journal article·2019-03

Experimental study on thermophysical properties of molten salt nanofluids prepared by high-temperature melting

Xia Chen, Yu-ting Wu, Lu-di Zhang, Xin Wang, Chong-fang Ma

Publisher page

Abstract

Abstract Heat storage is a key technology in solar thermal power, helps solar thermal power eliminate the instability in energy supply for the grid, and provides continuous and stable high-quality electrical energy to improve power system efficiency and extend system life. Molten salt is an important material for heat storage and heat transfer in solar thermal power. In recent years, nanofluid technology has been applied to investigate heat storage and transfer materials, such as molten salt, to improve heat capacity. However, the nanofluid technology is hampered by the easy agglomeration of nanoparticles in molten salts, and this phenomenon degrades the performance of the molten salt nanofluids. To reduce or prevent agglomeration, a two-step method with high-temperature melting in preparing molten salt nanofluids is developed recently. Molten salt nanofluids obtained by high-temperature melting show good stability and long time to agglomerate. This paper presented the study on the thermophysical properties of molten salt nanofluids prepared by high-temperature melting method. The molten salt nanofluids possessed low-melting point salt as base liquid and SiO2 with a diameter of 20 nm as nanoparticles. The specific heat of this type of molten salt nanofluid was tested, and the optimum concentration of nanoparticles was determined. Results showed that the specific heat capacities of the molten salt nanofluid samples with different mass fractions of nanoparticles were higher than those of pure molten salt. The average specific heat of molten salt nanofluid with a mass fraction of 0.5% was the highest at 1.950 J/(g K), which was 24.5% more than that of pure molten salt. The thermophysical properties of molten salt nanofluids with a mass fraction of 0.5% and prepared by high-temperature melting were experimentally tested and compared with those of pure molten salt. These properties included melting point, primary crystallization point, thermal conductivity, viscosity, latent heat, and density. The molten salt nanofluids showed good performance for heat storage and transfer.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Nanofluid Flow and Heat Transfer · Phase Change Materials Research · Solar Thermal and Photovoltaic Systems

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (27)

Show source-provided references
1. Transient molten salt two-tank thermal storage modeling for CSP performance simulations10.1016/j.solener.2013.02.034 ↗
2. CFD-simulation of a new receiver design for a molten salt solar power tower10.1016/j.solener.2012.12.007 ↗
3. Survey of thermal energy storage for parabolic trough power plants10.1115/1.1467601 ↗
4. Engineering aspects of a molten salt heat transfer fluid in a trough solar field10.1016/S0360-5442(03)00191-9 ↗
5. Stability of glycol nanofluids - the theory and experiment10.1016/j.powtec.2013.01.039 ↗
6. Phase transfer based synthesis and thermophysical properties of Au/Therminol VP-1 nanofluids10.1016/j.pnsc.2013.04.006 ↗
7. A review on how the researchers prepare their nanofluids10.1016/j.ijthermalsci.2013.08.010 ↗
8. A review on preparation methods and challenges of nanofluids10.1016/j.icheatmasstransfer.2014.03.002 ↗
9. Bharath · 2013
10. Ramaprasath · 2013
11. Optimal concentration of alumina nanoparticles in molten Hitec salt to maximize its specific heat capacity10.1016/j.ijheatmasstransfer.2013.10.078 ↗
12. Enhanced specific heat capacity of high-temperature molten salt-based nanofluids10.1016/j.ijheatmasstransfer.2012.10.062 ↗
13. Experimental study on optimized composition of mixed carbonate salt for sensible heat storage in solar thermal power plant10.1016/j.solener.2011.05.004 ↗
14. Preparation and thermal properties of quaternary mixed nitrate with low melting point10.1016/j.solmat.2014.03.056 ↗
15. Recent progress in solar thermal energy storage using nanomaterials10.1016/j.rser.2016.09.034 ↗
16. An investigation into the thermophysical and rheological properties of nanofluids for solar thermal applications10.1016/j.rser.2015.10.065 ↗
17. Chen · 2001
18. Xia Chen, Yuting Wu, Ludi Zhang, et al., Experimental study on the specific heat and stability of molten salt nanofluids prepared by high-temperature melting, Solar Energy Materials and Solar Cells. Accepted. DOI: 10.1016/j.solmat.2017.11.021.10.1016/j.solmat.2017.11.021 ↗
19. Preparation and thermal properties of quaternary mixed nitrate with low melting point10.1016/j.solmat.2014.03.056 ↗
20. D.M. Blake, L. Moens, M.J. Hale, et al., New heat transfer and storage fluids for parabolic trough solar thermal electric plants, in: Proceedings of the 11th Solar PACES International Symposium On concentrating Solar Power and Chemical Energy Technologies, Zurich, Switzerland, September 4–6, 2002.
21. Surface and size effects on the specific heat capacity of nanoparticles10.1007/s10765-006-0022-9 ↗
22. Cai · 1999
23. Viscosity of potassium nitrate-sodium nitrite-sodium nitrate mixtures10.1021/je00028a014 ↗
24. Heat transfer fluids and systems for process and energy applications10.1016/0142-727X(86)90064-0 ↗
25. Ren · 2015
26. L.L.C. Coastal Chemical Co · 2002 · 1
27. Importance of accurate on viscosity and thermal conductivity in molten salts applications10.1021/je020160l ↗