journal article·2019-04

Damage to passivation contact in silicon heterojunction solar cells by ITO sputtering under various plasma excitation modes

Anh Huy Tuan Le, Vinh Ai Dao, Duy Phong Pham, Sangho Kim, Subhajit Dutta, Cam Phu Thi Nguyen, Youngseok Lee, Youngkuk Kim, Junsin Yi

Publisher page

Abstract

Abstract Analysis of damage to passivation contact in heterojunction with intrinsic thin layer (HIT) solar cells by indium tin oxide (ITO) sputtering under various plasma excitation modes such as radio frequency (RF), direct current (DC), RF-superimposed DC, pulsed DC is presented. A significant degradation of effective minority carrier lifetime of the precursor cells at both low and high-level injections after the ITO deposition by sputtering technique was observed regardless of plasma excitation modes. We found that the main reason for this degradation was mainly due to the ion flux in the sputtering plasma rather than the ion kinetic energy. On the basis of the experimental and simulated results, we attributed the degradation of surface passivation quality mainly to the damage of the amorphous-silicon/crystalline-silicon interfaces rather than that of the intrinsic hydrogenated amorphous silicon layers. This degradation could be significantly reduced by the ITO deposition at a high temperature in which a trade-off between degradation and curing step was expected to occur. The cell performance of the HIT solar cells using the ITO films deposited by various plasma excitation modes at 180 °C was subsequently discussed. The ITO films deposited by the RF-superimposed DC mode exhibited a high potential as excellent opto-electrical properties and free sputter-induced damage electrodes for HIT solar cell applications. To our best knowledge, this is the first time that the ITO films deposited by the RF-superimpose DC mode are used as electrodes in the HIT solar cells.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Silicon and Solar Cell Technologies · Thin-Film Transistor Technologies · Semiconductor materials and interfaces

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (24)

Show source-provided references
1. Material challenges for solar cells in the twenty-first century: directions in emerging technologies10.1080/14686996.2018.1433439 ↗
2. Effective optimization of indium tin oxide films by a statistical approach for shallow emitter based crystalline silicon solar cell applications10.1016/j.solmat.2014.03.011 ↗
3. 24·5% Efficiency silicon PERT cells on MCZ substrates and 24·7% efficiency PERL cells on FZ substrates10.1002/(SICI)1099-159X(199911/12)7:6<471::AID-PIP298>3.0.CO;2-7 ↗
4. Achievement of more than 25% conversion efficiency with crystalline silicon heterojunction solar cell10.1109/JPHOTOV.2014.2352151 ↗
5. Silicon heterojunction solar cell with interdigitated back contacts for a photoconversion efficiency over 26%10.1038/nenergy.2017.32 ↗
6. A statistical approach for the optimization of indium tin oxide films used as a front contact in amorphous/crystalline silicon heterojunction solar cells10.1016/j.enconman.2014.07.021 ↗
7. Silicon heterojunction solar cells with novel fluorinated n-type nanocrystalline silicon oxide emitters on p-type crystalline silicon10.7567/JJAP.54.08KD03 ↗
8. Damage at hydrogenated amorphous/crystalline silicon interfaces by indium tin oxide overlayer sputtering10.1063/1.4764529 ↗
9. Influence of the transparent conductive oxide layer deposition step on electrical properties of silicon heterojunction solar cells10.1063/1.4804985 ↗
10. B.-.M. Meiners, S. Holinski, P. Schäfer, S. Hohage, D. Borchert, Sputter damage to amorphous silicon layers for heterojunction solar cells, in: Proceedings of the 31st European PV Solar Energy Conference and Exhibition (EU PVSEC. 2015), Hamburg, Germany, 2015.
11. Comparative study of amorphous indium tin oxide prepared by pulsed-DC and unbalanced RF magnetron sputtering at low power and low temperature conditions for heterojunction silicon wafer solar cell applications10.1016/j.vacuum.2015.04.032 ↗
12. Sanden, Effect of ion bombardment on the a-Si:H based surface passivation of c-Si surfaces10.1063/1.3601485 ↗
13. Processed optimization for excellent interface passivation quality of amorphous/crystalline silicon solar cells10.1016/j.solmat.2013.05.042 ↗
14. Characterization of a RF/dc-magnetron discharge for the sputter deposition of transparent and highly conductive ITO films10.1007/s003390051021 ↗
15. Al-doped zinc oxide films deposited by simultaneous rf and dc excitation of a magnetron plasma: relationships between plasma parameters and structural and electrical film properties10.1063/1.366798 ↗
16. Recovery of indium-tin-oxide/silicon heterojunction solar cells by thermal annealing10.1016/j.egypro.2013.12.002 ↗
17. D. Skorka, N. Brinkmann, A. Gorgulla, G. Hahn, B. Terheiden, Changes in passivation quality of PECV-deposited hydrogenated amorphous silicon layers used in solar cells due to sputter deposition of TCOs, in: 28th European Photovoltaic Solar Energy Conference and Exhibition, 2013, pp. 1162–1165.
18. i Cabarrocas, In situ photoluminescence study of plasma-induced damage at the a-Si: h/c-si interface10.1063/1.4941298 ↗
19. Transparent electrodes in silicon heterojunction solar cells: influence on contact passivation10.1109/JPHOTOV.2015.2484962 ↗
20. Investigation of selective junctions using a newly developed tunnel current model for solar cell applications10.1016/j.solmat.2015.05.014 ↗
21. The defect density in amorphous silicon10.1080/13642818908205926 ↗
22. Bahardoust · 2006 · 1187
23. Characterization of interface states in a-Si: h/c-si heterojunctions by an expression of the theoretical diffusion capacitance10.1088/0022-3727/43/49/495102 ↗
24. Anomalous optical absorption limit in InSb10.1103/PhysRev.93.632 ↗