Influence of the annealing atmosphere and precursor's thickness on the properties of CZTSSe based solar cells
Source abstract
Abstract
Abstract Cu-Zn-Sn-S sulfide precursors with various thicknesses, ranging from 0.8 µm to 1.7 µm were annealed under two types of annealing atmosphere: a pure (Se) atmosphere and a mix of (S+Se) one. Pure (Se) annealing led to the Cu2ZnSn(S,Se)4 (CZTSSe) phase with a Se gradient from front to back surface. Annealing under mixture of (S+Se) improved the homogeneity of the CZTSSe solid solution across the whole layer thickness and prevented the S loss from sulfide precursor. This increased the band gap of the absorber, but enhanced the occurrence of S-rich secondary phases, mainly ZnS thin layers formed at the Mo/CZTSSe interface. The decrease of the absorber thickness can limit the occurrence of secondary phases and affects electrical parameters of the solar cells. While the best cell efficiency of 7.1% was obtained for a 1.7 µm-thick layer annealed under pure Se atmosphere, the best and homogeneous average efficiencies on 2.5 × 2.5 cm2 samples were obtained for a 0.8 µm-thick layer annealed under (S+Se) atmosphere. These results showed clearly the trade-off to find between the annealing atmosphere and the thickness of the absorber.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Copper-based nanomaterials and applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (64)
Show source-provided references
1. Compositional investigation of potassium doped Cu(In,Ga)Se2 solar cells with efficiencies up to 20.8%10.1002/pssr.201409040 ↗
2. Brief review of emerging photovoltaic absorbers10.1016/j.cogsc.2017.01.002 ↗
3. Single step preparation of quaternary Cu2ZnSnSe4 thin films by RF magnetron sputtering from binary chalcogenide targets10.1016/j.jpcs.2007.05.022 ↗
4. Composition dependence of structure and optical properties of Cu2ZnSn(S,Se)4 solid solutions: an experimental study10.1016/j.jallcom.2011.08.099 ↗
5. High efficiency Cu2ZnSn(S,Se)4 solar cells by applying a double In2S3/CdS emitter10.1002/adma.201402373 ↗
6. Device characteristics of CZTSSe thin-film solar cells with 12.6% efficiency10.1002/aenm.201301465 ↗
7. A band-gap-graded CZTSSe solar cell with 12.3% efficiency10.1039/C6TA01558A ↗
8. Limiting effects of conduction band offset and defect states on high efficiency CZTSSe solar cell10.1016/j.nanoen.2017.12.031 ↗
9. Properties of Cu(In,Ga)Se2 solar cells with new record efficiencies up to 21.7%10.1002/pssr.201409520 ↗
10. Development of CZTS-based thin film solar cells10.1016/j.tsf.2008.11.002 ↗
11. Fabrication of Cu2ZnSn(S,Se)4 photovoltaic devices with 10% efficiency by optimizing the annealing temperature of precursor films10.1039/C7RA13069D ↗
12. Study on phase formation mechanism of non- and near-stoichiometric Cu2ZnSn(S,Se)4 film prepared by selenization of Cu–Sn–Zn–S precursors10.1021/cm403423e ↗
13. On the growth process of Cu2ZnSn(S,Se)4 absorber layer formed by selenizing Cu–ZnS–SnS precursors and its photovoltaic performance10.1016/j.solmat.2014.09.023 ↗
14. Cu2ZnSn(S,Se)4 kesterite solar cell with 5.1% efficiency using spray pyrolysis of aqueous precursor solution followed by selenization10.1016/j.solmat.2014.01.029 ↗
15. 9.0% efficient Cu2ZnSn(S,Se)4 solar cells from selenized nanoparticle inks10.1002/pip.2472 ↗
16. Sputtering processed highly efficient Cu2ZnSn(S,Se)4 solar cells by a low-cost, simple, environmentally friendly, and up-scalable strategy10.1039/C5GC02417J ↗
17. On the impact of Na dynamics at the Cu2ZnSn(S,Se)4/CdS interface during post low temperature treatment of absorbers10.1021/acsami.5b12243 ↗
18. Influence of precursor uniformity on the performance of Cu2ZnSnSxSe4−x thin film solar cells prepared by the sputtering method10.1016/j.tsf.2017.07.054 ↗
19. Preparation and characterization of Cu2ZnSn(S,Se)4 thin films by sulfurization of Cu-Zn-Sn-Se precursor layers10.3938/jkps.70.281 ↗
20. H. Hiroi, N. Sakai, T. Kato, H. Sugimoto, High Voltage Cu2ZnSnS4 Submodules by Hybrid Buffer Layer, in: Proceedings of the IEEE 39th Photovoltaic Specialists Conference (PVSC), 2013.10.1109/PVSC.2013.6744281 ↗
21. S. Temgoua, R. Bodeux, S. Delbos, N. Naghavi, Crystallization behavior of Cu2ZnSn(Sx,Se1−x)4 absorbers processed from sputtered Cu2ZnSnS4 precursors under different selenization conditions, in: Proceedings of IEEE 40th Photovoltaic Specialists Conference (PVSC), 2014.
