Surface texturing of sputtered ZnO:Al/Ag back reflectors for flexible silicon thin-film solar cells
Source abstract
Abstract
Abstract Al-doped zinc oxide/silver (ZnO:Al/Ag) back reflectors for silicon thin-film solar cells with an n–i–p configuration were prepared on flexible stainless steel substrates by dc magnetron sputtering. The surface morphologies of the back reflectors were modified by changing the deposition temperature of the Ag films to improve the light-scattering properties on the back reflectors, resulting in the enhancement of the light-trapping effect in the solar cells. By elevating the deposition temperature from room temperature to 500 °C, the surface roughness of the Ag films increased from 6.62 to 46.64 nm. The films at 500 °C had coarse surface features with irregular grain size distributions between 200 and 900 nm, whereas the films produced at low temperatures below 100 °C had smooth surfaces consisting of small grains between 100 and 200 nm. Even after the 100-nm thick ZnO:Al films were deposited on the modified Ag surfaces, the surface microstructure of the ZnO:Al/Ag bilayers was similar to that of the Ag films. The surface roughness of bilayers increased from 7.12 to 39.30 nm with coarsening the Ag surfaces. Haze factor (a ratio of diffuse reflectance to total reflectance) of Ag films was enhanced remarkably from 59% to 74% in a wide wavelength range from 350 to 1100 nm with increasing the surface roughness of the Ag films from 6.62 nm to 46.64 nm. Enhancement in the haze factor was due to the increase of diffuse reflectance on the Ag films, because the total reflectance did not change much with increasing surface roughness of the Ag films. This increasing roughness indicated that the light scattering from the rough surface of the back reflectors improved. The enhanced light scattering from the back reflectors influenced the performance of the solar cells mainly in terms of the short-circuit current density ( J sc ). Compared to the back reflectors with smooth surface features, leading to a J sc value of 9.94 mA/cm 2 , the back reflectors with large surface roughness improved the J sc value of the solar cells to 13.36 mA/cm 2 without detrimental changes in the fill factor (FF) and open circuit voltage ( V oc ); they eventually increased the conversion efficiency of the solar cells from 5.59% to 7.60%.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Thin-Film Transistor Technologies · Silicon and Solar Cell Technologies · ZnO doping and properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (18)
Show source-provided references
1. Development of micromorph tandem solar cells on flexible low-cost plastic substrates10.1016/j.solmat.2008.10.018 ↗
2. Pagliaro · 2008
3. Fabrication of thin film silicon solar cells on plastic substrate by very high frequency PECVD10.1016/j.solmat.2010.01.013 ↗
4. Hydrogenated microcrystalline silicon single-junction and multi-junction solar cells10.1557/PROC-762-A4.1 ↗
5. Development of highly efficient thin film silicon solar cells on texture-etched zinc oxide-coated glass substrates10.1016/S0927-0248(00)00184-7 ↗
6. TCO and light trapping in silicon thin film solar cells10.1016/j.solener.2004.03.015 ↗
7. Texture etched ZnO:Al coated glass substrates for silicon based thin film solar cells10.1016/S0040-6090(99)00085-1 ↗
8. Absorption loss at nanorough silver back reflector of thin film silicon solar cells10.1063/1.1633652 ↗
9. Back surface reflectors with periodic textures fabricated by self-ordering process for light trapping in thin-film microcrystalline silicon solar cells10.1016/j.solmat.2008.12.030 ↗
10. Efficiency enhancement in Si solar cells by textured photonic crystal back reflector10.1063/1.2349845 ↗
11. A comparative study of photoconductivity and carrier transport in a-Si:H p–i–n solar cells with different back reflectors10.1016/j.sse.2009.09.008 ↗
12. Improvement in the efficiency of amorphous silicon solar cells utilizing the optical confinement effect by means of a TiO2/Ag/SUS back-surface reflector10.1016/0379-6787(84)90099-1 ↗
13. Thin-film silicon solar cells with efficient periodic light trapping texture10.1063/1.2768882 ↗
14. Microstructural evolution during film growth10.1116/1.1601610 ↗
15. Asymmetric intermediate reflector for tandem micromorph thin film silicon solar cells10.1063/1.3079414 ↗
16. ZnO:Al films prepared by rf magnetron sputtering applied as back reflectors in thin-film silicon solar cells10.1016/j.tsf.2008.05.009 ↗
17. Advances in microcrystalline silicon solar cell technologies
18. A.M.K. Dagamseh, B. Vet, P. Sutta, M. Zeman, Modeling and optimization of a-Si:H solar cells with ZnO:Al back reflector, Sol. Energy Mater. Sol. Cells 94 (2010) 2119–2123.10.1016/j.solmat.2010.06.039 ↗