Effects of the Cu/(Ga+In) ratio on the bulk and interface properties of Cu(InGa)(SSe)2 solar cells
Source abstract
Abstract
In this study, we systematically investigated the performance loss factors in Cu(InGa)(SSe)2 (CIGSSe) solar cells with various Cu/(Ga+In) (CGI) ratios, which were fabricated with sputtering and sequential selenization/sulfurization processes. The effects of the CGI ratio on the CIGSSe solar cells were determined by measuring the current–voltage (IV) curves and junction capacitance of the solar cells, as well as by performing X-ray analysis techniques on the cells. An increase in the defect density and decrease in the free carrier density were observed in samples with high Cu concentrations (CGI ratio >0.89), which resulted in a drastic decrease in the open-circuit voltage (VOC) and fill factor (FF). The temperature-dependent IV (IVT) and X-ray diffraction (XRD) results of the bulk characterization corresponded well with the capacitance measurements for all CGI ratios. The low crystal quality and short minority-carrier diffusion length at high CGI ratios resulted in a significant bulk recombination rate. A qualitative analysis of the interface characteristics was performed with IVT measurements, and the results showed that the recombination activation energy in the samples with high CGI ratios was lower than the bandgap (Eg), decreasing the VOC of these devices. For the samples with high CGI ratios, their inferior bulk and interface characteristics caused recombination to occur at the interface as well as in the bulk. However, the interface recombination rate was negligible for the samples with low CGI ratios (CGI ratio <0.89). In addition, a CIGSSe solar module was fabricated on a mass production assembly line, with the size of the CIGSSe solar module the same as that of commercially available crystalline-Si-based solar modules. The record efficiency of a solar module with a total area of is 16.0%.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Chalcogenide Semiconductor Thin Films · Semiconductor materials and interfaces · Quantum Dots Synthesis And Properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (38)
Show source-provided references
1. K. Kushiya, Future prospect of CIS-based thin film PV technology in solar frontier K.K., in: Proceedings of the 29th European Photovoltaic Solar Energy Conference, Amsterdam, 2014, 3CP.1.2.
2. Solar cell efficiency tables (version 44)10.1002/pip.2525 ↗
3. 19.9%-efficient ZnO/CdS/CuInGaSe2 solar cell with 81.2% fill factor10.1002/pip.822 ↗
4. Potassium-induced surface modification of Cu(In,Ga)Se2 thin films for high-efficiency solar cells10.1038/nmat3789 ↗
5. New world record efficiency for Cu(In,Ga)Se2 thin-film solar cells beyond 20%10.1002/pip.1078 ↗
6. K. Kushiya, Progress in large-area Cu(InGa)Se2-based thin-film modules with the efficiency of over 13%, in: Proceedings of the 3rd World Conference on Photovoltaic Energy Conversion, Osaka, 2003.
