Interpretation of the degradation of silicon HIT solar cells due to inadequate front contact TCO work function
Source abstract
Abstract
Abstract The degradation of the open circuit voltage ( V OC ) and of the I – V characteristics of p + /n amorphous silicon/crystalline silicon heterojunction solar cells (a-Si:H(p + /i)/c-Si(n) HIT cells) due to the use of transparent conducting oxide (TCO) with small work function at the front contact is investigated. The influence of the TCO work function on the band diagrams, carrier profiles and I – V characteristics in the dark and under illumination is studied by means of AFORS-HET device simulations supported by circuit modeling. It is found that when the TCO work function is not high enough to ensure a good ohmic contact with p-type heavily doped a-Si:H(p + ) the V OC degradation is due to the rectifying Schottky barrier at the TCO/a-Si:H(p + ) interface. On the other hand, if in addition to the small TCO work function the p-type active doping level in a-Si:H(p + ) is reduced, the hole concentration in the p + inversion layer emitter at the hetero-interface significantly drops leading to a strong enhancement of the emitter dark current and to serious V OC degradation. Moreover, if carrier recombination at the hetero-interface is significant, the weak inversion layer emitter may collapse at a relatively low cell voltage leading to total cell failure.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Silicon and Solar Cell Technologies · Thin-Film Transistor Technologies · Semiconductor materials and interfaces
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (40)
Show source-provided references
1. Achievement of more than 25% conversion efficiency with crystalline silicon heterojunction solar cell10.1109/JPHOTOV.2014.2352151 ↗
2. 24.7% record efficiency HIT solar cell on thin silicon wafer10.1109/JPHOTOV.2013.2282737 ↗
3. Solar cell efficiency tables (version 39)10.1002/pip.2163 ↗
4. On the possible role of the interfacial inversion layer in the improvement of the performance of hydrogenated amorphous silicon/crystalline silicon heterojunction solar cell10.1016/j.solmat.2014.09.008 ↗
5. Optimization and characterization of amorphous/crystalline silicon heterojunction solar cells10.1002/pip.398 ↗
6. Determination of band-offsets in a-Si:H/c-Si heterojunctions from capacitance-voltage measurements: capabilities and limits10.1016/j.tsf.2006.11.198 ↗
7. K. Ghosh, C. Tracy, S. Herasimenka, C. Honsberg, S. Bowden, Explanation of the device operation principle of amorphous silicon/crystalline silicon heterojunction solar cell and role of the inversion of crystalline silicon surface, in: Proceedings of the 35th IEEE Photovoltaic Specialists Conference, IEEE Piscataway NJ, 2010, pp. 1383–1386.10.1109/PVSC.2010.5614387 ↗
8. Determination of the conduction band offset between hydrogenated amorphous silicon and crystalline silicon from surface inversion layer conductance measurements10.1063/1.2907695 ↗
9. Study of the interfacial properties of amorphous silicon/n-type crystalline silicon heterojunction through static planar conductance measurements10.1002/pssc.200982800 ↗
10. Band bending and determination of band offsets in amorphous/crystalline silicon hetero-structures from planar conductance measurements10.1063/1.4769736 ↗
11. Observation by conductive-probe atomic force microscopy of strongly inverted surface layers at the hydrogenated amorphous silicon/crystalline silicon heterojunctions10.1063/1.3525166 ↗
12. Capacitance study of inversion at the amorphous-crystalline interface of n-type silicon heterojunction solar cells10.1063/1.3663433 ↗
13. Understanding inversion layers and band discontinuities in hydrogenated amorphous silicon/crystalline silicon heterojunctions from the temperature dependence of the capacitance10.1063/1.4826920 ↗
14. Band lineup theories and the determination of band offsets from electrical measurements
15. Impact of Fermi-level dependent defect equilibration on Voc of amorphous/crystalline silicon heterojunction solar cells10.1016/j.egypro.2011.06.137 ↗
16. Silicon heterojunction solar cells: optimization of emitter and contact properties from analytical calculation and numerical simulation10.1016/j.mseb.2012.11.011 ↗
17. Analysis of lateral transport through the inversion layer in amorphous silicon/crystalline silicon heterojunction solar cells10.1063/1.4818709 ↗
18. , Influence of TCO type on the performance of amorphous silicon solar cells10.1117/12.796096 ↗
19. Role of the work function of transparent conductive oxide on the performance of amorphous/crystalline silicon heterojunction solar cells studied computer simulation10.1002/pssa.200723276 ↗
20. Improving the a-Si:H(p) rear emitter contact of n-type silicon solar cells10.1016/j.solmat.2012.06.036 ↗
21. Computer simulation of a-Si/c-Si heterojunction solar cell with high conversion efficiency10.1016/j.solener.2011.10.015 ↗
22. TCO work function related transport losses at the a-Si:H/TCO-contact in SHJ solar cells10.1016/j.solmat.2014.06.026 ↗
23. Transparent conducting oxides for photovoltaics: manipulation of fermi level, work function and energy band alignment10.3390/ma3114892 ↗
24. Analysis of TCO/p (a-SiC:H) heterojunction and its influence on p-i-n a-Si:H solar cell performance10.1016/0022-3093(95)00512-9 ↗
25. Carrier transport mechanism in the SnO2:F/p-type a-Si:H heterojunction10.1063/1.3606408 ↗
26. Design of Schottky contacts for optimum performance of thin-film silicon solar cells10.1109/JPHOTOV.2014.2362306 ↗
27. Work function of transparent conducting multicomponent oxide thin films prepared by magnetron sputtering10.1016/S0257-8972(98)00592-1 ↗
28. Hydrogen-doped indium oxide/indium tin oxide bilayers for high-efficiency silicon heterojunction solar cells10.1016/j.solmat.2013.03.024 ↗
29. Improved fill factors in amorphous silicon solar cells on zinc oxide by insertion of a germanium layer to block impurity incorporation10.1063/1.1773372 ↗
30. J.-S. Im, J.-W. Jeon, S. Park, Y. Lee, K.S. Lim, Improvement of amorphous silicon solar cell performance by inserting a tungsten oxide layer between zinc oxide and p-type amorphous silicon carbide, in: Proceedings of the 37th IEEE Photovoltaic Specialists Conference, IEEE Piscataway NJ, 2011, pp. 612–615.10.1109/PVSC.2011.6186028 ↗
31. The emitter having microcrystalline surface in silicon heterojunction interdigitated back contact solar cells10.7567/JJAP.51.10NA05 ↗
32. General principles of solar cell simulation and introduction to AFORS-HET
33. Development of new a-Si/c-Si heterojunction solar cells: ACJ-HIT (Artificially Constructed Junction-Heterojunction with Intrinsic Thin-layer)10.1143/JJAP.31.3518 ↗
34. An improved value for the silicon intrinsic carrier concentration at 300K10.1063/1.103707 ↗
35. Doping type and thickness dependence of band offsets at the amorphous/crystalline silicon heterojunction
36. Heterojunctions of hydrogenated amorphous silicon and monocrystalline silicon
37. The physics and modeling of heavily doped emitters10.1109/T-ED.1984.21805 ↗
38. Effects of the Au/CdTe back contact on IV and CV characteristics of Au/CdTe/CdS/TCO solar cells10.1063/1.363946 ↗
39. Effect of back-contact barrier on thin-film CdTe solar cells10.1016/j.tsf.2006.01.004 ↗
40. Characterization of the anomalous second junction in Mo/CuInSe2/(CdZn)S/ITO solar cells10.1016/0379-6787(91)90019-L ↗