Experimental investigation of Cu(In1−x,Gax)Se2/Zn(O1−z,Sz) solar cell performance
Source abstract
Abstract
CdS is conventionally used as a buffer layer in Cu(In,Ga)Se2, CIGS, solar cells. The aim of this thesis is to substitute CdS with cadmium-free, more transparent and environmentally benign alternative buffer layers and to analyze how the material properties of alternative layers affect the solar cell performance. The alternative buffer layers have been deposited using Atomic Layer Deposition, ALD. A theoretical explanation for the success of CdS is that its conduction band, Ec, forms a small positive offset with that of CIGS. In one of the studies in this thesis the theory is tested experimentally by changing both the Ec position of the CIGS and of Zn(O,S) buffer layers through changing their gallium and sulfur contents respectively. Surprisingly, the top performing solar cells for all gallium contents have Zn(O,S) buffer layers with the same sulfur content and properties in spite of predicted unfavorable Ec offsets. An explanation is proposed based on observed non-homogenous composition in the buffer layer. This thesis also shows that the solar cell performance is strongly related to the resistivity of alternative buffer layers made of (Zn,Mg)O. A tentative explanation is that a high resistivity reduces the influence of shunt paths at the buffer layer/absorber interface. For devices in operation however, it seems beneficial to induce persistent photoconductivity, by light soaking, which can reduce the effective Ec barrier at the interface and thereby improve the fill factor of the solar cells. Zn-Sn-O is introduced as a new buffer layer in this thesis. The initial studies show that solar cells with Zn-Sn-O buffer layers have comparable performance to the CdS reference devices. While an intrinsic ZnO layer is required for a high reproducibility and performance of solar cells with CdS buffer layers it is shown in this thesis that it can be thinned if Zn(O,S) or omitted if (Zn,Mg)O buffer layers are used instead. As a result, a top conversion efficiency of 18.1 % was achieved with an (Zn,Mg)O buffer layer, a record for a cadmium and sulfur free CIGS solar cell.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Copper-based nanomaterials and applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (30)
Show source-provided references
1. 19.9%-efficient ZnO/CdS/CuInGaSe2 solar cell with 81.2% fill factor10.1002/pip.822 ↗
2. High quality baseline for high efficiency, Cu(In1−x,Gax)Se2 solar cells10.1002/pip.757 ↗
3. 18% Efficiency Cd-free Cu(In,Ga)Se2 thin-film solar cells fabricated using chemical bath deposition (CBD)–ZnS buffer layers10.1143/JJAP.41.L165 ↗
4. Highly efficient CIS solar cells and modules made by the co-evaporation process10.1016/j.tsf.2008.10.126 ↗
5. Green · 1992
6. Fabrication of wide-gap Cu(In1−xGax)Se2 thin film solar cells: a study on the correlation of cell performance with highly resistive i-ZnO layer thickness10.1016/j.solmat.2004.08.017 ↗
7. Improved performance in ZnO/CdS/CuGaSe2 thin-film solar cells10.1002/pip.516 ↗
8. Using atomic layer deposited Zn(O,S) and (Zn,Mg)O buffer layers10.1016/j.tsf.2008.10.109 ↗
9. H. Marko, A. Hultqvist, C. Platzer-Björkman, S. Noël, J. Kessler, CuIn0.5Ga0.5Se2 growth by isothermal and bithermal Cu-poor/rich/poor sequence on solar cell properties, in: Material Research Society Symposium Proceedings, Spring meeting, San Francisco, vol. 1165, 2009, pp. M02-05.
10. Prospects of wide-gap chalcopyrites for thin film photovoltaic modules10.1016/S0927-0248(97)00199-2 ↗
11. Influence of the Ga-content on the bulk defect densities of Cu(In,Ga)Se210.1016/S0040-6090(00)01710-7 ↗
12. Effect of the Ga content on defect states in CuIn1−xGaxSe2 photovoltaic devices10.1063/1.1485301 ↗
13. Interdependence of absorber composition and recombination mechanism in Cu(In,Ga)(Se,S)2 heterojunction solar cells10.1063/1.1467621 ↗
14. On the CdS/CuInSe2 conduction band discontinuity10.1063/1.115523 ↗
15. Zn(O,S) buffer layers by atomic layer deposition in Cu(In,Ga)Se2 based thin film solar cells: band alignment and sulfur gradient10.1063/1.2222067 ↗
16. Baseline Cu(In,Ga)Se2 device production: control and statistical significance10.1016/S0927-0248(00)00264-6 ↗
17. M. Bodegård, J. Kessler, O. Lundberg, J. Schöldström, L. Stolt, Growth of Co-evaporated Cu(In,Ga)Se2, in: The Influence of Rate Profiles on Film Morphology, Materials Research Society Symposium Proceedings, Spring meeting, San Francisco, vol. 688, 2001, pp. H2.2.1–H2.2.12.10.1557/PROC-668-H2.2 ↗
18. U. Zimmermann, M. Ruth, M. Edoff, Cadmium free CIGS mini-modules with ALD-grown Zn(O,S)-based buffer layers, in: Proceedings of the 21st European Photovoltaic Solar Energy Conference, Dresden 2006, pp. 1831-1834.
19. Briggs · 1990 · vol. 1
20. Birkholz · 2006
21. Cu(In,Ga) Se2 solar cells
22. N.A. Allsop, C. Camus, S. Gledhill, T. Unold, M. Lux-Steiner, T. Niesen, C.-H. Fischer, Nanostructured ZnS:In2S3 buffer layers on Cu(In,Ga)(S,Se)2: can voltage and efficiency be improved through interface inhomogenities on a scale below the minority carrier diffusion length, in: Materials Research Society Symposium Proceedings, Spring meeting, San Francisco, vol. 1012, 2007, pp. 43–49.
23. In situ monitoring the growth of thin-film ZnS/Zn(S,O) bilayer on Cu-chalcopyrite fo high performance thin film solar cells10.1016/j.tsf.2008.10.139 ↗
24. Photoemission studies on Cu(In, Ga)Se2 thin films and related binary selenides10.1016/S0169-4332(96)00099-2 ↗
25. Strong valence-band offset bowing of ZnO1−xSx enhances p-type nitrogen doping of ZnO-like alloys10.1103/PhysRevLett.97.146403 ↗
26. Electronic properties of CuGaSe2-based heterojunction solar cells
27. The effect of Zn1−xMgxO buffer layer deposition temperature on Cu(In,Ga)Se2 solar cells: a study of the buffer/absorber interface10.1002/pip.859 ↗
28. C. Platzer-Björkman, P. Zabierowski, J. Pettersson, T. Töndahl, M. Edoff, Improved fill factor and open circuit voltage by crystalline selenium at the Cu(In,Ga)Se2/buffer layer interface in thin film solar cells, Progress in Photovoltaics: Research and Appliations, Early View.
29. Electrical and optical properties of point-contacted a-Si:H/c-Si heterojunction solar cells with patterned SiO2 at the interface10.1016/j.solmat.2007.04.013 ↗
30. Band offset of high efficiency CBD-ZnS/CIGS thin film solar cells10.1016/S0040-6090(03)00265-7 ↗