Effect of gallium grading in Cu(In,Ga)Se2 solar-cell absorbers produced by multi-stage coevaporation
Source abstract
Abstract
We investigate Cu(In,Ga)Se2 thin films grown in multi-stage coevaporation processes and solar cells fabricated from such absorbers. Despite some interdiffusion during film growth, Ga/(Ga+In) gradients defined via evaporation-profile variations in the process are to a good part retained in the finished film. This indicates that the bandgap can be engineered in this type of process by varying the evaporation profiles, and consequently also that unintended profile variations should be noted and avoided. With front-side gradients the topmost part of many grains seems to be affected by a higher density of lattice defects due to the strong change of gallium content under copper-poor growth conditions. Electrically, both back-side gradients and moderate front-side gradients are shown to yield an improvement of device efficiency. If a front-side gradient is too wide, though, it causes strong voltage-dependent collection and the fill factor is severely reduced.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Semiconductor materials and interfaces
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (17)
Show source-provided references
1. 19.9%-efficient ZnO/CdS/CuInGaSe2 solar cell with 8.12% fill factor10.1002/pip.822 ↗
2. Highly efficient CIS solar cells and modules made by the co-evaporation process10.1016/j.tsf.2008.10.126 ↗
3. M.A. Contreras, J.R. Tuttle, A.M. Gabor, A.L. Tennant, K. Ramanathan, S.E. Asher, A. Franz, J.C. Keane, L. Wang, J. Scofield, R. Noufi, High efficiency Cu(ln,Ga)Se2-based soar cells: processing of novel absorber structures, in: Conference Record of the 24th IEEE Photovoltaic Specialist Conference, 1994, pp. 68–75. URL 〈http://www.oberlin.edu/physics/Scofield/pdf_files/pvsc-95h.pdf〉.10.1109/WCPEC.1994.519811 ↗
4. Band-gap engineering in Cu(In,Ga)Se2 thin films grown from (In,Ga)2Se3 precursors10.1016/0927-0248(95)00122-0 ↗
5. Cu(In,Ga)Se2 solar cells
6. A. Dhingra, A. Rothwarf, Computer simulation and modeling of the graded bandgap CuInSe2/CdS solar cell, in: Conference Record of the 23rd IEEE Photovoltaic Specialists Conference, 1993, pp. 475–480. doi:10.1109/pvsc.1993.347135.10.1109/PVSC.1993.347135 ↗
7. Green · 1998
8. Back surface band gap gradings in Cu(In,Ga)Se2 solar cells10.1016/S0040-6090(00)01726-0 ↗
9. Photogeneration and carrier recombination in graded gap Cu(In,Ga)Se2 solar cells10.1109/16.887004 ↗
10. Band-gap grading in Cu(In,Ga)Se2 solar cells10.1016/j.jpcs.2005.09.087 ↗
11. Baseline Cu(In,Ga)Se2 device production: control and statistical significance10.1016/S0927-0248(00)00264-6 ↗
12. Two-stage growth of smooth Cu(In,Ga)Se2 films using end-point detection10.1016/j.tsf.2004.11.076 ↗
13. Cascade mixing in AlxGa1−xAs/GaAs during sputter profiling by noble-gas ions10.1103/PhysRevB.60.14302 ↗
14. CuIn1−xGaxSe2 photovoltaic devices for tandem solar cell application10.1016/j.tsf.2008.11.038 ↗
15. Chalcopyrite/defect chalcopyrite heterojunctions on the basis of CuInSe210.1063/1.353020 ↗
16. Microstructure of surface layers in Cu(In,Ga)Se2 thin films10.1063/1.1498499 ↗
17. Electronic properties of Cu(In,Ga)Se2 thin-film solar cells—an update10.1007/978-3-540-39970-4_3 ↗