Ti3+ states induced band gap reduction and enhanced visible light absorption of TiO2 nanotube arrays: Effect of the surface solid fraction factor
Source abstract
Abstract
Abstract In this work, a simple strategy was used to prepare Ti 3+ surface defect states through the simple UV irradiation of TiO 2 nanotubes (TiNT) formed in ethylene glycol/NH 4 F/H 3 PO4/H 2 O mixture at different anodizing potentials. The band gap electronic states created by Ti 3+ are mostly responsible for the effective narrowing of band gap. The effect of anodizing potential on surface states of TiO 2 nanotubes/electrolyte interface has been studied under UV irradiation. A quantitative and qualitative analysis of surface states of TiNT formed at different anodizing potential was performed using capacitance measurements. These measurements allow us to provide evidence for the presence of monoenergetic surface states in the band gap. The energy levels and the density of surface states have been determined. Both density and energetic location are very dependent on the geometric characteristics. Relatively wide distribution of these states in a range of electric energy of 0.17–0.35 eV below the edge of the conduction band was obtained according to the anodizing potential. The optical absorption at 630 nm may be attributed to deep level states originated from oxygen vacancies associated with Ti 3+ . The presence of energetic level states and elevated surface solid fraction factor of TiNT are the determining factors in enhancing the photoactivity in visible light as evidenced by high photocurrent densities up to 16 mA cm −2 .
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: TiO2 Photocatalysis and Solar Cells · Advanced Photocatalysis Techniques · Gas Sensing Nanomaterials and Sensors
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (66)
Show source-provided references
1. Photocatalytic water treatment by titanium dioxide: recent updates10.3390/catal2040572 ↗
2. Titanium dioxide-based nanomaterials for photocatalytic fuel generations10.1021/cr500008u ↗
3. Effects of Sn dopant on the photoinduced charge property and photocatalytic activity of TiO2 nanoparticles10.1016/j.apcatb.2005.08.012 ↗
4. Thiols passivate recombination centers in colloidal quantum dots leading to enhanced photovoltaic device efficiency10.1021/nn800471c ↗
5. Enhanced photoelectrocatalytic water splitting at hierarchical Gd3+:TiO2 nanostructures through amplifying light reception and surface states passivation10.1149/2.0161503jes ↗
6. Surface state recombination and passivation in nanocrystalline TiO2 dye-sensitized solar cells10.1021/jp408055g ↗
7. Recombination in SnO2-based quantum dots sensitized solar cells: the role of surface states10.1021/jp402601v ↗
8. Surface properties and photoactivity of TiO2 treated with electron beam10.1016/j.radphyschem.2005.10.015 ↗
9. The impact of silver modification on the catalytic activity of iodine-doped titania for p-chlorophenol degradation under visible-light irradiation10.1016/j.molcata.2009.12.003 ↗
10. Dye-sensitized solar cells with modified TiO2 surface chemical states: The role of Ti3+10.1063/1.3660711 ↗
11. The role of oxygen vacancy-Ti3+ states on TiO2 nanotubes surface in dye-sensitized solar cells10.1016/j.matlet.2013.02.116 ↗
12. Plasma reduction of nanostructured TiO2 electrode to improve photovoltaic efficiency of dye-sensitized solar cells10.1149/2.0421414jes ↗
13. Preparation of highly visible-light active N-doped TiO2 photocatalyst10.1039/c0jm00376j ↗
14. Visible-light-induced photoelectrochemical behaviors of Fe modified TiO2 nanotube arrays10.1039/c1nr10282f ↗
15. An economic method to prepare vacuum activated photocatalysts with high photo-activities and photosensitivities10.1039/c1cc10537j ↗
16. CdS–CdSe (CdTe) core–shell quantum dots sensitized TiO2 nanotube array solar cells10.1016/j.solmat.2014.10.014 ↗
17. Broadband plasmon photocurrent generation from Au nanoparticles/mesoporous TiO2 nanotube electrodes10.1016/j.solmat.2015.02.021 ↗
18. Silver nanoparticles and defect-induced visible light photocatalytic and photoelectrochemical performance of Ag@m-TiO2 nanocomposite10.1016/j.solmat.2015.05.029 ↗
19. Hydrogenated titania: synergy of surface modification and morphology improvement for enhanced photocatalytic activity10.1039/c2cc32220j ↗
20. Effect of nature and location of defects on bandgap narrowing in black TiO2 nanoparticles10.1021/ja3012676 ↗
21. Zhang · Mater. Lett. · 2013 · 51 · 10010.1016/j.matlet.2012.09.092 ↗
22. Self-doped Ti3+ enhanced photocatalyst for hydrogen production under visible light10.1021/ja103843d ↗
23. Increasing solar absorption for photocatalysis with black hydrogenated titanium dioxide nanocrystals10.1126/science.1200448 ↗
24. Some critical factors for photocatalysis on self organized TiO2 nanotubes10.1007/s10008-012-1799-z ↗
25. Microwave-assisted preparation of self-doped TiO2 nanotube arrays for enhanced photoelectrochemical water splitting10.1039/C4TA05021E ↗
26. TiO2 nanotubes: tailoring the geometry in H3PO4/HF electrolytes10.1016/j.elecom.2006.05.030 ↗
