe) can elevate the open-circuit voltage (Voc) and fill factor (FF) of CZTSSe solar cells, but decrease short-circuit current density (Jsc) due to the increase in bandgap (E g ) of the CAZTSSe by Ag doping. The decreased Jsc limits the enhancement in PCE through Ag doping. In this paper, to compensate for the deficit in Jsc and further increase Voc and FF, a strategy is proposed to substitute CdS/CAZTSSe in CAZTSSe solar cells with annealed B-doped CdS/CAZTSSe. It is found that B doping can increase the electron density of CdS (n e ) and decrease the lattice mismatch between CdS and CAZTSSe. Annealing can decrease the hole density of CAZTSSe (n p) and passivate the surface of CAZTSSe by diffusing B towards the surface of CAZTSSe. The increased n e and reduced n p widen the depletion region, leading to an increase in photogenerated carrier density (J L ), resulting in an increase in Jsc. The surface passivation and decreased lattice mismatch can reduce interfacial recombination, resulting in decrease in the reverse saturation current density (J 0), so further increases in Voc and FF. By optimizing the Ag doping content, B doping content, as well as the annealing temperature and time of the B xCd 1-xS/CAZTSSe, the power conversion efficiency (PCE) increases from 8.96 % to 11.06 %. This study not only advances a deeper understanding of the mechanisms behind various parameters in CZTSSe solar cells but also proposes a method to boost the PCE of CZTSSe solar cells.
Source: expertdata · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Perovskite Materials and Applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (50)
Show source-provided references
1. High-efficiency solution-processed Cu2ZnSn(S, Se)4 thin-film solar cells prepared from binary and ternary nanoparticles10.1021/ja3057985 ↗
2. High efficiency CZTSSe solar cells enabled by dual Ag-passivation approach via aqueous solution process10.1016/j.jechem.2022.10.004 ↗
3. Ag, Ge dual-gradient substitution for low-energy loss and high-efficiency kesterite solar cells10.1039/D0TA06318E ↗
4. Kesterite solar cells: insights into current strategies and challenges
5. Passivating SnZn defect and optimizing energy level alignment via organic silicon salt incorporation toward efficient solution‐processed CZTSSe solar cells
6. Suppressing surface and bulk effect enables high efficiency solution-processed kesterite solar cells10.1016/j.cej.2023.147739 ↗
7. Solar cell efficiency tables (version 57)10.1002/pip.3371 ↗
8. A study on Cr incorporation to enhance performance of CZTSSe solar cells via optimizing selenization condition10.1016/j.solener.2023.111898 ↗
9. Enhancement of power conversion efficiency of Ag-substituted Cu2ZnSn(S, Se)4 solar cells via tuning Cu2+/(Cu++Cu2+) percentage in precursor solution10.1016/j.solmat.2023.112502 ↗
10. Effect of thermal pretreatment of metal precursor on the properties of Cu2ZnSnS4 films
11. Cd-free Cu(in,Ga)(Se, S)2 thin-film solar cell with record efficiency of 23.3510.1109/JPHOTOV.2019.2937218 ↗
12. Ag incorporation with controlled grain growth enables 12.5% efficient kesterite solar cell with open circuit voltage reached 64.2% shockley–queisser limit10.1002/adfm.202101927 ↗
13. Improved interfacial properties of electrodeposited Cu2ZnSn(S, Se)4 thin‐film solar cells by a facile post‐heat treatment process10.1002/pip.3332 ↗
14. Interfaces of high-efficiency kesterite Cu2ZnSnS(e)4thin film solar cells10.1088/1674-1056/27/1/018803 ↗
15. Insights into kesterite's back contact interface: a status review10.1016/j.solmat.2019.04.033 ↗
16. Ge bidirectional diffusion to simultaneously engineer back interface and bulk defects in the absorber for efficient CZTSSe solar cells
17. Defect engineering in earth‐abundant Cu2ZnSn(S, Se)4 photovoltaic materials via Ga3+‐doping for over 12% efficient solar cells10.1002/adfm.202010325 ↗
18. The role of Ag in aqueous solution processed (Ag, Cu)2ZnSn(S, Se)4kesterite solar cells: antisite defect elimination and importance of Na passivation10.1039/C8TA02950D ↗
19. Synergistic effect of Mn on bandgap fluctuations and surface electrical characteristics in Ag-based Cu2ZnSn(S, Se)4 solar cells10.1039/D0TA10103F ↗
20. Lithium-assisted synergistic engineering of charge transport both in GBs and GI for Ag-substituted Cu2ZnSn(S, Se)4 solar cells10.1016/j.jechem.2020.03.007 ↗
