journal article·2011-01Open access

Substrate dependent stability and interplay between optical and electrical properties in μc-Si:H single junction solar cells

M. Boccard, P. Cuony, M. Despeisse, D. Dominé, A. Feltrin, N. Wyrsch, C. Ballif

Abstract

In this work, we analyze the effect of rough ZnO front electrodes developed in-house favoring high current versus “smoother” substrates favoring good V oc and FF on the properties of microcrystalline silicon ( μ c -Si:H ) cells. Complete μ c -Si:H p- i- n solar cells with intrinsic layer thicknesses varying from 1 to 6 μ m were deposited using very high frequency plasma-enhanced chemical vapor deposition. The better scattering capabilities of rough substrates induce a significantly higher cell current in comparison to the smooth one for all the thicknesses. This allows a current output of more than 27 mA cm −2 for cells thicker than 4 μ m . As a result, there is no full compensation of poor light scattering by thickness increase up to 6 μ m in μ c -Si:H solar cells. Concerning the electrical characteristics, good quality cells are obtained for all thicknesses on smooth substrates, whereas the thick cells on rough substrates exhibit poorer electrical characteristics. Cells grown on smooth substrates show excellent stability under light soaking and atmospheric storage for all the thicknesses. However, a high increase of the saturation current is evidenced after atmospheric storage for cells grown on rough substrates and thus a degradation of their electrical characteristics is observed.
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Thin-Film Transistor Technologies · Silicon and Solar Cell Technologies · Silicon Nanostructures and Photoluminescence

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (12)

Show source-provided references
1. H.K.J. Meier, F.L. Flückiger, A. Shah, Complete microcrystalline p–i–n solar cell—crystalline or amorphous cell behavior? Applied Physics Letter 65 (1994) 860–862.10.1063/1.112183 ↗
2. Tco and light trapping in silicon thin film solar cells10.1016/j.solener.2004.03.015 ↗
3. H. Stiebig, T. Brammer, T. Repmann, O. Kluth, N. Senoussaoui, A. Lambertz, H. Wagner, Light scattering in microcrystalline silicon thin film solar cells, in: Proceedings of 16th EU-PVSEC, 2000, pp. 549–552.
4. Effects of substrate surface morphology on microcrystalline silicon solar cells10.1143/JJAP.40.L303 ↗
5. Structural defects caused by a rough substrate and their influence on the performance of hydrogenated nano-crystalline silicon n–i–p solar cells10.1016/j.solmat.2008.11.013 ↗
6. Opto-electronic properties of rough lp-cvd zno:b for use as tco in thin-film silicon solar cells10.1016/j.tsf.2007.03.130 ↗
7. Transition between grain boundary and intragrain scattering transport mechanisms in boron-doped zinc oxide thin films10.1063/1.2719158 ↗
8. J. Bailat, D. Dominé, R. Schlüchter, J. Steinhauser, S. Faÿ, F. Freitas, C. Bücher, L. Feitknecht, X. Niquille, R. Tscharner, A. Shah, C. Ballif, High-efficiency p-i-n microcrystalline and micromorph thin film silicon solar cells deposited on LPCVD ZnO coated glass substrates, in: Proceedings of the Fourth WCPEC Conference, Hawaï, 2006, pp.1533–1536.10.1109/WCPEC.2006.279775 ↗
9. Influence of the substrate geometrical parameters on microcrystalline silicon growth for thin-film solar cells10.1016/j.solmat.2009.05.025 ↗
10. Optical management in high-efficiency thin-film silicon micromorph solar cells with a silicon oxide based intermediate reflector10.1002/pssr.200802118 ↗
11. Influence on cell performance of bulk defect density in microcrystalline silicon grown by VHFPECVD10.1016/j.jnoncrysol.2005.12.042 ↗
12. Relation between substrate surface morphology and microcrystalline silicon solar cell performance10.1016/j.jnoncrysol.2007.09.084 ↗