7. Experimental study of graded bandgap Cu(InGa)(SeS)2 thin films grown on glass/molybdenum substrates by selenization and sulphidation
8. Bulk and metastable defects in CuIn1−XGaXSe2 thin films using drive-level capacitance profiling10.1063/1.1633982 ↗
9. Distinguishing metastable changes in bulk CIGS defect densities from interface effects10.1016/S0040-6090(03)00189-5 ↗
10. Near-surface defect distributions in Cu(In,Ga)Se210.1016/S0040-6090(03)00148-2 ↗
11. Interdependence of absorber composition and recombination mechanism in Cu(In,Ga)(Se,S)2 heterojunction solar cells10.1063/1.1467621 ↗
12. Composition dependence of defect energies and band alignments in the Cu(In1−XGaX)(Se1-ySy)2 alloy system10.1063/1.1432126 ↗
13. Efficiency enhancement of Cu(In,Ga)Se2 thin-film solar cells by a post-deposition treatment with potassium fluoride10.1002/pssr.201307238 ↗
14. Defect formation in Cu(In,Ga)Se2 thin films due to the presence of potassium during growth by low temperature co-evaporation process10.1063/1.4832781 ↗
15. Compositional investigation of potassium doped Cu(In,Ga)Se2 solar cells with efficiencies up to 20.8%10.1002/pssr.201409040 ↗
16. Inroduction of Si PERC rear contacting design to boost efficiency of Cu(In,Ga)Se2 solar cells10.1109/JPHOTOV.2014.2350696 ↗
17. Direct evidence of void passivation in Cu(InGa)(SSe)2 absorber layer10.1063/1.4913612 ↗
18. Chalcopyrite/defect chalcopyrite heterojunctions on the basis of CuInSe210.1063/1.353020 ↗
19. Direct evidence of a buried homojunction in Cu(In,Ga)Se2 solar cells10.1063/1.1534417 ↗
20. Formation of pn homojunction in Cu(InGa)Se2 thin film solar cells by Zn doping10.1143/JJAP.39.4816 ↗
21. A. Yamada, T. Sugiyama, S. Chaisitsak, M. Konagai, Y. Kudriavtsev, A. Godines, A. Villegas, R. Asomoza, Buried pn homojunction in Cu(InGa)Se2 solar cells formed by intentional Zn doping, IEEE Photvolt. Spec. Conf., 2000, pp. 462–465.10.1143/JJAP.39.4816 ↗
22. Thin-film solar cells: devices measurements and analysis10.1002/pip.518 ↗
23. Determination of defect distributions from admittance measurements and application to Cu(In,Ga)Se2 based heterojunctions10.1063/1.363401 ↗
24. J.D. Cohen, Identifying the electronic properties relevant to improving the performance of high band-gap copper based I-III-VI2 chalcopyrite thin film photovoltaic devices, NREL Subcontract Report, 2008, SR-520-43909.10.2172/937345 ↗
25. V.I. Kaydanov, T.R. Ohno, Studies of basic electronic properties of CdTe-based solar cells and their evolution during processing and stress, NREL Subcontract Report, 2007, SR-520-41129.10.2172/899988 ↗
26. Admittance spectroscopy of cadmium free CIGS solar cells heterointerfaces10.1016/j.tsf.2005.11.087 ↗
27. Defect distributions in thin film solar cells deduced from admittance measurements under different bias voltages10.1063/1.3641987 ↗
28. Defect physics of the CuInSe2 chalcopyrite semiconductor10.1103/PhysRevB.57.9642 ↗
29. Effect of zinc addition on properties of cadmium sulfide layer and performance of Cu(In,Ga)Se2 solar cell10.1016/j.tsf.2012.11.077 ↗
30. Effect of sodium on polycrystalline Cu(In,Ga)Se2 and its solar cell performance10.1002/(SICI)1521-4095(199801)10:1<31::AID-ADMA31>3.0.CO;2-3 ↗
31. Na impurity chemistry in photovoltaic CIGS thin films: Investigation with x-ray photoelectron spectroscopy10.1116/1.580902 ↗
32. Preparation and characterization of Cu(In,Ga)Se2 thin film by selenization of Cu0.8Ga0.2 and In2Se3 precursor films10.1155/2012/149210 ↗
33. Defects in Cu(In,Ga)Se2 chalcopyrite semiconductors: a comparative study of material properties, defect states, and photovoltaic performance10.1002/aenm.201100344 ↗
34. Electronic loss mechanisms in chalcopyrite based heterojunction solar cells10.1016/S0040-6090(99)00762-2 ↗
35. Electrical characterization of Cu(In,Ga)Se2 thin-film solar cells and the role of defects for the device performance10.1016/S0927-0248(00)00273-7 ↗
36. Investigation of Cu(In,Ga)Se2 thin-film formation during the multi-stage co-evaporation process
37. Effects of Ga addition to CuInSe2 on its electronic, structural and defect properties10.1063/1.121548 ↗
38. Performance-limitations in Cu(In,Ga)Se2-based heterojunction solar cells