journal article·2023-08

24.7% industrial tunnel oxide passivated contact solar cells prepared through tube PECVD integrating with plasma-assisted oxygen oxidation and in-situ doped polysilicon

S. Ma, B. Liao, F.Y. Qiao, D. Ding, C. Gao, Z.P. Li, R. Tong, X.Y. Kong, W.Z. Shen

Publisher page

Abstract

Tunnel oxide passivated contact (TOPCon) solar cells have gradually dominated the industrial silicon solar cells. In this paper, we have adopted the tube plasma-enhanced chemical vapor deposition (PECVD) technology integrating with nano SiO x (Tox) and in-situ phosphorus-doped polysilicon ( n + poly-Si), in which Tox is prepared by plasma-assisted oxygen (O 2 ) oxidation. Passivation and contact performance of TOPCon solar cells have been investigated under different thicknesses of Tox, and the following simulation has confirmed the optimal electrical properties, i.e., the implied open-circuit voltage ( iV OC ) of the hydrogenated lifetime sample is promoted to more than 736.1 mV on the textured wafer, corresponding to a lowest single-sided saturation current density ( J 0) of 4.6 fA/cm 2, and the contact resistivity of 1.55 mΩ cm 2 extracted from the transmission line method. Characterizations are carried out to conform the rear stack passivation layers satisfy the requirement of the high-efficiency TOPCon solar cells. Finally, we have fabricated the large-sized TOPCon solar cells with an average efficiency of 24.5% and a maximum efficiency of 24.7%, respectively. The above work has demonstrated the tube PECVD technology integrating with plasma-assisted O 2 oxidation and in-situ doped poly-Si has the potential for the mass-production TOPCon in industry.
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Silicon and Solar Cell Technologies · Thin-Film Transistor Technologies · Silicon Nanostructures and Photoluminescence

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (56)