21. Synergistic incorporation of NaF and CsF PDT for high efficiency kesterite solar cells: unveiling of grain interior and grain boundary effects10.1039/D0TA08224D ↗
22. Defect passivation in Cu2ZnSnSe4 thin-film solar cells by novel sodium doping10.1016/j.solmat.2021.111138 ↗
23. The effect of Rb doping on CZTSSe solar cells10.1016/j.solener.2019.05.027 ↗
24. Enhancing carrier transport in flexible CZTSSe solar cells via doping Li strategy10.1016/j.jechem.2022.07.031 ↗
25. Regulating crystal growth via organic lithium salt additive for efficient Kesterite solar cells10.1016/j.nanoen.2021.106405 ↗
26. Improvement of performance of Cu2ZnSn(S, Se)4 solar cells by low‐temperature annealing of B‐doped CdS10.1002/solr.202300838 ↗
27. Revealing the reason for enhanced CZTSSe device performance after Ag heavily doped into absorber surface
28. Substitution of Ag for Cu in Cu2ZnSn(S, Se)4: toward wide band gap absorbers with low antisite defects for thin film solar cells10.3390/nano10010096 ↗
29. Enhancing open-circuit voltage of solution-processed Cu2ZnSn(S, Se)4 solar cells with Ag substitution10.1109/JPHOTOV.2017.2675993 ↗
30. Further boosting solar cell performance via bandgap-graded Ag doping in Cu2ZnSn(S, Se)4 solar cells compared to uniform Ag doping10.1021/acsami.2c18082 ↗
31. Efficient kesterite Ag-alloyed Cu2ZnSn(S,Se)4 thin film solar cells with a front Ag grading distribution enabled by ZnO insert layer10.1016/j.mssp.2024.108112 ↗
32. Optoelectronic and material properties of nanocrystal-based CZTSe absorbers with Ag-alloying10.1016/j.solmat.2015.10.039 ↗
33. Effect of boron doping on the rectification effect and photovoltaic performance of CdS/Si heterostructure based on Si nanoporous pillar array10.1088/0022-3727/48/26/265101 ↗
34. Suppressing interface recombination in CZTSSe solar cells by simple selenization with synchronous interface gradient doping10.1039/D2NR06115E ↗
35. Improving open-circuit voltage deficit by interface passivation via Li treatment in Cu2ZnSn(S, Se)4 solar cells10.1039/D3TA04907H ↗
36. A feasible and effective solution-processed PCBM electron extraction layer enabling the high VOC and efficient Cu2ZnSn(S, Se)4 devices10.1016/j.jechem.2022.02.009 ↗
37. Positive role of inhibiting CZTSSe decomposition on intrinsic defects and interface recombination of 12.03% efficient kesterite solar cells10.1002/solr.202200256 ↗
38. Doping behavior of Zn in CdS and its effect on the power conversion efficiency of the Cu2ZnSn(S, Se)4 solar cell10.1021/acs.jpcc.1c08579 ↗
39. Beyond 8% ultrathin kesterite Cu2ZnSnS4 solar cells by interface reaction route controlling and self-organized nanopattern at the back contact10.1038/am.2017.103 ↗
40. On the interface between kesterite absorber and Mo back contact and its impact on solution-processed thin-film solar cells10.1016/j.solmat.2016.09.029 ↗
41. Improvement of power conversion efficiency of Cu2ZnSn(S, Se)4 solar cells by Al doped CdS10.1016/j.physb.2022.414083 ↗
42. Mechanism of improvement of efficiency of Cu2ZnSn(S, Se)4 solar cells by optimization of deposition temperature of CdS buffer layer10.1016/j.solener.2023.111847 ↗
43. Insight into the role of air-annealing Cu2ZnSnS4 precursor films in improving efficiency of Cu2ZnSn(S, Se)4 solar cells10.1016/j.jallcom.2022.167308 ↗
44. Efficiency enhancement of Cu2ZnSn(S, Se)4 solar cells by addition a CuSe intermediate layer between Cu2ZnSn(S, Se)4 and Mo electrode10.1016/j.jallcom.2022.165056 ↗
45. Surface defect ordered Cu2ZnSn(S, Se)4 solar cells with efficiency over 12% via manipulating local substitution10.1016/j.jechem.2021.10.035 ↗
46. A facile process for partial Ag substitution in kesterite Cu2ZnSn(S, Se)4 solar cells enabling a device efficiency of over 1210.1021/acsami.0c19373 ↗
47. Elemental precursor solution processed (Cu1–x Agx)2ZnSn(S, Se)4 photovoltaic devices with over 10% efficiency10.1021/acsami.7b03944 ↗
48. In‐situ boron doping of chemical‐bath deposited CdS thin films10.1002/pssa.200824290 ↗
49. Boron implantation effects in CdS thin films grown by chemical synthesis10.1016/j.vacuum.2007.04.004 ↗
50. Effects of ultraviolet light on B-doped CdS thin films prepared by spray pyrolysis method using perfume atomizer10.1016/j.apsusc.2013.04.155 ↗