Rheological behaviors of sugar alcohols for low-to-medium temperature latent heat storage: Effects of temperature in both the molten and supercooled liquid states
Source abstract
Abstract
Abstract As potential candidates of solid−liquid phase change materials (PCM) for latent heat storage in the low-to-medium temperature range (80–250 °C), the temperature-dependent rheological behaviors of five select sugar alcohols were characterized over a wide range of shear rates from 10−3 s−1 to 104 s−1. It was found that the four linear-structured sugar alcohols, i.e., xylitol, erythritol, d-mannitol, and d-dulcitol, are Newtonian fluids above their respective critical shear rates, in both the molten and supercooled liquid states, and that they exhibit typical shear thinning behaviors below the critical shear rates. In particular, d-mannitol and d-dulcitol, with relatively higher melting points, behave like Herschel-Bulkley fluids, which experience slight yield under small yield stresses (0.0001–0.0099 Pa s and 0.0078–0.0528 Pa s for d-mannitol and d-dulcitol, respectively). Inositol, the only cyclic-structured sugar alcohol with the highest melting point (497.65 K), also behaves like a Herschel-Bulkley fluid in both the molten and supercooled liquid states. The dynamic viscosity curves of inositol were found to agree with the Cross model, leading to determination on its zero shear and infinite shear viscosities. An Arrhenius-type dynamic viscosity-temperature curve was observed for inositol over the entire temperature range at the highest shear rate of 104 s−1.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Phase Change Materials Research · Adsorption and Cooling Systems · Nanofluid Flow and Heat Transfer
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (36)
Show source-provided references
1. Phase change materials for thermal energy storage10.1016/j.pmatsci.2014.03.005 ↗
2. Advancement in phase change materials for thermal energy storage applications10.1016/j.solmat.2017.07.023 ↗
3. Carbon based material included-shaped stabilized phase change materials for sunlight-driven energy conversion and storage: an extensive review10.1016/j.solener.2018.05.007 ↗
4. Potential of cascaded phase change materials in enhancing the performance of solar domestic hot water systems10.1016/j.solener.2017.11.034 ↗
5. Utilization of phase change materials in solar domestic hot water systems10.1016/j.renene.2008.10.016 ↗
6. Performance evaluation of nano-enhanced phase change materials during discharge stage in waste heat recovery10.1016/j.renene.2018.05.009 ↗
7. Application of TCE-PCM based heat sinks for cooling of electronic components: a review10.1016/j.rser.2015.12.238 ↗
8. The experimental phase diagram study of the binary polyols system erythritol−xylitol10.1016/j.solmat.2017.08.005 ↗
9. New sugar alcohols mixtures for long-term thermal energy storage applications at temperatures between 70°C and 100°C10.1016/j.solmat.2016.06.048 ↗
10. A eutectic mixture of galactitol and mannitol as a phase change material for latent heat storage10.1016/j.enconman.2015.06.013 ↗
11. Eutectic mixtures of sugar alcohols for thermal energy storage in the 50–90°C temperature range10.1016/j.solmat.2014.11.050 ↗
12. Screening of sugar alcohols and their binary eutectic mixtures as phase change materials for low-to-medium temperature latent heat storage. (Ⅰ): non-isothermal melting and crystallization behaviors10.1016/j.energy.2018.07.081 ↗
13. Characterization of different sugar alcohols as phase change materials for thermal energy storage applications10.1016/j.solmat.2016.10.009 ↗
14. Developments in organic solid–liquid phase change materials and their applications in thermal energy storage10.1016/j.enconman.2015.01.084 ↗
15. Heat transfer and interface motion during melting and solidification around a finned heat source/sink10.1115/1.3244532 ↗
16. Slow molecular mobility in the crystalline and amorphous solid states of pentitols: a study by thermally stimulated depolarisation currents and by differential scanning calorimetry10.1016/j.carres.2007.01.016 ↗
17. Crystal growth from the melt: a review
18. Cycling stability of d-mannitol when used as phase change material for thermal storage applications10.1016/j.tca.2017.12.026 ↗
19. Experimental and in silico characterization of xylitol as seasonal heat storage material10.1016/j.fluid.2016.12.020 ↗
20. Characterization of sugar alcohols as seasonal heat storage media–experimental and theoretical investigations
21. Applicability for heat storage of binary systems of neopentylglycol, pentaglycerine and pentaerythritol: a comparative analysis10.1016/0165-1633(88)90051-2 ↗
22. Crystallization and glass properties of pentitols10.1023/A:1025482230325 ↗
23. Viscosity of nanofluids: a review of recent experimental studies10.1016/j.icheatmasstransfer.2016.02.005 ↗
24. Rheological properties of the mucilage gum (opuntia ficus indica)10.1016/S0268-005X(00)00015-1 ↗
25. Modelling the flow behaviour of very shear-thinning liquids10.1016/S0009-2509(01)00291-3 ↗
26. On the determination of yield surfaces in herschel–bulkley fluids10.1122/1.550992 ↗
27. Getting the zero shear viscosity of polymer melts with different rheological tests
28. The yield stress myth10.1007/BF01333960 ↗
29. Rheology of non-Newtonian fluids: a new flow equation for pseudoplastic systems10.1016/0095-8522(65)90022-X ↗
30. Analysis of flow data on molten polymers10.1016/0014-3057(66)90050-4 ↗
31. Polymer rheology: influence of molecular weight and polydispersity10.1002/app.1969.070130415 ↗
32. Relation between viscoelasticity and shear-thinning behaviour in liquids10.1007/BF01520357 ↗
33. Influence of cross-link density on rheological properties of temperature-sensitive microgel suspensions10.1007/s003960000329 ↗
34. Rheological analysis of highly pigmented inks: flocculation at high temperatures10.1122/1.550948 ↗
35. Thermodynamic parameters of bonds in glassy materials from viscosity-temperature relationships10.1088/0953-8984/19/41/415107 ↗
36. Measurement of the temperature dependent viscosity of biodiesel fuels10.1016/j.fuel.2003.08.001 ↗