22. 11.2% efficient solution processed kesterite solar cell with a low voltage deficit, advanced energy
23. Fine-tuning the Sn content in CZTSSe thin films to achieve 10.8% solar cell effi ciency from spray-deposited water–ethanol-based colloidal inks10.1002/aenm.201501404 ↗
24. Li · Sol. Energy Mater. Sol. Cells · 2016 · 149 · 24210.1016/j.solmat.2016.02.002 ↗
25. Tuning the Se content in Cu2ZnSn(S,Se)4 absorber to achieve 9.7% solar cell efficiency from a thiol/amine-based solution process10.1021/acsaem.7b00146 ↗
26. Effects of SnSe2 secondary phases on the efficiency of Cu2ZnSn(Sx,Se1−x)4 based solar cells10.1016/j.tsf.2014.10.058 ↗
27. A better understanding of the reaction pathways in the formation of Cu2ZnSn(Sx,Se1−x)4 thin films10.1016/j.solmat.2017.07.031 ↗
28. Band gap tunable and improved microstructure characteristics of Cu2ZnSn(S1-x,Sex)4 thin films by annealing under atmosphere containing S and Se10.1016/j.cap.2013.06.022 ↗
29. Single-step sulfo-selenization method for achieving low open circuit voltage deficit with band gap front-graded Cu2ZnSn(S,Se)4 thin films10.1016/j.solmat.2016.11.034 ↗
30. Cu2ZnSn(SxSe1−x)4 thin film solar cell with high sulfur content (x approximately 0.4) and low Voc deficit prepared using a postsulfurization process10.1016/j.solmat.2017.09.036 ↗
31. Ultrathin Cu(In,Ga)Se2 based solar cells10.1016/j.tsf.2016.11.029 ↗
32. High efficiency CuInxGa1-xSe2 solar cells made from (Inx,Ga1-x)2Se3 precursor films10.1063/1.112670 ↗
33. Cu(In,Ga)(Se,S)2 solar cell research in Solar Frontier: progress and current status10.7567/JJAP.56.04CA02 ↗
34. T. Kato, N. Sakai, H. Sugimoto, Efficiency improvement of Cu2ZnSn(S,Se)4 submodule with graded bandgap and reduced backside ZnS segregation, in: Proceedings of IEEE 40th Photovoltaic Specialists Conference (PVSC), 2014.10.1109/PVSC.2014.6925047 ↗
35. Band-gap-graded Cu2ZnSn(S1-x,Sex)4 solar cells fabricated by an ethanol-based particulate precursor ink route10.1038/srep03069 ↗
36. Practical limitations to selenium annealing of compound co-sputtered Cu2ZnSnS4 as a route to achieving sulfur-selenium graded solar cell absorbers10.1016/j.tsf.2016.12.044 ↗
37. Secondary ion mass spectrometry as a tool to study selenium gradient in Cu2ZnSn(S,Se)410.1002/pssc.201600187 ↗
38. S. Temgoua, R. Bodeux, L. Michely, S. Borensztajn, N. Naghavi, A better understanding of reaction pathways of the formation of CZTSSe absorbers using co-sputtered Cu-Zn-Sn-S precursors, in: Proceedings of IEEE 41st Photovoltaic Specialists Conference (PVSC), 2015.10.1109/PVSC.2015.7356360 ↗
39. Determination of the electronic properties of Cu2ZnSnSe4-based solar cells by impedance spectroscopy and current–voltage characteristics analysis10.1007/s00339-017-1437-9 ↗
40. Physicochemical characterizations of Cu2Sn0.7Si0.3S3 made from sputtered precursors for thin film solar cell applications10.1016/j.jallcom.2018.01.179 ↗
