Dependence of Se beam pressure on defect states in CIGS-based solar cells
Source abstract
Abstract
Abstract The influence of Se beam pressure on defect properties in Cu(In 1– x ,Ga x )Se 2 (CIGS)-based solar cells fabricated by the three-stage process was investigated by admittance spectroscopy. The Se beam pressure was varied from 1.3×10 −3 to 4.4×10 −3 Pa, at the position of the samples, by varying the Se cell temperature. The spectra for all samples show three distinct peaks denoted as α , β , and ζ with activation energies of 20, 150, and 300 meV, respectively. The trap density of ζ increased from 5×10 14 to 4×10 15 cm −3 with decrease in Se beam pressure; the trap densities of α and β did not change. These results suggest that the origin of ζ is related to the Se deficiency. The density of ζ seems to correlate with the cell efficiency. Therefore, it is important to control the Se beam pressure in order to obtain highly efficient solar cells.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Advanced Semiconductor Detectors and Materials
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (21)
Show source-provided references
1. Electrical characterization of Cu(In,Ga)Se2 thin-film solar cells and the role of defects for the device performance10.1016/S0927-0248(00)00273-7 ↗
2. Effect of Ga content on defect states in CuIn1−xGaxSe2 photovoltaic devices10.1063/1.1485301 ↗
3. The influence of buffer layer on the transient behavior of thin film chalcopyrite devices10.1016/j.solmat.2004.02.038 ↗
4. Chalcopyrite/defect chalcopyrite heterojunctions on the basis of CuInSe210.1063/1.353020 ↗
5. Preferred orientation control of Cu(In1−xGax)Se2 (x≈0.28) thin films and its influence on solar cell characteristics10.1143/JJAP.41.507 ↗
6. Na-induced variations in the structural, optical, and electrical properties of Cu(In,Ga)Se2 thin films10.1063/1.3190528 ↗
7. Transport properties of CuInSe210.1016/0379-6787(86)90091-8 ↗
8. Defect physics of the CuInSe2 chalcopyrite semiconductor10.1103/PhysRevB.57.9642 ↗
9. Light- and bias-induced metastabilities in Cu(In,Ga)Se2 based solar cells caused by the (VSe–VCu) vacancy complex10.1063/1.2388256 ↗
10. Creation and relaxation of light- and bias-induced metastabilities in Cu(In,Ga)Se210.1063/1.3213339 ↗
11. Effect of Se/(Ga+In) ratio on MBE grown Cu(In,Ga)Se2 thin film solar cell10.1016/j.jcrysgro.2008.12.005 ↗
12. Effects of Se flux on the microstructure of Cu(In,Ga)Se2 thin film deposited by a three-stage co-evaporation process10.1149/1.2208011 ↗
13. Microstructure of Cu(In,Ga)Se2 films deposited in low Se vapor pressure10.1143/JJAP.38.2888 ↗
14. Fabrication of wide-gap Cu(In1xGax)Se2 thin film solar cells: a study on the correlation of cell performance with highly resistive i-ZnO layer thickness10.1016/j.solmat.2004.08.017 ↗
15. Determination of defect distributions from admittance measurements and application to Cu(In,Ga)Se2 based heterojunctions10.1063/1.363401 ↗
16. Photocapacitance Spectroscopy in copper indium diselenide alloys
17. Effects of annealing under various atmospheres on electrical properties of Cu(In,Ga)Se2 films and CdS/Cu(In,Ga)Se2 heterostructures10.1016/j.tsf.2007.12.135 ↗
18. M.M. Islam, T. Sakurai, S. Otagiri, S. Ishizuka, A. Yamada, K. Sakurai, K. Matsubara, S. Niki, K. Akimoto, Determination of Cu(In,Ga)3Se5 defect phase in CIGS material by Rietveld analysis, Sol. Energy Mater. Sol. Cells, in press.
19. Preparation and characterization of Cu(In1−xGax)3Se5 thin films10.1063/1.115456 ↗
20. T. Nakada, T. Mouri, Y. Okano, A. Kunioka, Cu(In,Ga)3Se5-based thin film solar cells fabricated by Na control technique, in Proceedings of the 14th European Photovoltaic Solar Energy Conference, Barcelona, 1997, 2143–2146.
21. Anion vacancies in CuInSe210.1016/S0040-6090(00)01718-1 ↗