A coupled optical-thermal-fluid-structural analysis of parabolic trough solar collector by deformation coupling instant ray-tracing multiple iteration method
Source abstract
Abstract
Parabolic trough solar collectors (PTC) have been widely applied in concentrating solar power generation and solar heating. During typical operation processes, due to the interaction between the bending deformation and the non-uniform solar flux concentration of the receiver tube, the PTC presents a complex multi-physical coupling phenomenon, which seriously influences the concentrating characteristic and solar-to-thermal conversion efficiency. In order to improve the accuracy of multiphysics simulation, a fully coupled optical-thermal-fluid-structural simulation model is developed by considering the novel structure-deformation coupling instant ray-tracing method. Based on the case study refers to the Euro Trough 150 type collector and the Schott PTR70 type solar receiver, the optical-thermal-fluid-structural coupling characteristics of PTC has been comprehensively investigated. The results indicate that the calculation error of the receiver tube deformation decreases by 16 %, indicating significant improvement in multiphysics coupling. Under the dynamic tracking process, increasing the tracking angle of the adopted PTC module to 90° from 0°results in a corresponding peak solar flux improvement to 73.84 kW/m 2 from 72.41 kW/m 2. Due to the thermal stress and gravity, the maximum concavity decreases to 6.64 mm from 9.58 mm and the maximum convexity increases to 1.89 mm from 1.13 mm. This new method provides a feasible reference for optimization and regulation of PTCs.
Source: expertdata · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Solar Thermal and Photovoltaic Systems · Photovoltaic System Optimization Techniques · Solar Radiation and Photovoltaics
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (54)
Show source-provided references
1. Current status and future prospects of renewable and sustainable energy in north America: progress and challenges10.1016/j.enconman.2022.115945 ↗
2. Effect of wind and solar energy production, and economic development on the environmental quality: is this the solution to climate change?10.1016/j.gr.2023.01.012 ↗
3. Multi-energy complementary power systems based on solar energy: a review10.1016/j.rser.2024.114464 ↗
4. Modelling and analysis of a novel hydrogen production approach by full spectrum solar energy10.1016/j.enconman.2022.115694 ↗
5. Dynamic optimization with flexible heat integration of a solar parabolic trough collector plant with thermal energy storage used for industrial process heat10.1016/j.enconman.2022.115921 ↗
6. A thorough review of the existing concentrated solar power technologies and various performance enhancing techniques10.1007/s10973-022-11634-8 ↗
7. Assessment of photovoltaic performance and carbon emission reduction potential of bifacial pv systems for regional grids in China10.1016/j.solener.2024.112367 ↗
8. Application of nanofluid in solar energy harvesting devices: a comprehensive review10.1016/j.enconman.2022.115790 ↗
9. Global advancement of solar thermal energy technologies for industrial process heat and its future prospects: a review10.1016/j.enconman.2019.05.081 ↗
10. Thermo-economic analysis of steam accumulation and solid thermal energy storage in direct steam generation concentrated solar power plants10.1016/j.enconman.2022.116222 ↗
11. Performance analysis of a parabolic trough solar collector using al2o3/synthetic oil nanofluid10.1016/j.applthermaleng.2016.06.170 ↗
12. Performance analysis of an improved 30 mw parabolic trough solar thermal power plant
13. Parabolic trough solar thermal power plant noor i in Morocco10.1016/j.energy.2019.04.160 ↗
14. Impact of parabolic trough collector model on the csp plants' performance
15. Progress in research and technological advancements of commercial concentrated solar thermal power plants10.1016/j.solener.2022.10.041 ↗
16. Progress in concentrated solar power technology with parabolic trough collector system: a comprehensive review10.1016/j.rser.2017.05.174 ↗
17. Techno-economic comparative analysis of solar thermal collectors and high-temperature heat pumps for industrial steam generation10.1016/j.enconman.2022.116623 ↗
18. Comprehensive analysis and optimization of combined cooling heating and power system integrated with solar thermal energy and thermal energy storage10.1016/j.enconman.2022.116464 ↗
19. Application of a mid-/low-temperature solar thermochemical technology in the distributed energy system with cooling, heating and power production10.1016/j.apenergy.2019.113491 ↗
20. A novel parabolic trough concentrating solar heating for cut tobacco drying system10.1155/2014/209028 ↗
21. Prototype of phosphate sludge rotary dryer coupled to a parabolic trough collector solar loop: integration and experimental analysis10.1016/j.solener.2021.01.040 ↗
