Rapid thermal annealing on ZnMgO window layer for improved performance of CdTe solar cells
Source abstract
Abstract
Abstract Poor qualities of ZnMgO thin films are likely to be obtained at higher Mg content, which can decrease the performance of ZnMgO-based devices. This study focuses on improving the qualities of ZnMgO thin films to increase the performance of CdTe solar cell. It is found that the rapid thermal annealing (RTA) treatment increases the crystallinity, eliminates defects and improves the conductivity of ZnMgO thin films. These are helpful to suppress the recombination caused by bulk and interface defects as well as to reduce the cell's series resistance. The Fermi level moves close to conduction band and both the conduction and valence band energy shift lower relative to band energy of CdSSeTe film after RTA, which could not only increase the built-in voltage but also enhance the electron transport and block the hole recombination. As a result, the efficiency of CdTe solar cells is enhanced when using the RTA-treated ZnMgO, with maxium power conversion efficiency reaching values of 15.7%, which are much higher than those of the cells with the as-grown ZnMgO (11.6%). RTA is proved to be one of the excellent methods to control the properties of ZnMgO for improving the performance of CdTe solar cell.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Chalcogenide Semiconductor Thin Films · ZnO doping and properties · Quantum Dots Synthesis And Properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (27)
Show source-provided references
1. Polycrystalline CdTe photovoltaics with efficiency over 18% through improved absorber passivation and current collection10.1016/j.solmat.2017.11.031 ↗
2. 20% Efficient Zn0.9Mg0.1O: Al/ Zn0.8Mg0.2O/Cu(In,Ga)(S,Se)2 solar cell prepared by all-dry process through a combination of heat-light-soaking and light-soaking processes10.1021/acsami.8b01247 ↗
3. High-efficiency Cu(In,Ga)Se2 solar cells10.1016/j.tsf.2016.08.021 ↗
4. Band alignment of front contact layers for high-efficiency CdTe solar cells10.1016/j.solmat.2016.05.050 ↗
5. Performance improvement in Cd-free Cu(In,Ga)Se2solar cells by modifying the electronic structure of the ZnMgO buffer layer10.1039/C4RA07776H ↗
6. Ultrathin high band gap solar cells with improved efficiencies from the world's oldest photovoltaic material10.1038/s41467-017-00582-9 ↗
7. Effect of Mg content on structural, electrical and optical properties of Zn1−xMgxO nanocomposite thin films10.1016/j.solmat.2008.09.039 ↗
8. Tailoring of composition, band-gap, and structural phase in ZnMgO films by simply controlling growth temperature and oxygen partial pressure during sputter deposition10.1016/j.jallcom.2017.03.131 ↗
9. The origin of electrical property deterioration with increasing Mg concentration in ZnMgO:Ga10.1016/j.tsf.2011.12.020 ↗
10. Surface defects control for ZnO nanorods synthesized by quenching and their anti-recombination in photocatalysis10.1016/j.apsusc.2015.01.139 ↗
11. Highly sensitive and selective H2 sensing by ZnO nanofibers and the underlying sensing mechanism10.1016/j.jhazmat.2014.12.007 ↗
12. Effect of substrate temperature and oxygen partial pressure on structural and optical properties of Mg doped ZnO thin films10.1016/j.ceramint.2015.01.049 ↗
13. Influence of oxygen partial pressure on the crystal quality and optical properties of Mg-doped ZnO films
14. Co-deposition of band-gap tuned Zn1-xMgxO using high impulse power- and dc-magnetron sputtering10.1088/0022-3727/48/13/135301 ↗
15. Effects of sputtering power on the properties of Al-doped ZnO films deposited on amorphous silicon films substrate10.1016/j.spmi.2013.10.024 ↗
16. Preparation of Zn1−xMgxO films by radio frequency magnetron sputtering10.1016/S0040-6090(00)01009-9 ↗
17. G. Th, R.S. Von, S. Sadewasser, R. Klenk, W.A. Jäger, L.S.M. Ch, (Zn,Mg)O as window layer for Cd-free Chalcopyrite solar cells, in: Proceedings of the 17th European Photovoltaic Solar Energy Conference and Exhibition (EU PVSEC), 2001, pp. 1151–1154.
18. Gold Schottky contacts on oxygen plasma-treated, n-type ZnO(0001̄)10.1063/1.1536264 ↗
19. Understanding the light soaking effect of ZnMgO buffer in CIGS solar cells10.1039/C5CP01758K ↗
20. Effects of post-annealing temperature on structural, optical, and electrical properties of MgxZn1−xO films by RF magnetron sputtering10.1016/j.jcrysgro.2010.11.154 ↗
21. Postdeposition annealing of radio frequency magnetron sputtered ZnO films10.1116/1.580050 ↗
22. Photoemission studies on undoped SnO2 buffer layers for CdTe thin film solar cells10.1016/j.egypro.2011.10.168 ↗
23. Optical properties and electronic structure of amorphous Ge and Si10.1016/0025-5408(68)90023-8 ↗
24. Effect of annealing atmosphere on the electrical and optical properties of sol–gel derived Al doped Zn1−xMgxO thin film10.1016/j.tsf.2015.11.012 ↗
25. Review of progress toward 20% efficiency flexible CIGS solar cells and manufacturing issues of solar modules10.1109/JPHOTOV.2012.2226869 ↗
26. Obtaining large columnar CdTe grains and long lifetime on nanocrystalline CdSe, MgZnO, or CdS layers10.1002/aenm.201702666 ↗
27. Interface-barrier-induced J-V distortion of CIGS cells with sputtered-deposited Zn(S,O) window layers10.1109/JPHOTOV.2014.2301894 ↗