journal article·2016-01

Combining strong interface recombination with bandgap narrowing and short diffusion length in Cu2ZnSnS4 device modeling

C. Frisk, T. Ericson, S.-Y. Li, P. Szaniawski, J. Olsson, C. Platzer-Björkman

Publisher page

Abstract

In this work we establish a device model in SCAPS, incorporating bandgap narrowing, short minority carrier diffusion length and interface recombination. The model is based on a reference device with standard structure; sputtered Mo on soda lime glass, a reactively sputtered and annealed Cu 2ZnSnS 4 (CZTS) absorber layer, chemical bath deposited CdS and sputtered i-ZnO buffer layers, and front contact formed with sputtered ZnO:Al and an evaporated Ni/Al/Ni grid. The efficiency of the reference device is 6.7%. Model parameter values of the absorber layer are based on the analysis of temperature dependent current–voltage ( J– V– T) measurements, capacitance–voltage ( C– V ) and drive-level capacitance profiling (DLCP) measurements, performed on the reference device, and on the comparison of simulated and measured quantum efficiency (QE) and current–voltage ( J– V) performance. Additional parameters are taken from literature. The key elements, electron–hole pair generation and recombination in the absorber layer, are the main focus in this study. Reported values of the absorption coefficient of CZTS vary around one order of magnitude when comparing data from reflectance–transmission ( R– T ) measurements with ellipsometry measurements, and calculations. Therefore, a modified semi-empirical absorption coefficient, extracted from R– T and QE measurements, with the depletion width from CV and DLCP, is presented and used in this study. The dominating recombination path is evaluated with J– V– T analysis and the zero Kelvin activation energy ( E A , 0 ) is extracted from both temperature dependent open circuit voltage ( V OC ) and from modified Arrhenius plots. In each case, E A , 0 is found to be substantially smaller than the bandgap energy, even when considering bandgap narrowing due to disorder, which is an indication that the V OC deficit observed in our CZTS device dominated by interface recombination. Finally, a complete device model is established, with J– V and QE simulations in good agreement with corresponding measurements, where the interface has the biggest impact on the V OC deficit, but with clear contribution from bulk recombination, with minority carrier diffusion length 250 nm, and from bandgap narrowing, giving a lower than nominal bandgap energy of 1.35 eV.
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Copper-based nanomaterials and applications

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (32)

Show source-provided references
1. Technology Roadmap: Solar Photovoltaic Energy – 2014 edition.
2. Zn(O,S) buffer layers and thickness variations of CdS buffer for Cu2ZnSnS4 solar cells10.1109/JPHOTOV.2013.2283058 ↗
3. The state and future prospects of kesterite photovoltaics10.1039/c3ee41781f ↗
4. Loss mechanisms in hydrazine-processed Cu2ZnSn(Se,S)4 solar cells10.1063/1.3522884 ↗
5. Semi-empirical device model for Cu2ZnSn(S,Se)4 solar cells10.1063/1.4890844 ↗
6. Cliff-like conduction band offset and KCN-induced recombination barrier enhancement at the CdS/Cu2ZnSnS4 thin-film solar cell heterojunction10.1063/1.3663327 ↗
7. Optical constants of Cu2ZnSnS4 bulk crystals
8. Study of optical and structural properties of Cu2ZnSnS4 thin films10.1016/j.tsf.2010.12.105 ↗
9. Electronic and optical properties of Cu2ZnSnS4 and Cu2ZnSnSe410.1063/1.3318468 ↗
10. Modelling polycrystalline semiconductor solar cells10.1016/S0040-6090(99)00825-1 ↗
11. Electronic properties of Cu(In,Ga)Se2 heterojunction solar cells-recent achievements, current understanding, and future challenges10.1007/s003390050984 ↗
12. Generalized current–voltage analysis and efficiency limitations in non-ideal solar cells: case of Cu2ZnSn(SxSe1−x)4 and Cu2Zn(SnyGe1−y)(SxSe1−x)410.1063/1.4882119 ↗
13. Temperature dependence of energy gap in semiconductors10.1016/0031-8914(67)90062-6 ↗
14. Activation energy of heterojunction diode currents in the limit of interface recombination10.1063/1.3126523 ↗
15. Diode quality factor determination for thin-film solar-cells10.1016/0379-6787(89)90050-1 ↗
16. Thin-film solar cells: device measurements and analysis10.1002/pip.518 ↗
17. Influence of deep traps on measurement of free-carrier distributions in semiconductors by junction capacitance techniques10.1063/1.1663500 ↗
18. Drive-level capacitance profiling – its application to determining gap state densities in hydrogenated amorphous-silicon films10.1063/1.96129 ↗
19. Orgassa · 2004
20. Green · 1982
21. Minority carrier diffusion length extraction in Cu2ZnSn(Se, S)4 solar cells10.1063/1.4821841 ↗
22. Optimizing Ga-profiles for highly efficient Cu(In,Ga)Se2 thin film solar cells in simple and complex defect models10.1088/0022-3727/47/48/485104 ↗
23. Preparation of Cu2ZnSnS4 thin films by hybrid sputtering10.1016/j.jpcs.2005.09.037 ↗
24. Growth of CZTS thin films by cosputtering of metal targets and sulfurization in H2S
25. J.J.S. Scragg, J.K. Larsen, M. Kumar, C. Persson, J. Sendler, S. Siebentritt, C. Platzer-Björkman, Cu–Zn disorder and band gap fluctuations in Cu2ZnSnS4, Unpublished results.
26. Band gap change induced by defect complexes in Cu2ZnSnS410.1016/j.tsf.2012.10.030 ↗
27. Electronic properties of the Cu2ZnSn(Se,S)4 absorber layer in solar cells as revealed by admittance spectroscopy and related methods10.1063/1.4729751 ↗
28. First-principles study on the effective masses of zinc-blend-derived Cu2Zn–IV–VI4 (IV=Sn, Ge, Si and VI=S, Se)10.1063/1.4759322 ↗
29. Radiative efficiency limits of solar cells with lateral band-gap fluctuations10.1063/1.1737071 ↗
30. Band tailing and efficiency limitation in kesterite solar cells10.1063/1.4820250 ↗
31. Development of rear surface passivated Cu(In,Ga)Se2 thin film solar cells with nano-sized local rear point contacts10.1016/j.solmat.2013.07.025 ↗
32. Influence of C2ZnSnS4 absorber thickness on thin film solar cells