The electrical properties of high performance multicrystalline silicon and mono-like silicon: Material limitations and cell potential
Source abstract
Abstract
We compare the electrical properties of p-type and n-type industrially grown High Performance (HP) multicrystalline silicon (mc-Si) and mono-like silicon. The materials are characterised in terms of their bulk lifetimes, their implied open circuit voltages, and the density and recombination velocity of recombination active grain boundaries and dislocation clusters within the materials. Quokka3 is applied to simulate the cell performance potential of the studied materials, and quantify the corresponding efficiency loss due to different recombination mechanisms occurring in the bulk. Our results show that bulk recombination causes a noticeable efficiency loss in high efficiency cast-grown silicon solar cells, varying from 0.1% to 3.1% absolute in the simulated devices, depending on the materials and also the ingot position of the wafers. The performance of p-type HP mc-Si is affected by both recombination at extended crystal defects and in the intra-grain regions. N-type HP mc-Si shows a slight advantage over p-type HP mc-Si in the intra-grain regions. The advantage of p-type mono-like Si over p-type mc-Si mainly comes from optical gains due to alkaline texturing, but the material exhibits large performance variations along the ingot of up to 2.4% absolute. N-type mono-like Si shows the most promising material properties, featuring less performance variation along the ingot than p-type mono-like Si, and the highest efficiency potential among the four studied materials.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Silicon and Solar Cell Technologies · Thin-Film Transistor Technologies · Semiconductor materials and interfaces
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (50)
Show source-provided references
1. 2017
2. Development of high-performance multicrystalline silicon for photovoltaic industry10.1002/pip.2437 ↗
3. The emergence of high-performance multi-crystalline silicon in photovoltaics10.1016/j.jcrysgro.2016.10.072 ↗
4. Study of evolution of dislocation clusters in high performance multicrystalline silicon10.1016/j.solmat.2014.02.034 ↗
5. About the origin of low wafer performance and crystal defect generation on seed-cast growth of industrial mono-like silicon ingots10.1002/pip.2344 ↗
6. Characteristics and value enhancement of cast silicon ingots10.1016/j.solmat.2015.03.007 ↗
7. Solar cell efficiency losses due to impurities from the crucible in multicrystalline silicon10.1109/JPHOTOV.2013.2284060 ↗
8. Metal content of multicrystalline silicon for solar cells and its impact on minority carrier diffusion length10.1063/1.1618912 ↗
9. Impurity control in high performance multicrystalline silicon10.1002/pssa.201700319 ↗
10. Transition-metal profiles in a multicrystalline silicon ingot10.1063/1.1845584 ↗
11. Altermatt · 2018
12. Recombination activity of interstitial iron and other transition metal point defects in p- and n-type crystalline silicon10.1063/1.1812833 ↗
13. Potential gain in multicrystalline silicon solar cell efficiency by n-type doping10.1109/JPHOTOV.2014.2377554 ↗
14. High efficiency multicrystalline silicon solar cells: potential of n-type doping10.1109/JPHOTOV.2015.2466474 ↗
15. Millisecond minority carrier lifetimes in n-type multicrystalline silicon10.1063/1.1529089 ↗
16. N-type high-performance multicrystalline and mono-like silicon wafers with lifetimes above 2 ms10.7567/JJAP.56.08MB10 ↗
17. Effect of seed arrangements on the quality of n-type monolike silicon grown by directional solidification10.1021/acs.cgd.6b01317 ↗
18. Towards the efficiency limits of multicrystalline silicon solar cells10.1016/j.solmat.2018.05.006 ↗
19. Silicon heterojunction solar cells on quasi-mono wafers
20. Dependence of phosphorus gettering and hydrogen passivation efficacy on grain boundary type in multicrystalline silicon10.1063/1.4856215 ↗
21. Efficacy of phosphorus gettering and hydrogenation in multicrystalline silicon10.1109/JPHOTOV.2014.2322276 ↗
22. The role of hydrogenation and gettering in enhancing the efficiency of next-generation Si solar cells: an industrial perspective10.1002/pssa.201700305 ↗
23. Precipitates and hydrogen passivation at crystal defects in n- and p-type multicrystalline silicon10.1063/1.2800271 ↗
24. Direct comparison of the electrical properties of multicrystalline silicon materials for solar cells: conventional p-type, n-type and high performance p-type10.1016/j.solmat.2015.09.011 ↗
25. Recombination sources in p-type high performance multicrystalline silicon10.7567/JJAP.56.08MB16 ↗
26. Impact of phosphorous gettering and hydrogenation on the surface recombination velocity of grain boundaries in p-type multicrystalline silicon10.1109/JPHOTOV.2015.2455341 ↗
27. Electronic quality improvement of highly defective quasi-mono silicon material by phosphorus diffusion gettering10.1002/aelm.201600435 ↗
28. Adamczyk · 2017
29. Recombination activity of grain boundaries in high-performance multicrystalline Si during solar cell processing10.1063/1.5018797 ↗
30. Fell · 2017
31. 3-D Modeling of Multicrystalline Silicon Materials and Solar Cells10.1109/JPHOTOV.2019.2914874 ↗
32. Quantifying carrier recombination at grain boundaries in multicrystalline silicon wafers through photoluminescence imaging10.1063/1.4904963 ↗
33. Quasi-steady-state photoconductance, a new method for solar cell material and device characterization
34. Photoluminescence imaging of silicon wafers10.1063/1.2234747 ↗
35. An accurate method for calibrating photoluminescence-based lifetime images on multi-crystalline silicon wafers10.1016/j.solmat.2014.06.004 ↗
36. Contrast enhancement of luminescence images via point-spread deconvolution
37. Carrier de-smearing of photoluminescence images on silicon wafers using the continuity equation10.1063/1.4829658 ↗
38. Imaging surface recombination velocities of grain boundaries in multicrystalline silicon wafers via photoluminescence10.1002/solr.201600014 ↗
39. Evolution of grain structure and recombination active dislocations in extraordinary tall conventional and high performance multi-crystalline silicon ingots10.1016/j.jcrysgro.2016.11.030 ↗
40. Tradeoffs between impurity gettering, bulk degradation, and surface passivation of boron-rich layers on silicon solar cells10.1109/JPHOTOV.2012.2226332 ↗
41. Electrical properties of n-type multicrystalline silicon for photovoltaic application—impact of high temperature boron diffusion10.1016/j.mseb.2008.10.043 ↗
42. Improved quantitative description of Auger recombination in crystalline silicon10.1103/PhysRevB.86.165202 ↗
43. Dislocation-limited performance of advanced solar cells determined by TCAD modeling10.1016/j.solmat.2016.06.031 ↗
44. Control of ingot quality and solar cell appearance of cast mono-like silicon by using seed partitions10.1016/j.jcrysgro.2017.06.014 ↗
45. Development of high-efficiency industrial p-type multi-crystalline PERC solar cells with efficiency greater than 21%10.1016/j.egypro.2016.07.050 ↗
46. 22.61% efficient fully screen printed PERC solar cell
47. Fell · 2015 · vol. 99 · 1
48. 20.8% PERC solar cell on 156 mm X 156 mm P-type multicrystalline silicon substrate10.1109/JPHOTOV.2015.2489881 ↗
49. Development of a large area n-type PERT cell with high efficiency of 22% using industrially feasible technology10.1016/j.solmat.2016.03.032 ↗
50. 22.13% Efficient industrial p-type mono PERC solar cell