41. GaSe formation at the Cu(In,Ga)Se2/Mo interface–a novel approach for flexible solar cells by easy mechanical lift-off10.1002/admi.201400044 ↗
42. Cu2ZnSnSe4 absorbers processed from solution deposited metal salt precursors under different selenization conditions10.1002/pssa.201228003 ↗
43. On the Sn loss from thin films of the material system Cu–Zn–Sn–S in high vacuum10.1063/1.3273495 ↗
44. The consequences of kesterite Equilibria for efficient solar cells10.1021/ja111713g ↗
45. Thermodynamic aspects of the synthesis of thin-film materials for solar cells10.1002/cphc.201200067 ↗
46. Growth of Cu2ZnSnSe4 by cosputtering and reactive annealing atmosphere10.1016/j.solmat.2014.08.001 ↗
47. Kubaschewski · 1993
48. Growth and Raman scattering characterization of Cu2ZnSnS4 thin films10.1016/j.tsf.2008.11.031 ↗
49. Phase controlled solvothermal synthesis of Cu2ZnSnS4, Cu2ZnSn(S,Se)4 and Cu2ZnSnSe4 Nanocrystals: the effect of Se and S sources on phase purity10.1016/j.matchemphys.2015.10.002 ↗
50. Photoluminescence and Raman study of Cu2ZnSn(SexS1−x)4 monograins for photovoltaic applications10.1016/j.tsf.2010.12.099 ↗
51. CZTS monograin powders and thin films10.4028/www.scientific.net/AMR.222.8 ↗
52. First principles calculation of the electronic properties and lattice dynamics of Cu2ZnSn(S1−xSex)410.1063/1.4728232 ↗
53. Cu2ZnSn(S1−xSex)4 based solar cell produced by selenization of vacuum deposited precursors10.1016/j.solmat.2012.02.016 ↗
54. Single-step sulfo-selenization method to synthesize Cu2ZnSn(SySe1−y)4 absorbers from metallic stack precursors10.1002/cphc.201300157 ↗
55. Multiwavelength excitation Raman scattering study of polycrystalline kesterite Cu2ZnSnS4 thin films10.1063/1.4861593 ↗
56. Raman scattering quantitative analysis of the anion chemical composition in kesterite Cu2ZnSn(SxSe1-x)4 solid solutions10.1016/j.jallcom.2014.12.175 ↗
57. In-depth resolved Raman scattering analysis for the identification of secondary phases: characterization of Cu2ZnSnS4 layers for solar cell applications10.1063/1.3587614 ↗
58. On the kinetics of MoSe2 interfacial layer formation in chalcogen-based thin film solar cells with a molybdenum back contact10.1063/1.4794422 ↗
59. Impact of minor phases on the performances of CZTSSe thin-film solar cells10.1021/acs.chemmater.6b00069 ↗
60. Fill factor losses in Cu2ZnSn(SxSe1−x)4 solar cells: insights from physical and electrical characterization of devices and exfoliated films10.1002/aenm.201501609 ↗
61. Influence of the Cu(In,Ga)Se2 thickness and Ga grading on solar cell performance10.1002/pip.462 ↗
62. Towards ultrathin copper indium gallium diselenide solar cells: proof of concept study by chemical etching and gold back contact engineering10.1002/pip.2162 ↗
63. Flexible Cu(In,Ga)Se2 solar cells with reduced absorber thickness10.1002/pip.2420 ↗
64. Optical and electrical characterization of Cu(In,Ga)Se2 thin film solar cells with varied absorber layer thickness10.1016/j.tsf.2015.01.004 ↗