Effect of SiO2 nanoparticles concentration on the corrosion behaviour of solar salt-based nanofluids for Concentrating Solar Power plants
Source abstract
Abstract
Recently, corrosion of nanoparticles molten salt-based nanofluids studies have emerged as Concentrating Solar Power plants provide a low carbon alternative to produce electricity. Enhancing the heat capacity and thermal conductivity of molten salts by using inorganic nanoparticles has been targeted as a strategy to decrease the overall investment cost of CSP systems. However, there is scarce and insufficient information about their effect on the corrosion behaviour of nanofluids, whether the nanoparticle content increases it or have no significant effect. The scatter data found show no clear agreement and the measurements are done under different conditions (temperature, time, impurities, nanoparticle`s chemical nature and concentration, metal and alloy composition, testing method). In this context, the authors evaluated the effect of SiO 2 nanoparticles concentration in an industrial-grade Solar Salt in contact with four different alloys; AISI 1045, 304H, 316L and Inconel 600 by isothermal tests, 500 °C up to 2160 h. The effect of nanoparticles, 0.5% and 1% wt., was evaluated in comparison with Solar Salt industrial grade. The corrosion rate of the samples decreased in the following order AISI 1045 > 304H > 316L > Inconel 600 and nanoparticles increased in general and to a different extent the corrosion rate of the alloys. The one that experiences the highest nanoparticle effect is stainless steel 304H, followed by AISI 1045 and Inconel. For 316L, no significant differences can be seen. The applicability assessment carried out has shown that molten salt nitrate-based nanofluids can be used with Inconel 600, 304H and 316L in long-term service high-temperature applications such as CSP.
Source: expertdata · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Solar Thermal and Photovoltaic Systems · Photovoltaic System Optimization Techniques · Phase Change Materials Research
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (61)
Show source-provided references
1. Energy Agency, I; Renewable Energy Agency, I. Perspectives for the Energy Transition – Investment Needs for a Low-Carbon Energy System.
2. 2018
3. Effect of formation of “long range” secondary dendritic nanostructures in molten salt nanofluids on the values of specific heat capacity10.1016/j.ijheatmasstransfer.2015.05.072 ↗
4. Enhanced specific heat capacity of molten salt-based nanomaterials: effects of nanoparticle dispersion and solvent material10.1016/j.actamat.2014.05.005 ↗
5. Enhanced specific heat capacity of high-temperature molten salt-based nanofluids10.1016/j.ijheatmasstransfer.2012.10.062 ↗
6. Lasfargues · 2015 · 5194
7. Novel key parameter for eutectic nitrates based nanofluids selection for concentrating solar power (CSP) systems10.1016/j.apenergy.2018.10.114 ↗
8. The effect of nanoparticle morphology on the specific heat of nanosalts10.1016/j.ijheatmasstransfer.2015.11.064 ↗
9. Nanofluid and nanocomposite applications in solar energy conversion systems for performance enhancement: a review10.1093/ijlct/ctw007 ↗
10. Ahmed · 2014 · vol. 922
11. Comparison of corrosion performance of grade 316 and grade 347H stainless steels in molten nitrate salt
12. Molten nitrate salts at 600 and 680°C: thermophysical property changes and corrosion of high-temperature nickel alloys10.1016/j.solener.2014.01.028 ↗
13. Corrosion testing device for in-situ corrosion characterization in operational molten salts storage tanks: a516 Gr70 carbon steel performance under molten salts exposure10.1016/j.solmat.2016.06.005 ↗
14. Dynamic pilot plant facility for applications in CSP: evaluation of corrosion resistance of A516 in a nitrate molten salt mixture
15. Evaluation of corrosion resistance of A516 steel in a molten nitrate salt mixture using a pilot plant facility for application in CSP plants10.1016/j.solmat.2016.12.002 ↗
16. Corrosion of high temperature alloys in solar salt at 400 , 500 , and 680 ° C
17. Corrosion of stainless steels and carbon steel by molten mixtures of commercial nitrate salts10.1361/10599490417542 ↗
18. Corrosion behavior of stainless and low-chromium steels and IN625 in molten nitrate salts at 600 °c10.1016/j.solmat.2015.08.011 ↗
