journal article·2018-02

Cu2ZnSn(SxSe1−x)4 thin film solar cell with high sulfur content (x approximately 0.4) and low Voc deficit prepared using a postsulfurization process

Shih-Hsiung Wu, Kuan-Ta Huang, Hui-Ju Chen, Chuan-Feng Shih

Publisher page

Abstract

Abstract High-efficiency (11.1%) Cu2ZnSn(SxSe1−x)4 (CZTSSe) solar cells have been obtained only with low-sulfur absorbers because the incorporation of high sulfur content is typically accompanied by a large open-circuit voltage (Voc) deficit. In this research, a sulfur content of 40% (x = 0.4) was obtained by postsulfurization. In comparison with a low-sulfur CZTSSe with x = 0.13, an efficiency of 9.8%, a band gap of 1.05 eV, and a Voc of 446 mV, the proposed cell had an efficiency of 11.1%, a band gap of 1.2 eV and a Voc of 578 mV; the post-sulfurization caused a very small increase in the Voc deficit (approximately 18 mV). Approximately 250-nm-thick S-rich CZTSSe layer was found near the surface and was close to the depletion width (approximately 238.5 nm) of the p-n junction, indicating a double-layered CZTSSe included a high-sulfur top layer was responsible for the high Voc. Admittance spectroscopy showed the activation energy of the bulk defect was 138 meV; this revealed some deep-level defects were associated with the low short-circuit current at long wavelengths. The activation energy of the interfacial defects was 1.08 eV, indicating the Voc deficits of future devices may be decreased by suitable surface treatment of high-sulfur-content CZTSSe devices.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Semiconductor materials and interfaces

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (34)

Show source-provided references
1. Compositionally tunable Cu2ZnSn(S1–xSex)4 nanocrystals: probing the effect of Se-inclusion in mixed chalcogenide thin films10.1021/ja2058692 ↗
2. Device characteristics of CZTSSe thin-film solar cells with 12.6% efficiency10.1002/aenm.201301465 ↗
3. 11.2% efficient solution processed kesterite solar cell with a low voltage deficit10.1002/aenm.201500712 ↗
4. High-efficiency Cu2ZnSn(S,Se) 4 solar cells fabricated through a low-cost solution process and a two-step heat treatment
5. Properties of Cu(In,Ga)Se2 solar cells with new record efficiencies up to 21.7%10.1002/pssr.201409520 ↗
6. Synthesis of Cu2ZnSnS4 nanocrystal ink and its use for solar cells10.1021/ja904981r ↗
7. Composition-and band-gap-tunable synthesis of wurtzite-derived Cu2ZnSn (S1–xSex)4 nanocrystals: theoretical and experimental insights10.1021/nn3052296 ↗
8. The role of sulfur in solution-processed Cu2ZnSn(S,Se)4 and its effect on defect properties10.1002/adfm.201201732 ↗
9. Controlled substitution of S by Se in reactively sputtered CZTSSe thin films for solar cells10.1016/j.jallcom.2015.06.276 ↗
10. Effect of post sulfurization temperature on the microstructure of Cu2ZnSn (S, Se) 4 thin film10.1016/j.matlet.2015.06.067 ↗
11. Characteristics of Cu 2 ZnSnSe 4 and Cu 2 ZnSn (Se, Se) 4 absorber thin films prepared by post selenization and sequential sulfurization of co-evaporated Cu–Zn–Sn precursors10.1016/j.jallcom.2013.06.064 ↗
12. Hot-injection synthesis of monodispersed Cu2ZnSn (SxSe1−x)4 nanocrystals: tunable composition and optical properties10.1039/c2jm31901b ↗
13. Why are kesterite solar cells not 20% efficient10.1016/j.tsf.2012.12.089 ↗
14. Electronic properties of the Cu2ZnSn (Se, Se) 4 absorber layer in solar cells as revealed by admittance spectroscopy and related methods10.1063/1.4729751 ↗
15. Band alignment at the Cu2ZnSn(SxSe1-x)4/CdS interface10.1063/1.3600776 ↗
16. Band tailing and efficiency limitation in kesterite solar cells10.1063/1.4820250 ↗
17. Solution-processed highly efficient Cu2ZnSnSe4 thin film solar cells by dissolution of elemental Cu, Zn, Sn, and Se powders10.1021/am5064926 ↗
18. Physical and electrical characterization of high-performance Cu 2 ZnSnSe 4 based thin film solar cells10.1016/j.tsf.2014.10.052 ↗
19. Cu2ZnSnSe4 thin-film solar cells by thermal co-evaporation with 11.6% efficiency and improved minority carrier diffusion length10.1002/aenm.201401372 ↗
20. Cation/Anion substitution in Cu2ZnSnS4 for improved photovoltaic performance10.1038/srep35369 ↗
21. Jiang · Adv. Energy Mater. · 2014 · 4 · 130138110.1002/aenm.201301381 ↗
22. Sulfurization induced surface constitution and its correlation to the performance of solution-processed Cu2ZnSn(S,Se)4 solar cells10.1038/srep06288 ↗
23. Growth and characterization of Cu2ZnSn (S, Se)4 thin films for solar cells10.1016/j.solmat.2012.02.031 ↗
24. A. route to phase controllable Cu2ZnSn(S1−xSex)4 nanocrystals with tunable energy bands10.1038/srep02733 ↗
25. T. Kobayashi, H. Sugimoto, T. Kato, H. Hakuma, T. Nakada, 23rd International Photovaltaic Science and Engineering Conference.
26. Improved Cu(In,Ga)(S,Se)2 thin film solar cells by surface sulfurization10.1016/S0927-0248(97)00054-8 ↗
27. Structural and photoelectron spectroscopic studies of band alignment at the Cu2ZnSnS4/CdS heterojunction with slight Ni doping in Cu2ZnSnS410.1088/0022-3727/49/33/335102 ↗
28. Contactless determination of current–voltage characteristics and minority‐carrier lifetimes in semiconductors from quasi‐steady‐state photoconductance data10.1063/1.117723 ↗
29. Determination of defect distributions from admittance measurements and application to Cu(In,Ga)Se2 based heterojunctions10.1063/1.363401 ↗
30. Defect levels in Cu2ZnSn(SxSe1−x)4 solar cells probed by current-mode deep level transient spectroscopy10.1063/1.4876925 ↗
31. Correlation between intrinsic defects and electrical properties in the high-quality Cu2ZnSnS4 single crystal10.1063/1.4821279 ↗
32. Free-to-bound recombination in near stoichiometric Cu2ZnSnS4 single crystals10.1103/PhysRevB.86.045206 ↗
33. Compositional dependence of structural and electronic properties of Cu2ZnSn(S,Se)4 alloys for thin film solar cells10.1103/PhysRevB.83.125201 ↗
34. Electronic properties of CuGaSe2-based heterojunction solar cells. Part I. Transport analysis10.1063/1.371903 ↗