22. Performance analysis of a mid- and low-temperature solar receiver/reactor for hydrogen production with methanol steam reforming10.1002/er.1738 ↗
23. Investigation on the mid-temperature solar thermochemical power generation system with methanol decomposition10.1016/j.apenergy.2018.02.101 ↗
24. Comparative study on the effect of the absorber geometry, rim angle and operational modes on the distribution of the heat flux over the absorber's surface10.1016/j.solener.2021.08.010 ↗
25. Thermal stress analysis of absorber tube for a parabolic collector under quasi-steady state condition10.1016/j.egypro.2015.03.002 ↗
26. A detailed nonuniform thermal model of a parabolic trough solar receiver with two halves and two inactive ends10.1016/j.renene.2014.07.060 ↗
27. Deformation of receiver in solar parabolic trough collector due to non uniform temperature and solar flux distribution and use of bimetallic absorber tube with multiple supports10.1016/j.energy.2018.09.145 ↗
28. Temperature and thermal stress analysis of parabolic trough receivers10.1016/j.renene.2019.01.021 ↗
29. Analysis of heat losses of absorber tubes of parabolic through collector of shiraz (Iran) solar power plant10.7763/JOCET.2013.V1.8 ↗
30. Coupling effect between heat flux distribution and buoyancy of supercritical co2 heat transfer with nonuniform heat flux in parabolic-trough collector10.1016/j.ijheatmasstransfer.2022.123197 ↗
31. Heat transfer and thermal stress of a parabolic trough solar collector with secondary reflector using microencapsulated phase change material slurries
32. Numerical model of solar external receiver tubes: influence of mechanical boundary conditions and temperature variation in thermoelastic stresses10.1016/j.solener.2018.09.068 ↗
33. Effects of geometric configurations on the thermal-mechanical properties of parabolic trough receivers based on coupled optical-thermal-stress model10.1016/j.renene.2022.09.055 ↗
34. Secondary reflector and receiver positions for uniform heat flux distribution in parabolic trough solar thermal collector
35. Optical, thermal, and structural performance analyses of a parabolic-trough solar collector10.1063/5.0012611 ↗
36. Use of sinusoidal surface profile in the absorber tube of a parabolic trough solar collector to enhance its thermal performance10.1007/s10973-020-09929-9 ↗
37. Cfd simulation of thermal performance of hybrid oil-cu-al2o3 nanofluid flowing through the porous receiver tube inside a finned parabolic trough solar collector
38. Safety and efficiency assessment of absorber with an initial offset in a parabolic trough collector10.1016/j.renene.2022.01.114 ↗
39. Thermal load and bending analysis of heat collection element of direct-steam-generation parabolic-trough solar power plant10.1016/j.applthermaleng.2017.08.129 ↗
40. A trans-dimensional multi-physics coupled analysis method for direct-steam-generation parabolic-trough loop10.1016/j.applthermaleng.2021.117011 ↗
41. Structural analysis of absorber tube used in parabolic trough solar collector and effect of materials on its bending: a computational study10.1016/j.solener.2018.02.028 ↗
42. A coupled optical-thermal-fluid-mechanical analysis of parabolic trough solar receivers using supercritical co2 as heat transfer fluid10.1016/j.applthermaleng.2020.116154 ↗
43. Coupled thermo-structural analysis of absorber tube for direct steam generation in parabolic trough solar collector10.1016/j.solener.2023.112148 ↗
44. Effects of geometric and optical irregularities on the flux distribution on an absorber tube of a parabolic trough collector10.1016/j.applthermaleng.2023.120937 ↗
45. Effect of different errors on deformation and thermal stress of absorber tube in solar parabolic trough collector10.1016/j.ijmecsci.2020.105969 ↗
46. Thermal stress in bimetallic receiver of solar parabolic trough concentrator induced due to non uniform temperature and solar flux distribution10.1016/j.solener.2018.09.081 ↗
47. Investigations of thermo-structural instability on the performance of solar parabolic trough collectors10.1016/j.renene.2022.11.068 ↗
48. Optical and thermal performance of large-size parabolic-trough solar collectors from outdoor experiments: a test method and a case study10.1016/j.energy.2014.04.016 ↗
49. Euro trough collector qualification complete-performance test results from psa
50. Numerical investigation on the thermal performance of parabolic trough solar collector with synthetic oil/cu nanofluids10.1016/j.applthermaleng.2023.120376 ↗
51. Cfd simulations to characterize near wall heat transfer in high Prandtl number packed bed conditions10.1016/j.nucengdes.2022.111868 ↗
52. Real-time thermal states monitoring of absorber tube for parabolic trough solar collector with non-uniform solar flux10.1002/er.3856 ↗
53. Experimental investigation of the bending of absorber tube of solar parabolic trough concentrator and comparison with analytical results10.1016/j.solener.2015.11.046 ↗
54. Dudley · 1994