Show source-provided references
1. Fraunhofer Institute for Solar Energy Systems · Photovolt. Rep. · 2019
2. 13% efficient industrial p-type mono PERC solar cell
3. Towards high-efficiency industrial p-type mono-like Si PERC solar cells10.1016/j.solmat.2019.110202 ↗
4. Analysis of the losses of industrial-type PERC solar cells
5. Loss analysis of 22% efficient industrial PERC solar cells10.1016/j.egypro.2017.09.322 ↗
6. The passivated emitter and rear cell (PERC): from conception to mass production10.1016/j.solmat.2015.06.055 ↗
7. Development of the PERC solar cell10.1109/JPHOTOV.2019.2899460 ↗
8. Evaluation of TOPCon technology on large area solar cells
9. 24.7% record efficiency HIT solar cell on thin silicon wafer10.1109/JPHOTOV.2013.2282737 ↗
10. Perimeter recombination in 25%-efficient IBC solar cells with passivating POLO contacts for both polarities10.1109/JPHOTOV.2017.2762592 ↗
11. Application of SiOxNy films in industrial bifacial PERC solar cells10.1016/j.solmat.2021.111199 ↗
12. Learning from the past to look beyond the roadmap of PERC Si solar cell mass production
13. Surface passivation of crystalline silicon solar cells: present and future10.1016/j.solmat.2018.06.047 ↗
14. Tong · 2021
15. n-type Si solar cells with passivating electron contact: identifying sources for efficiency limitations by wafer thickness and resistivity variation10.1016/j.solmat.2017.05.042 ↗
16. Design rules for high-efficiency both-sides-contacted silicon solar cells with balanced charge carrier transport and recombination losses10.1038/s41560-021-00805-w ↗
17. Laser contact openings for local poly-Si-metal contacts enabling 26.1%-efficient POLO-IBC solar cells10.1016/j.solmat.2018.06.020 ↗
18. Highlights of mainstream solar cell efficiencies in 202210.1007/s11708-023-0871-y ↗
19. Influence of SiOx film thickness on electrical performance and efficiency of TOPCon solar cells10.1016/j.solmat.2020.110423 ↗
20. Ion implantation for poly-Si passivated back-junction back-contacted solar cells10.1109/JPHOTOV.2014.2382975 ↗
21. Phosphorus-diffused polysilicon contacts for solar cells10.1016/j.solmat.2015.06.001 ↗
22. n-type polysilicon passivating contact for industrial bifacial n-type solar cells10.1016/j.solmat.2016.06.034 ↗
23. Peibst · 2016
24. Tunnel oxide passivated carrier-selective contacts based on ultra-thin SiO2 layers10.1016/j.solmat.2015.06.048 ↗
25. Tunnel oxide passivating electron contacts as full-area rear emitter of high-efficiency p-type silicon solar cells10.1002/pip.2960 ↗
26. Passivation effect of tunnel oxide grown by N2O plasma for c-Si solar cell applications10.1016/j.vacuum.2017.03.035 ↗
27. Ultrathin silicon oxide prepared by in-line plasma-assisted N2O oxidation (PANO) and the application for n-type polysilicon passivated contact10.1016/j.solmat.2019.110389 ↗
28. Atomic scale controlled tunnel oxide enabled by a novel industrial tube-based PEALD technology with demonstrated commercial TOPCon cell efficiencies > 2410.1002/pip.3627 ↗
29. Surface passivation of crystalline silicon solar cells: present and future10.1016/j.solmat.2018.06.047 ↗
30. Steinhauser · 2018
31. Large area TOPCon cells realized by a PECVD process
32. Charge carrier transport mechanisms of passivating contacts studied by temperature-dependent J-V measurements10.1016/j.solmat.2018.01.008 ↗
33. SiOyNx/SiNx stack anti-reflection coating with PID-resistance for crystalline silicon solar cells10.1016/j.egypro.2015.07.061 ↗
34. Effective way to reduce rear-side potential-induced degradation of bifacial PERC solar cells10.1016/j.solmat.2022.111687 ↗
35. Can we control the thickness of ultrathin silica layers by hyperthermal silicon oxidation at room temperature?10.1021/jp2082566 ↗
36. New mechanism for oxidation of native silicon oxide10.1021/jp400433u ↗
37. An industrially viable TOPCon structure with both ultra-thin SiOx and n+ poly-Si processed by PECVD for p-type c-Si solar cells10.1016/j.solmat.2019.109926 ↗
38. Different oxidation states of polycrystalline molybdenum treated by O2-plasma or O2-ion bombardment10.1016/S0039-6028(97)00973-4 ↗
39. Adsorption of lead(II) on O2-plasma-oxidized multiwalled carbon nanotubes: thermodynamics, kinetics, and desorption10.1021/am2004202 ↗
40. Influence of O2-plasma ambience and growth temperature on the oxidation of Mo-metal and volatilization of oxides10.1063/1.4821284 ↗
41. Oxidation kinetics of a silicon surface in a plasma of oxygen with inert gases
42. Nanoscale Si/SiO2 multilayer structures produced by plasma-chemical technology
43. Contactless determination of current-voltage characteristics and minority-carrier lifetimes in semiconductors from quasi-steady-state photoconductance data10.1063/1.117723 ↗
44. Measurement of the emitter saturation current by a contactless photoconductivity decay method
45. Recombination in highly injected silicon10.1109/T-ED.1987.23095 ↗
46. UV-Raman scattering of thin film Si with ultrathin silicon oxide tunnel contact for high efficiency crystal silicon solar cells10.1016/j.solmat.2018.12.025 ↗
47. Local current flow in amorphous and nanocrystalline mixed-phase silicon solar cells10.1063/1.2435077 ↗
48. Nanometer-scale surface potential and resistance mapping of wide-bandgap Cu(In,Ga) Se2 thin films10.1063/1.4907165 ↗
49. Role of Cu on the electrical properties of CdTe/CdS solar cells: a cross-sectional conductive atomic force microscopy study10.1116/1.2699923 ↗
50. Microscopic structure of the SiOx/Si interface10.1103/PhysRevB.38.6084 ↗
51. Moulder · 1992
52. Tunnel oxide passivated carrier-selective contacts based on ultra-thin SiO2 layers10.1016/j.solmat.2015.06.048 ↗
53. Study of the properties of SiOx layers prepared by different techniques for rear side passivation in TOPCon solar cells
54. Stegemann · 2018
55. Comparison of different types of interfacial oxides on hole-selective p+ poly-Si passivated contacts for high-efficiency c-Si solar cells10.1016/j.solmat.2020.110487 ↗
56. Carrier transport through the ultrathin silicon-oxide layer in tunnel oxide passivated contact (TOPCon) c-Si solar cells10.1016/j.solmat.2018.07.025 ↗