journal article·2014-03

Correlation between charge carriers mobility and nanomorphology in a blend of P3HT/PCBM bulk heterojunction solar cell: Impact on recombination mechanisms

O. Oklobia, T.S. Shafai

Publisher page

Abstract

Sandwich configurations consisting of hole-only and electron-only devices are employed to study the transport properties of polymer/fullerene blended material. Upon thermal annealing at 150 °C and subsequent device characterisations a direct correlation between solar cell device power conversion efficiency and charge carrier mobilities is identified. The highest power conversion efficiency reported herein resulted from the electron to hole mobility ratio of 4.78. This ratio further reduces to 0.357 at 175 °C as a result of the deterioration of electron mobility at the same time as enhancement in hole carrier mobility with no further improvement in PCE. Effects of thermal annealing on trap density reveal that the trap assisted recombination is more dominant as compared to the bimolecular recombination. Furthermore such a mechanism enhances as a result of increasing trap density at higher annealing temperatures. The effect of light intensity on the open circuit voltage VOC further verifies that the dominant recombination process is through trap assisted recombination.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Organic Electronics and Photovoltaics · Conducting polymers and applications · Thin-Film Transistor Technologies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (35)

Show source-provided references
1. Forrest · Introduction: Organic Electronics and Optoelectronics, Chem. Rev. · 2007 · 107 · 923
2. Krebs · Printed metal back electrodes for R2R fabricated polymer solar cells studied using LBIC technique Sol. Energy Mater. Sol. Cells · 2011 · 95 · 1348
3. Fabrication and processing of polymer solar cells: a review of printing and coating techniques10.1016/j.solmat.2008.10.004 ↗
4. Using light induced thermocleavage in a roll-to-roll process for polymer solar cells10.1021/am900858x ↗
5. Morphology evolution via self-organization and lateral and vertical diffusion in polymer:fullerene solar cell blend10.1038/nmat2102 ↗
6. Morphological study of P3HT:PCBM blend films prepared through solvent annealing for solar cell applications10.1016/j.solmat.2010.09.004 ↗
7. Kalita · Nanostructured morphology of P3HT:PCBM bulk heterojunction solar cells, Solid-State Electron. · 2010 · 54 · 447
8. Dependence of recombination mechanisms and strength on processing conditions in polymer solar cells
9. The limits to organic photovoltaic cell efficiency10.1557/mrs2005.5 ↗
10. A brief history of the development of organic and polymeric photovoltaics10.1016/j.solmat.2004.02.021 ↗
11. Polymer solar cells10.1038/nphoton.2012.11 ↗
12. Polymer-based solar cells10.1016/S1369-7021(07)70276-6 ↗
13. Efficiency of bulk-heterojunction organic solar cells10.1016/j.progpolymsci.2013.05.001 ↗
14. Nanoscale morphology of conjugated polymer/fullerene-based bulk-heterojunction solar cells10.1002/adfm.200305026 ↗
15. Influence of processing additives to nano-morphology and efficiency of bulk-heterojunction solar cells: a comparative review10.1016/j.solener.2010.10.012 ↗
16. Roles of donor and acceptor nanodomains in 6% efficient thermally annealed polymer photovoltaics
17. Origin of the enhanced performance in poly(3-hexylthiophene):[6,6]-phenyl C61-butyric acid methyl ester solar cells upon slow drying of the active layer
18. Bimolecular recombination in polymer/fullerene bulk heterojunction solar cells
19. Investigation of nanoscale morphological changes in organic photovoltaics during solvent vapour annealing10.1039/B713926H ↗
20. Efficiency improvement of polymer solar cells by iodine doping
21. Efficiency enhancement in low-bandgap polymer solar cells by processing with alkane dithiols10.1038/nmat1928 ↗
22. Decreasing the aggregation of PCBM in P3HT/PCBMBl end films by cooling the solution10.1016/j.colsurfa.2012.12.053 ↗
23. A quantitative study of the formation of PCBM clusters upon thermal annealing of P3HT/PCBM bulk heterojunction solar cell10.1016/j.solmat.2013.05.011 ↗
24. Charge photogeneration in organic solar cells10.1021/cr900271s ↗
25. Device annealing effect in organic solar cells with blends of poly(3-hexylthiophene) and soluble fullerene10.1016/j.physletb.2005.01.019 ↗
26. Growth rate dependent trap-density in polythiophene–fullerene solar cells and its implications
27. Effect of self-organization in polymer/fullerene bulk heterojunctions on solar cell performance
28. Lampert · 1970
29. High-performance air-processed polymer–fullerene bulk heterojunction solar cells10.1002/adfm.200900311 ↗
30. Charge transport and photocurrent generation in poly(3-hexylthiophene):methanofullerene bulk-heterojunction solar cells10.1002/adfm.200500420 ↗
31. Yang · Nanoscale Morphology of High-Performance Polymer Solar Cells, Nano Lett. · 2005 · 5 · 579
32. Peter · 2009
33. Initial recombination of ions10.1103/PhysRev.54.554 ↗
34. Electric field assisted dissociation of charge transfer states as a mechanism of photocarrier production
35. Bimolecular recombination in polymer/fullerene bulk heterojunction solar cells