journal article·2023-03

Solar thermal irradiation cycles and their influence on the corrosion behaviour of stainless steels with molten salt used in concentrated solar power plants

Qingyang Liu, Jiong Qian, Anne Neville, Frederick Pessu

Publisher page

Abstract

In this study, the corrosion behaviour of stainless steels AISI 321 and 347 in molten nitrate salt were investigated for up to 28 days. Three different thermal conditions; isothermal, thermal cycling and thermal shock, were explored to investigate the effect of the likely temperature gradients on the corrosion characteristics of AISI 321 and 347 during the operation of Concentrated solar power plants. Gravimetric corrosion analysis was combined with micro-morphology and cross-sectional analysis of the corrosion interface; using a combination of scanning/transmission electron microscopy, energy dispersive X-ray spectroscopy and X-Ray diffraction techniques, for this study. Results from corrosion rate measurements and surface characterisation show that thermal shock induces higher material degradation rate than the two other temperature profiles. Severe spallation of interfacial corrosion oxide layers was observed under thermal shock conditions other than in isothermal and thermal cycling conditions and correlated to the overall performance after 28 days. The level of spallation of interfacial oxides across the three temperature profiles investigated in this study was linked to the induced stresses from mismatch in the thermal expansion properties between the corrosion oxide layer and the substrates.
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: High-Temperature Coating Behaviors · Solar Thermal and Photovoltaic Systems · Phase Change Materials Research

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (42)

Show source-provided references
1. Progress in research and development of molten chloride salt technology for next generation concentrated solar power plants10.1016/j.eng.2020.06.027 ↗
2. Materials corrosion for thermal energy storage systems in concentrated solar power plants10.1016/j.rser.2018.01.010 ↗
3. Thermal energy storage systems for concentrated solar power plants10.1016/j.rser.2017.03.139 ↗
4. Mainstreaming commercial CSP systems: a technology review10.1016/j.renene.2019.03.049 ↗
5. An overview of thermal energy storage systems10.1016/j.energy.2017.12.037 ↗
6. Review of commercial thermal energy storage in concentrated solar power plants: steam vs. molten salts10.1016/j.rser.2017.05.084 ↗
7. Heat transfer fluids for concentrating solar power systems – a review10.1016/j.apenergy.2015.01.125 ↗
8. Sensible energy storage options for concentrating solar power plants operating above 600 °C10.1016/j.rser.2019.01.062 ↗
9. Corrosion mechanisms in molten salt thermal energy storage for concentrating solar power10.1016/j.rser.2019.109328 ↗
10. Corrosion resistance of high nickel alloys in solar salt at 600 °C for up to 4000 h
11. Impact of temperature on corrosion behavior of austenitic stainless steels in solar salt for CSP application: an electrochemical study10.1016/j.solmat.2022.111661 ↗
12. High-temperature corrosion behavior of austenitic stainless steel in quaternary nitrate molten salt nanofluids for concentrated solar power10.1016/j.solmat.2022.111851 ↗
13. The corrosion behaviour of stainless steels and Ni-based alloys in nitrate salts under thermal cycling conditions in concentrated solar power plants10.1016/j.solener.2021.12.072 ↗
14. Bradshaw · 2001
15. Experimental investigations on the thermal stability of Na2CO3–K2CO3 eutectic salt/ceramic composites for high temperature energy storage10.1016/j.renene.2019.08.027 ↗
16. Effect of thermal cycling on the corrosion behaviour of stainless steels and Ni-based alloys in molten salts under air and argon10.1016/j.solener.2022.04.041 ↗
17. Evaluation of flow accelerated corrosion and mechanical performance of martensitic steel T91 for a ternary mixture of molten salts for CSP plants10.1016/j.solmat.2022.111623 ↗
18. Lessons learned from corrosion of materials with molten salts during molten salt tank preheating10.1016/j.solmat.2022.111943 ↗
19. Long-term material tests in liquid molten salts
20. Residual stress analysis in thermally grown oxide scales developed on Nb-alloyed refractory austenitic stainless steels10.1016/j.corsci.2020.109066 ↗
21. Residual stresses in oxide scale formed on Fe–17Cr stainless steel10.1016/j.apsusc.2014.07.195 ↗
22. Birks · 2006
23. Comparison of electrochemical behavior between coarse-grained and fine-grained AISI 430 ferritic stainless steel by Mott–Schottky analysis and EIS measurements10.1016/j.jallcom.2015.03.142 ↗
24. G1-03 · 2017
25. Calculations of parabolic reaction rate constants10.1007/BF00667057 ↗
26. An electrochemical study on the effect of stabilization and sensitization heat treatments on the intergranular corrosion behaviour of AISI 321H austenitic stainless steel10.1016/j.corsci.2018.03.043 ↗
27. Application of double loop electrochemical potentio-kinetic reactivation for characterizing the intergranular corrosion susceptibility of stainless steels and Ni-based alloys in solar nitrate salts used in CSP systems10.1016/j.engfailanal.2021.105717 ↗
28. Corrosion resistance of MCrAlX coatings in a molten chloride for thermal storage in concentrating solar power applications
29. Corrosion monitoring and mitigation techniques on advanced thermal energy storage materials for CSP plants10.1016/j.solmat.2018.12.028 ↗
30. Slusser · Corros. Molt. Nitrate Nitrite Salts · 1985 · 37 · 24
31. Ahmed · 2013
32. Experimental research of high temperature dynamic corrosion characteristic of stainless steels in nitrate eutectic molten salt10.1016/j.solener.2020.09.034 ↗
33. Comparative review of different influence factors on molten salt corrosion characteristics for thermal energy storage10.1016/j.solmat.2021.111485 ↗
34. Molten salt corrosion mechanisms of nitrate based thermal energy storage materials for concentrated solar power plants: a review10.1016/j.solmat.2019.02.012 ↗
35. Predicting phase equilibria of spinel-forming constituents in waste glass systems
36. Corrosion of stainless and carbon steels in molten mixtures of industrial nitrates
37. S.H. Goods, Corrosion of alloys and metals by molten nitrates
38. The oxidation behavior of an equimolar FeCoNiCrMn high-entropy alloy at 950°C in various oxygen-containing atmospheres10.1016/j.corsci.2016.03.020 ↗
39. Combined influence of Be and Ca on improving the high-temperature oxidation resistance of the magnesium alloy Mg-9Al-1Zn10.1016/j.corsci.2017.03.023 ↗
40. A cost-effective Fe-rich compositionally complicated alloy with superior high-temperature oxidation resistance10.1016/j.corsci.2020.109190 ↗
41. Theoretical analysis of the diffusion processes determining the oxidation rate of alloys10.1149/1.2779605 ↗
42. Diffusion of cations in chromia layers grown on iron-base alloys10.1007/BF00665632 ↗