journal article·2023-04

Optimization of activated phosphorus concentration in recrystallized polysilicon layers for the n-TOPCon solar cell application

Wenhao Chen, Xinxin Liu, Weiqing Liu, Yuanyuan Yu, Wenjie Wang, Yimao Wan

Publisher page

Abstract

The pivotal structure of n-TOPCon (tunnel oxide passivating contact) solar cells is the passivating contact structure composed of a heavily doped polysilicon (poly-Si) layer and an ultrathin silicon oxide (SiO x ), which can provide excellent selectively carrier transport. The activated phosphorus concentration in the passivating contact structure plays a crucial role in the passivation quality and contact resistivity performance. By adjusting PH 3 flow rate, SiO x thickness and activation temperature, three different activated phosphorus concentrations in poly-Si were achieved in this work, the phosphorus concentration from SiO x to silicon bulk decreased at the same rate. It can be found that the passivation quality decreases with increasing concentration and the contact resistivity decreases significantly. With the aid of ellipsometry, we successfully extracted the refractive index n and extinction coefficient k of three poly-Si with different activated phosphorus concentrations. The extracted n and k values can well feedback the influence of concentration change on short-circuit current density in the simulation. Due to the high concentration led to the decrease of the open circuit voltage and short circuit current of the final TOPCon solar cell, but the obvious filling factor benefit can be obtained, only moderate doping concentration can obtain the best efficiency performance. Finally, the activated phosphorus concentration of about 3 × 10 20 cm −1 can obtain the best efficiency, >24.8% on average.
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Silicon and Solar Cell Technologies · Thin-Film Transistor Technologies · Semiconductor materials and interfaces

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (33)

Show source-provided references
1. Polysilicon passivated junctions: the next technology for silicon solar cells?10.1016/j.joule.2021.02.013 ↗
2. TOPCon–Technology options for cost efficient industrial manufacturing10.1016/j.solmat.2021.111100 ↗
3. Tunnel oxide passivated contacts as an alternative to partial rear contacts10.1016/j.solmat.2014.06.015 ↗
4. A passivated rear contact for high-efficiency n-type Si solar cells enabling high voc's and FF>82 %
5. Impact of phosphorus diffusion on n-type poly-Si based passivated contact silicon solar cells10.1016/j.solmat.2019.110120 ↗
6. Passivation quality control in poly-Si/SiO/c-Si passivated contact solar cells with 734 mV implied open circuit voltage10.1016/j.solmat.2018.09.013 ↗
7. Design rules for high-efficiency both-sides-contacted silicon solar cells with balanced charge carrier transport and recombination losses10.1038/s41560-021-00805-w ↗
8. Laser contact openings for local poly-Si-metal contacts enabling 26.1%-efficient POLO-IBC solar cells10.1016/j.solmat.2018.06.020 ↗
9. Role of polysilicon in poly-Si/SiOx passivating contacts for high-efficiency silicon solar cells10.1039/C9RA03560E ↗
10. Recombination analysis of phosphorus-doped nanostructured silicon oxide passivating electron contacts for silicon solar cells10.1109/JPHOTOV.2017.2779871 ↗
11. Phosphorus-diffused polysilicon contacts for solar cells10.1016/j.solmat.2015.06.001 ↗
12. 24.58% total area efficiency of screen-printed, large area industrial silicon solar cells with the tunnel oxide passivated contacts (i-TOPCon) design10.1016/j.solmat.2019.110258 ↗
13. Optical and electrical characterization of poly-Si/SiOx contacts and their implications on solar cell design10.1016/j.egypro.2017.09.336 ↗
14. High efficiency screen-printed n-type silicon solar cell using co-diffusion of APCVD boron emitter and POCl3 back surface field10.1016/j.cap.2017.11.004 ↗
15. Fully screen-printed bifacial large area 22.6% N-type Si solar cell with lightly doped ion-implanted boron emitter and tunnel oxide passivated rear contact10.1016/j.solmat.2020.110585 ↗
16. Parasitic absorption in polycrystalline Si-layers for carrier-selective front junctions10.1016/j.egypro.2016.07.057 ↗
17. 23% efficient p-type crystalline silicon solar cells with hole-selective passivating contacts based on physical vapor deposition of doped silicon films10.1063/1.5037610 ↗
18. Ion implantation into amorphous Si layers to form carrier‐selective contacts for Si solar cells10.1002/pssr.201409312 ↗
19. Measurement of the emitter saturation current by a contactless photoconductivity decay method
20. Obtaining the specific contact resistance from transmission line model measurements10.1109/EDL.1982.25502 ↗
21. Temperature-induced stoichiometric changes in thermally grown interfacial oxide in tunnel-oxide passivating contacts10.1016/j.solmat.2020.110713 ↗
22. Unraveling the passivation mechanisms of c-Si/SiOx/poly-Si contacts10.1016/j.solmat.2022.112047 ↗
23. Working principle of carrier selective poly-Si/c-Si junctions: is tunnelling the whole story?10.1016/j.solmat.2016.05.045 ↗
24. Study of pinhole conductivity at passivated carrier-selected contacts of silicon solar cells10.1016/j.egypro.2016.07.040 ↗
25. Influence of PECVD deposition temperature on phosphorus doped poly-silicon passivating contacts
26. Hydrogenation of phosphorus-doped polycrystalline silicon films for passivating contact solar cells10.1021/acsami.8b19989 ↗
27. Firing stability of tube furnace‐annealed n‐type poly‐Si on oxide junctions10.1002/pip.3459 ↗
28. Firing stability of phosphorus-doped polysilicon passivating contacts: factors affecting the degradation behavior10.1016/j.solmat.2021.111407 ↗
29. Measurements of Raman crystallinity profiles in thin-film microcrystalline silicon solar cells10.1088/0022-3727/46/23/235105 ↗
30. Substrate‐independent analysis of microcrystalline silicon thin films using UV Raman spectroscopy10.1002/pssb.201700204 ↗
31. Grain size monitoring of 3D Flash memory channel poly-Si using multiwavelength Raman spectroscopy
32. Improving the microstructure and electrical properties of aluminum induced polysilicon thin films using silicon nitride capping layer10.1155/2014/342478 ↗
33. Grain growth mechanism of heavily phosphorus‐implanted polycrystalline silicon10.1149/1.2131703 ↗