journal article·2023-12

Investigation into fill factor and open-circuit voltage degradations in silicon heterojunction solar cells under accelerated life testing at elevated temperatures

Gbenga D. Obikoya, Anishkumar Soman, Ujjwal K. Das, Steven S. Hegedus

Publisher page

Abstract

There are many reports on open-circuit voltage (V OC ) degradation but limited reports on fill factor (FF) degradation in silicon heterojunction (SHJ) solar cells which are either subjected to an accelerated testing condition or to a field condition. The factors contributing to FF loss and V OC loss due to aging required a thorough investigation to gain insight into potential loss mechanisms and the approaches to mitigate them. In this context, we subjected SHJ solar cells of the same structure to varying accelerated testing conditions (i.e. exposure temperature of 90 °C versus 120 °C, under 1-sun illumination) in experiment 1 to 3 of this work. The SHJ cells exposed to a temperature of 90 °C were nearly stable in performance even after 2000 h while those exposed to 120 °C degraded significantly in FF. Device measurements and analysis revealed that the FF degradation was due to an increase in series resistance ( R s ) and hole collection barrier. In experiment 4, the effect of device structure was investigated by subjecting cells with only front-side indium tin oxide (ITO) and those with both-sides ITO to the same accelerated testing conditions at a temperature of 90 °C under 1-sun illumination. The result obtained revealed that SHJ cells with both sides ITO were nearly stable in electrical performance while those with only front ITO degraded in performance, dominated by V OC loss. The V OC loss was perhaps due to loss of passivation at the rear-side of the cells.
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Silicon and Solar Cell Technologies · Semiconductor materials and interfaces · Thin-Film Transistor Technologies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (43)