27. Effect of Anodizing Potential on the Formation and EIS Characteristics of TiO2 Nanotube Arrays
28. Photo-induced effects on self-organized TiO2 nanotube arrays: the influence of surface morphology10.1088/0957-4484/20/4/045603 ↗
29. Characterization and photocatalytic activity of TiO2 nanotube films prepared by anodization10.1155/2013/179427 ↗
30. Towards ideal hexagonal self-ordering of TiO2 nanotubes10.1002/pssr.200701148 ↗
31. Self-organized TiO2 nanotube arrays by anodization of Ti substrate: effect of anodization time, voltage and medium composition on oxide morphology and photoelectrochemical response10.1557/JMR.2007.0391 ↗
32. Properties of the electronic density of states in TiO2 nanoparticles surrounded with aqueous electrolyte10.1007/s10008-006-0220-1 ↗
33. Cyclic voltammetry studies of nanoporous semiconductors. Capacitive and reactive properties of nanocrystalline TiO2 electrodes in aqueous electrolyte10.1021/jp0265182 ↗
34. Characteristics of high efficiency dye-sensitized solar cells10.1021/jp064256o ↗
35. A review of recent results on electrochemical determination of the density of electronic states of nanostructured metal-oxide semiconductors and organic hole conductors10.1016/j.ica.2007.05.032 ↗
36. Dye-sensitized solar cells based on oriented TiO2 nanotube arrays: transport, trapping, and transfer of electrons10.1021/ja804852z ↗
37. The enhancement of TiO2 photocatalytic activity by hydrogen thermal treatment10.1016/S0045-6535(02)00486-1 ↗
38. Optically modulated charge transfer in TiO2–Au nanocomplexes10.1088/2053-1591/1/4/045033 ↗
39. Effect of ultra-violet light irradiation on anodic oxide films on titanium in sulfuric acid solution10.1016/S0022-0728(99)00238-7 ↗
40. Light-induced amphi-philic surfaces
41. Surface defect (Ti3+) controlling in the first step on the anatase TiO2 nanocrystal by using sol–gel technique10.1016/j.apsusc.2008.08.051 ↗
42. Light-induced charge separation in anatase TiO2 particles10.1021/jp0404293 ↗
43. Correlation between surface morphology and hydrophilic/hydrophobic conversion of MOCVD-TiO2 Films10.1021/la9915567 ↗
44. Surface states at the TiO2/H2O interface under UV illumination10.1016/0009-2614(83)80691-5 ↗
45. The analysis of electrode impedances complicated by the presence of a constant phase element10.1016/S0022-0728(84)80324-1 ↗
46. Interfacial barrier layer properties of three generations of TiO2 nanotube arrays10.1016/j.electacta.2014.04.086 ↗
47. Surface oxygen vacancy induced photocatalytic performance enhancement of a BiPO4 nanorod10.1039/C3TA13841K ↗
48. Architecture, optical absorption, and photocurrent response of oxygen-deficient mixed-phase titania nanostructures10.1016/j.actamat.2012.08.030 ↗
49. Highly-ordered TiO2 nanotube arrays up to 220μm in length: use in water photoelectrolysis and dye-sensitized solar cells10.1088/0957-4484/18/6/065707 ↗
50. On seeding of the second layer in growth of double-layered TiO2 nanotube arrays10.1016/j.electacta.2013.06.047 ↗
51. Enhanced photocleavage of water using titania nanotube arrays10.1021/nl048301k ↗
52. Impact of the anodizing potential on the electron transport properties of Nb-doped TiO2 nanotubes10.1016/j.electacta.2015.04.070 ↗
53. Reduced TiO2 nanotube arrays for photoelectrochemical water splitting10.1039/c3ta10689f ↗
54. Photoelectrochemical water splitting with rutile TiO2 nanowires array: synergistic effect of hydrogen treatment and surfacemodification with anatase nanoparticles10.1016/j.electacta.2014.03.024 ↗
55. Enhancement of photoelectrochemical activity for water splitting by controlling hydrodynamic conditions on titanium anodization10.1016/j.jpowsour.2015.03.174 ↗
56. (Photo)electrochemical methods for the determination of the band edge positions of TiO2-based nanomaterials10.1155/2011/786759 ↗
57. Photoelectrochemical study of anodized TiO2 nanotubes prepared using low and high H2O contents10.1016/j.electacta.2015.10.162 ↗
58. Infrared spectroscopic studies of conduction band and trapped electrons in UV photoexcited, H-atom n-doped, and thermally reduced TiO210.1021/jp2053103 ↗
59. Photoelectronic processes in rutile10.1103/PhysRev.184.979 ↗
60. Nolan · Phys. Rev. B · 2008 · 77 · 23542410.1103/PhysRevB.77.235424 ↗
61. Synthesis and characterization of anatase-structured titania hollow spheres doped with erbium (III)10.1111/j.1551-2916.2012.05329.x ↗
62. Understanding TiO2 photocatalysis: mechanisms and materials10.1021/cr5001892 ↗
63. Structure and photoluminescence of the TiO2 films grown by atomic layer deposition using tetrakis-dimethylamino titanium and ozone10.1186/s11671-015-0790-x ↗
64. Effects of reduced chemical vapor deposition environment on growth and optical characteristics of TiO2 nanobelts10.1166/jnn.2012.4648 ↗
65. Nitrogen doped 3D titanium dioxide nanorods architecture with significantly enhanced visible light photoactivity10.1021/jp512622j ↗
66. An insight into the influence of morphology on the photoelectrochemical activity of TiO2 nanotube arrays10.1016/j.solmat.2014.09.005 ↗