Performance limiting factors of Cu2ZnSn(SxSe1−x)4 solar cells prepared by thermal evaporation
Source abstract
Abstract
Abstract Cu 2 ZnSn(S x Se 1− x ) 4 (CZTSSe) thin film solar cells have been prepared by vacuum-based thermal evaporation of metal and binary sulfide precursors followed by annealing in a mixed chalcogen vapor at 550 °C for one hour. The Zn/Sn ratio in the precursor was varied from 0.75 to 1.50 keeping the Cu/(Zn+Sn) ratio constant at 0.7. The best performing solar cell was obtained with a final film composition of Cu/(Zn+Sn)=0.77 and Zn/Sn=1.13 corresponding to a Zn/Sn ratio of 0.9 in the precursor. The champion cell exhibited an open-circuit voltage ( V OC ) of 506 mV, short-circuit current density ( J SC ) of 22.92 mA/cm 2 , and a fill factor (FF) of 35% resulting in a total area efficiency ( η ) of 4.06% without any antireflection coating. Cell performance was found to be limited by high series resistance ( R S )=31.1 Ω and a low shunt resistance ( R sh )=125.2 Ω. No detrimental secondary phases, such as Cu 2− x S(Se) or ZnS were detected in the absorber film. Microstructural investigation suggested that small multigrain structure of the CZTSSe absorber layer, presence of an interfacial Mo(S,Se) x blocking barrier, and micro-air-voids at the Mo back contact are the major contributors to the origin of high R s . Morphological study of the CZTSSe film surface by atomic force microscopy revealed micro-pores that act as low resistance shunt paths and explains the source of such low R sh . The performance limiting factors of the vacuum based thermally evaporated CZTSSe thin film solar cells are reported.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Copper-based nanomaterials and applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (33)
Show source-provided references
1. Preparation and evaluation of Cu2ZnSnS4 thin films by sulfurization of E-B evaporated precursors10.1016/S0927-0248(97)00119-0 ↗
2. Cu2ZnSnS4 thin film solar cells by fast coevaporation10.1002/pip.976 ↗
3. Co-evaporated Cu2ZnSnSe4 films and devices10.1016/j.solmat.2012.01.008 ↗
4. Thermally evaporated Cu2ZnSnS4 solar cells
5. Defect levels in Cu2ZnSn(SxSe1−x)4 solar cells probed by current-mode deep level transient spectroscopy10.1063/1.4876925 ↗
6. S. Das, K.C. Mandal, Comparison of Cu2ZnSnS4 thin-film properties prepared by thermal evaporation of elemental metals and binary sulfide sources, in: Proceedings of the 38th IEEE Photovoltaic Specialists Conference (PVSC), 2012, pp. 2674–267810.1109/PVSC.2012.6318145 ↗
7. Estimates of Te and In prices from direct mining of known ores10.1002/pip.899 ↗
8. Thin-film photovoltaic cells: health and environmental issues in their manufacture use and disposal10.1002/pip.4670030504 ↗
9. Enhanced conversion efficiencies of Cu2ZnSnS4-based thin film solar cells by using preferential etching technique10.1143/APEX.1.041201 ↗
10. Cu2ZnSnSe4 thin film solar cells produced by selenisation of magnetron sputtered precursors10.1002/pip.886 ↗
11. Fabrication of 7.2% efficient CZTSSe solar cells using CZTS nanocrystals10.1021/ja108427b ↗
12. High-efficiency solution-processed Cu2ZnSn(S,Se)4 thin-film solar cells prepared from binary and ternary nanoparticles10.1021/ja3057985 ↗
13. Device characteristics of a 10.1% hydrazine-processed Cu2ZnSn(Se,S)4 solar cell10.1002/pip.1160 ↗
14. Device characteristics of CZTSSe thin-film solar cells with 12.6% efficiency10.1002/aenm.201301465 ↗
15. A high efficiency electrodeposited Cu2ZnSnS4 solar cell10.1002/aenm.201100526 ↗
16. 3.6%-CZTSSe device fabricated from ionic liquid electrodeposited Sn layer10.2174/1876531901305010021 ↗
17. Cu2ZnSn(S,Se)4 kesterite solar cell with 5.1% efficiency using spray pyrolysis of aqueous precursor solution followed by selenization10.1016/j.solmat.2014.01.029 ↗
18. Deposition and characterization of low-cost spray pyrolyzed Cu2ZnSnS4 (CZTS) thin-films for large-area high-efficiency heterojunction solar cells10.1149/1.3701535 ↗
19. 6% Efficiency Cu2ZnSnS4-based thin film solar cells using oxide precursors by open atmosphere type CVD10.1039/c2jm16454j ↗
20. 19.9%-efficient ZnO/CdS/CuInGaSe2 solar cell with 81.2% fill factor10.1002/pip.822 ↗
21. CdTe solar cells at the threshold to 20% efficiency10.1109/JPHOTOV.2013.2278661 ↗
22. High-efficiency solar cell with earth-abundant liquid-processed absorber10.1002/adma.200904155 ↗
23. Photoluminescence and Raman study of Cu2ZnSn(SexS1−x)4 monograins for photovoltaic applications10.1016/j.tsf.2010.12.099 ↗
24. Single phase polycrystalline Cu2ZnSnS4 grown by vertical gradient freeze technique10.1016/j.jcrysgro.2013.07.022 ↗
25. Cu2ZnSnSe4 photovoltaic absorber grown by vertical gradient freeze technique10.7567/JJAP.52.125502 ↗
26. Imaging and phase identification of Cu2ZnSnS4 thin films using confocal Raman spectroscopy10.1116/1.3625249 ↗
27. Growth and characterization of kesterite Cu2ZnSn(SxSe1-x)4 crystals for photovoltaic applications10.1016/j.materresbull.2014.04.073 ↗
28. Reaction pathways for the formation of Cu2ZnSn(Se,S)4 absorber materials from liquid-phase hydrazine-based precursor inks10.1039/c2ee21529b ↗
29. Improvement in the properties of CZTSSe thin films by selenizing single-step electrodeposited CZTS thin films10.1016/j.jallcom.2014.12.253 ↗
30. Band-gap-graded Cu2ZnSn(S1−x,Sex)4 solar cells fabricated by an Ethanol-based, particulate precursor Ink Route10.1038/srep03069 ↗
31. Effect of the stacked structure on performance in CZTSSe thin film solar cells
32. Effects of SnSe2 secondary phases on the efficiency of Cu2ZnSn(Sx,Se1 − x)4 based solar cells10.1016/j.tsf.2014.10.058 ↗
33. Optical and surface probe investigation of secondary phases in Cu2ZnSnS4 films grown by electrochemical deposition10.1016/j.solmat.2015.03.003 ↗