19. Walczak · 2018 · 22
20. Thermal influence in corrosion properties of Chilean solar nitrates10.1016/j.solener.2014.07.027 ↗
21. Bradshaw Rw · 2000
22. Corrosion of carbon steel in nanofluid containing ZrO2 nanoparticle at different temperature
23. Corrosion effects of CNT-nanofluids on different metals
24. A study on corrosion effects of a water based nanofluid for enhanced thermal energy applications10.1016/j.seta.2017.02.001 ↗
25. Experimental analysis of corrosion and erosion phenomena on metal surfaces by nanofluids10.1016/j.cherd.2015.10.004 ↗
26. Shin · 2012 · vol. 1
27. Unexpected effect of nanoparticles doping on the corrosivity of molten nitrate salt for thermal energy storage10.1016/j.solmat.2018.01.002 ↗
28. Investigation of rheological and corrosion properties of graphene-based eutectic salt10.1007/s10853-017-1497-4 ↗
29. Compatibility of container materials for concentrated solar power with a solar salt and alumina based nanofluid: a study under dynamic conditions10.1016/j.renene.2019.06.145 ↗
30. Corrosion aspects of molten nitrate salt-based nanofluids for thermal energy storage applications10.1016/j.solener.2019.07.050 ↗
31. High temperature corrosion behavior on molten nitrate salt-based nanofluids for CSP plants10.1016/j.renene.2018.07.018 ↗
32. Nanoparticles as a high-temperature anticorrosion additive to molten nitrate salts for concentrated solar power
33. High-temperature corrosion behaviour of metal alloys in commercial molten salts10.1016/j.solener.2020.03.010 ↗
34. Thermal storage properties of molten nitrate salt-based nanofluids with graphene nanoplatelets10.1186/s11671-016-1519-1 ↗
35. 2004
36. Impact of solar salt aging on corrosion of martensitic and austenitic steel for concentrating solar power plants10.1016/j.solmat.2019.110162 ↗
37. Screening tests of sodium nitrate and potassium nitrate decomposition10.1016/0038-092X(82)90082-2 ↗
38. Molten salt corrosion mechanisms of nitrate based thermal energy storage materials for concentrated solar power plants: a review10.1016/j.solmat.2019.02.012 ↗
39. High temperature corrosion in molten solar salt: the role of chloride impurities10.1002/maco.201609300 ↗
40. Hot corrosion behavior of Inconel 625 superalloy in eutectic molten nitrate salts10.1007/s11085-017-9830-5 ↗
41. Corrosion behavior of Ni-based structural materials for electrolytic reduction in lithium molten salt10.1016/j.jnucmat.2011.02.047 ↗
42. High-temperature and corrosion behavior of nitrate nitrite molten salt mixtures regarding their application in concentrating solar power plants10.1016/j.egypro.2015.03.071 ↗
43. Corrosion of stainless steels and low-Cr steel in molten Ca(NO3)2–NaNO3–KNO3 eutectic salt for direct energy storage in CSP plants10.1016/j.solmat.2015.05.004 ↗
44. Mainstreaming commercial CSP systems: a technology review10.1016/j.renene.2019.03.049 ↗
45. Cordaro · 2013 · 9
46. Molten nitrate salt development for thermal energy storage in parabolic trough solar power systems
47. Management and control of corrosion
48. Solid-state reaction between zinc oxide and ferric oxide10.1039/tf9696500219 ↗
49. Dynamic corrosion behavior of 316L stainless steel in quaternary nitrate-nitrite salts under different flow rates
50. Corrosion of structural alloys in molten salts for solar thermal energy storage
51. High-temperature corrosion behaviour of metal alloys in commercial molten salts10.1016/j.solener.2020.03.010 ↗
52. Monitoring – internal corrosion10.1016/B978-0-12-397022-0.00008-X ↗
53. Process diagnostics and coating characteristics10.1016/B978-0-323-29644-1.00005-0 ↗
54. The effect of humidity, impurities and initial state on the corrosion of carbon and stainless steels in molten HitecXL salt for CSP application10.1016/j.solmat.2017.08.026 ↗
55. Ahn · 2004
56. Science · 2005
57. Novel key parameter for eutectic nitrates based nanofluids selection for concentrating solar power (CSP) system10.1016/j.apenergy.2018.10.114 ↗
58. Microstructural improvement of solar salt based MgO composites through surface tension/wettability modification with SiO2 nanoparticles
59. Molten salts in the light of corrosion mitigation strategies and embedded with nanoparticles to enhance the thermophysical properties for CSP plants
60. Sastri · 2007
61. 2002