journal article·2018-08

A direct measurement of higher photovoltage at grain boundaries in CdS/ CZTSe solar cells using KPFM technique

Manoj Vishwakarma, Deepak Varandani, Christian Andres, Yaroslav E. Romanyuk, Stefan G. Haass, Ayodhya N. Tiwari, Bodh R. Mehta

Publisher page

Abstract

Abstract A direct mapping of photovoltage in a complete Mo/CZTSSe/CdS/ZnO/Al:ZnO solar cell device is carried out using Kelvin probe force microscopic (KPFM) measurements in surface and junction modes. Four cells having different values of open circuit voltage (VOC) have been studied, and nanoscale variation of photovoltage have been obtained from the difference of surface potential (SP) images in the two modes. The maps exhibit a higher photovoltage at grain boundaries in general. Observed SP image of pristine CZTSe layer reveals downward band bending resulting in reduction of carrier recombination, and thus, lower Jdark at grain boundaries (GB). The observed downward band bending resulting in low Jdark at GB in CZTSe layer is used to explain the increase in photovoltage (VOC) at the GB. KPFM measurements of CZTSe and CZTSe/CdS layers show that the surface potential of CZTSe layer and its variation can be affected by CdS deposition and further device processing, in addition to surface adsorption and contamination effects. The photovoltage mapping obtained from Kelvin probe force microscopic measurements on the final device without any interfering effects, is an important advantage of the present method.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Quantum Dots Synthesis And Properties · Chalcogenide Semiconductor Thin Films · Semiconductor materials and interfaces

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (29)

Show source-provided references
1. Comparative study of the luminescence and intrinsic point defects in the kesterite Cu2ZnSnS4 and chalcopyrite Cu(In,Ga)Se2 thin films used in photovoltaic applications10.1103/PhysRevB.84.165324 ↗
2. Nanoscale microstructure and chemistry of Cu2ZnSnS4/CdS interface in kesterite Cu2ZnSnS4 solar cells10.1002/aenm.201600706 ↗
3. Locating the electrical junctions in Cu(In,Ga)Se2 and Cu2ZnSnSe4 solar cells by scanning capacitance spectroscopy10.1002/pip.2805 ↗
4. The impact of charged grain boundaries on CdTe Solar cell: EBIC measurements not predictive of device performance10.1109/JPHOTOV.2016.2631298 ↗
5. R. Akis, D. Brinkman, D. Guo, D. Vasileska, C. Ringhofer, A 2D diffusion-reaction CdTe solar cell simulator that includes active defects and grain boundaries, Photovoltaic Specialists Conference, 2016.10.1109/PVSC.2016.7750009 ↗
6. Effect of the KF post-deposition treatment on grain boundary properties in Cu(In, Ga)Se2 thin films10.1038/srep41361 ↗
7. How grain boundaries in Cu(In,Ga)Se2 thin films are charged: revisit10.1063/1.4737406 ↗
8. Potassium-induced surface modification of Cu(In,Ga)Se2 thin films for high-efficiency solar cells10.1038/nmat3789 ↗
9. Investigation of sodium distribution in Cu2ZnSnS4 thin films and its effects on the performance of the solar cells10.1016/j.materresbull.2016.08.003 ↗
10. Strategic review of secondary phases, defects and defect-complexes in kesterite CZTS–Se solar cells10.1039/C5EE02153G ↗
11. Practical limitations to selenium annealing of compound co-sputtered Cu2ZnSnS4 as a route to achieving sulfur-selenium graded solar cell absorbers10.1016/j.tsf.2016.12.044 ↗
12. Study of charge separation and interface formation in a single nanorod CdS–CuxS heterojunction solar cell using Kelvin probe force microscopy10.1088/0957-4484/24/25/255703 ↗
13. Effects of the compositional ratio distribution with sulfurization temperatures in the absorber layer on the defect and surface electrical characteristics of Cu2ZnSnS4 solar cells10.1002/pip.2619 ↗
14. Improved photovoltaic and grain boundary characteristics of single elementary target-sputtered Cu2ZnSnS4 thin films by post sulfurization/selenization process10.1088/0022-3727/48/24/245103 ↗
15. Lithium-doping inverts the nanoscale electric field at the grain boundaries in Cu2ZnSn(S,Se)4 and increase photovoltaic efficiency10.1039/C5CP04707B ↗
16. Electrical characterization of grain boundaries of CZTS thin films using conductive atomic force microscopy techniques10.1016/j.materresbull.2015.05.002 ↗
17. Nanoimaging of open-circuit voltage in photovoltaic devices10.1002/aenm.201501142 ↗
18. Nanoscale interface formation and charge transfer in graphene/silicon Schottky junctions; KPFM and CAFM studies10.1016/j.carbon.2015.10.075 ↗
19. 9.4% efficient Cu2ZnSnSe4 solar cells from co-sputtered elemental metal precursor and rapid thermal annealing10.1016/j.tsf.2016.09.048 ↗
20. 11.2% Efficient solution processed kesterite solar cell with a low voltage deficit10.1002/aenm.201500712 ↗
21. Potential distribution of Cu(In,Ga)(S,Se)2 solar cell cross-sections measured by Kelvin probe force microscopy10.1016/j.tsf.2004.11.065 ↗
22. Elucidating the charge carrier transport and extraction in planar heterojunction perovskite solar cells by Kelvin probe force microscopy10.1039/C6TA05350E ↗
23. Relationship between diode saturation current and open circuit voltage in Poly(3-alkylthiophene) solar cells as a function of device architecture, processing conditions, and alkyl side chain length10.1021/jp2070612 ↗
24. Investigating the role of grain boundaries in CZTS and CZTSSe thin film solar cells with scanning probe microscopy10.1002/adma.201103470 ↗
25. Kesterites—a challenging material for solar cells10.1002/pip.2156 ↗
26. Radiative efficiency limits of solar cells with lateral band-gap fluctuations10.1063/1.1737071 ↗
27. Classification of lattice defects in the kesterite Cu2ZnSnS4 and Cu2ZnSnSe4 earth-abundant solar cell absorbers10.1002/adma.201203146 ↗
28. Abundance of CuZn + SnZn and 2CuZn + SnZn defect clusters in kesterite solar cells10.1063/1.4768215 ↗
29. Band alignment at the Cu2ZnSn(SxSe1−x)4/CdS interface10.1063/1.3600776 ↗