Four failure modes in silicon heterojunction glass-backsheet modules
Source abstract
Abstract
Silicon heterojunction technology (HJT) is expected to gain a significant market share in the near future. For HJT to deliver a low levelized cost of electricity (LCOE), it needs to have a high initial efficiency and degrade less than 0.5% relative per year. This work investigates damp heat-induced failure modes in silicon HJT glass-backsheet modules. Four unique failure modes are identified after damp heat (DH) testing: point failure (Type-1); failure around the interconnected regions of the busbars and ribbon wires (Type-2); failure between the busbars (Type-3); and failure at/on the interconnected regions of busbars and ribbon wires (Type-4). The Type-1 failure mode is likely caused by a chemical reaction between surface contaminants (introduced to the cells during handling or characterization before encapsulation) and moisture that increase charge carrier recombination and lead to a loss in maximum power (Pmax) of up to 40%rel in this study. Type-2 and Type-3 failure modes cause Pmax losses of ∼5%rel and 50%rel, respectively, in this study and can appear due to exposure to soldering flux used for connecting the ribbon wires and busbars. Finally, the Type-4 failure mode causes a Pmax loss of ∼16%rel in this study after the DH test. The evidence suggests that this failure mode is likely due to the interaction of acetic acid, generated from a reaction between the encapsulation material and moisture, ribbon wires, and silver paste (busbars), resulting in recombination loss. We believe these failure modes must be well understood and mitigated at preferably the solar cell level to ensure that HJT can meet its LCOE potential.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Silicon and Solar Cell Technologies · Photovoltaic System Optimization Techniques · solar cell performance optimization
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (25)
Show source-provided references
1. The value of stability in photovoltaics10.1016/j.joule.2021.10.019 ↗
2. Tourino Jacobo · 2022
3. Damp heat induced degradation of silicon heterojunction solar cells with Cu-plated contacts10.1109/JPHOTOV.2019.2941693 ↗
4. Effects of SiOx barrier layer prepared by plasma-enhanced chemical vapor deposition on improvement of long-term reliability and production cost for Cu-plated amorphous Si/crystalline Si heterojunction solar cells10.1016/j.solmat.2016.12.029 ↗
5. A reliability study of silicon heterojunction photovoltaic modules exposed to damp heat testing10.1016/j.mee.2019.111081 ↗
6. Annual degradation rates of recent crystalline silicon photovoltaic modules10.1002/pip.2903 ↗
7. Approaches to the long-term stability of silicon heterojunction modules
8. Comparison of glass/glass and glass/backsheet PV modules using bifacial silicon solar cells10.1109/JPHOTOV.2015.2405756 ↗
9. 2017
10. Design considerations for multi-terawatt scale manufacturing of existing and future photovoltaic technologies: challenges and opportunities related to silver, indium and bismuth consumption10.1039/D1EE01814K ↗
11. Aluminum-doped zinc oxide as front electrode for rear emitter silicon heterojunction solar cells with high efficiency
12. Lokanc · 2015
13. Contactless qualitative series resistance imaging on solar cells10.1109/JPHOTOV.2012.2184524 ↗
14. Detection of finger interruptions in silicon solar cells using line scan photoluminescence imaging10.1109/JPHOTOV.2017.2732220 ↗
15. Comparison of line scan luminescence imaging techniques for defect characterisation in crystalline silicon solar modules
16. Kyranaki · 2020
17. Effect of soldering on the module degradation along bus bar in DH test and PCT for crystalline Si PV modules
18. Characterization of front contact degradation in monocrystalline and multicrystalline silicon photovoltaic modules following damp heat exposure
19. Influence of pre-existing damages on the degradation behavior of crystalline silicon photovoltaic modules10.1063/1.5000294 ↗
20. Mcintosh · 2000
21. McIntosh · 2001
22. Investigation of degradation mode spreading interconnectors by pressure-cooker testing of photovoltaic cells10.1109/JPHOTOV.2019.2950079 ↗
23. Decomposition studies of no-clean solder flux systems in connection with corrosion reliability of electronics
24. Investigation of electronic corrosion at device level10.1149/1.3321952 ↗
25. Copper outdiffusion from copper-plated solar cell contacts during damp heat exposure