Show source-provided references
1. High-efficiency crystalline silicon solar cells: status and perspectives10.1039/C5EE03380B ↗
2. Materials for photovoltaics: state of art and recent developments10.3390/ijms20040976 ↗
3. Silicon heterojunction solar cells with up to 26.81% efficiency achieved by electrically optimized nanocrystalline-silicon hole contact layers
4. Properties of high efficiency silicon heterojunction cells10.1016/j.egypro.2011.06.117 ↗
5. Kaitlyn VanSant, and Jeff Newmiller. "Compendium of photovoltaic degradation rates."10.1002/pip.2744 ↗
6. Annual degradation rates of recent c-Si PV modules under subtropical coastal climate conditions
7. Modeling boron–oxygen degradation and self-repairing silicon PV modules in the field10.1109/JPHOTOV.2019.2945161 ↗
8. Degradation analysis of a-Si,(HIT) hetro-junction intrinsic thin layer silicon and mC-Si solar photovoltaic technologies under outdoor conditions10.1016/j.energy.2014.05.078 ↗
9. Silicon heterojunction system field performance10.1109/JPHOTOV.2017.2765680 ↗
10. Multiprobe characterization of inversion charge for self-consistent parameterization of HIT cells10.1109/JPHOTOV.2014.2388072 ↗
11. Investigation of light-induced degradation in N-Type silicon heterojunction solar cells during illuminated annealing at elevated temperatures10.1016/j.solmat.2020.110752 ↗
12. Evidence for a light‐induced degradation mechanism at elevated temperatures in commercial N‐type silicon heterojunction solar cells10.1002/solr.202000214 ↗
13. Analysis of silicon wafer surface preparation for heterojunction solar cells using X-ray photoelectron spectroscopy and effective minority carrier lifetime10.1016/j.solmat.2018.03.006 ↗
14. Experimental and simulated analysis of front versus all‐back‐contact silicon heterojunction solar cells: effect of interface and doped a‐Si: H layer defects10.1002/pip.2400 ↗
15. Correlation between in situ diagnostics of the hydrogen plasma and the interface passivation quality of hydrogen plasma post-treated a-Si: H in silicon heterojunction solar cells10.1021/acsami.9b01686 ↗
16. Interface engineering by intermediate hydrogen plasma treatment using Dc-PECVD for silicon heterojunction solar cells10.1021/acsaelm.2c01336 ↗
17. NIH Image to ImageJ: 25 years of image analysis10.1038/nmeth.2089 ↗
18. Increasing the efficiency of silicon heterojunction solar cells and modules by light soaking10.1016/j.solmat.2017.06.023 ↗
19. Light-induced performance increase of silicon heterojunction solar cells10.1063/1.4964835 ↗
20. Light-induced performance of SHJ solar modules under 2000 h illumination10.1016/j.solmat.2021.111459 ↗
21. Reassessment of silicon heterojunction cell performance under operating conditions10.1016/j.solmat.2022.111951 ↗
22. Light-induced performance of SHJ solar modules under 2000 h illumination10.1016/j.solmat.2021.111459 ↗
23. Influence of light soaking on silicon heterojunction solar cells with various architectures10.1109/JPHOTOV.2021.3065537 ↗
24. A generalized theory explains the anomalous suns–VOC response of Si heterojunction solar cells10.1109/JPHOTOV.2016.2621346 ↗
25. Thin‐film solar cells: device measurements and analysis10.1002/pip.518 ↗
26. Optimization of interdigitated back contact silicon heterojunction solar cells: tailoring hetero‐interface band structures while maintaining surface passivation10.1002/pip.1032 ↗
27. Selective contacts and fill factor limitations in heterojunction solar cells10.1002/pip.3418 ↗
28. Silicon heterojunction solar cells toward higher fill factor10.1002/pip.3241 ↗
29. Doped layer optimization for silicon heterojunctions by injection-level-dependent open-circuit voltage measurements10.1109/JPHOTOV.2013.2294757 ↗
30. Device physics underlying silicon heterojunction and passivating‐contact solar cells: a topical review10.1002/pip.2959 ↗
31. Role of front contact work function on amorphous silicon/crystalline silicon heterojunction solar cell performance10.1109/LED.2003.811405 ↗
32. Interdigitated back contact silicon hetero-junction solar cells: the effect of doped layer defect levels and rear surface i-layer band gap on fill factor using two-dimensional simulations
33. Boron-doped zinc oxide layers grown by metal-organic CVD for silicon heterojunction solar cells applications10.1016/j.solmat.2010.11.013 ↗
34. ITO-free metallization for interdigitated back contact silicon heterojunction solar cells10.1016/j.egypro.2017.09.253 ↗
35. Application of indium tin oxide/aluminum-doped zinc oxide transparent conductive oxide stack films in silicon heterojunction solar cells10.1021/acsaem.1c02209 ↗
36. F. Jay, T. Gageot, G. Pinoit, B. Thiriot, J. Veirman, R. Cabal, S. De Vecchi et al. "Reduction in indium usage for silicon heterojunction solar cells in a short‐term industrial perspective." Sol. RRL. https://doi.org/10.1002/solr.202200598.10.1002/solr.202200598 ↗
37. "> 85% indium reduction for high-efficiency silicon heterojunction solar cells with aluminum-doped zinc oxide contacts."10.1016/j.solmat.2022.112120 ↗
38. Transparent-conductive-oxide-free front contacts for high-efficiency silicon heterojunction solar cells10.1016/j.joule.2021.04.004 ↗
39. Infrared light management in high-efficiency silicon heterojunction and rear-passivated solar cells10.1063/1.4772975 ↗
40. Electroluminescence analysis for spatial characterization of parasitic optical losses in silicon heterojunction solar cells10.1063/1.5007048 ↗
41. Hegedus “Role of back-side indium tin oxide on the degradation mechanism of silicon heterojunction solar cells”
42. Aluminum-induced degradation and failure mechanisms of a-Si: H solar cells10.1016/0927-0248(95)00097-6 ↗
43. Aluminum–silicon interdiffusion in silicon heterojunction solar cells with a-Si: H (i)/a-Si: H (n/p)/Al rear contacts10.1088/1361-6463/abd5e5 ↗