ITO/SiOx:H stacks for silicon heterojunction solar cells
Source abstract
Abstract
Abstract A method of reducing optical losses in the transparent conductive oxides (TCO) used in silicon heterojunction solar cells without compromising with series resistance is described. In the method the thickness of a TCO is reduced two-three times and a hydrogenated dielectric is deposited on top to form a double layer antireflection coating. The conductivity of a thin TCO is increased due to the effect of hydrogen treatment supplied from the capping dielectric during the post deposition annealing. The optimized cells with ITO/SiOx:H stacks achieved more than 41 mA/cm2 generation current on 120-micron-thick wafers while having approximately 100 Ω/square sheet resistance. The paper also considers integration of ITO/SiOx:H stacks with Cu plating and using ITO/SiNx/SiOx triple layer antireflection coatings.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Silicon and Solar Cell Technologies · Thin-Film Transistor Technologies · Silicon Nanostructures and Photoluminescence
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (15)
Show source-provided references
1. High-efficiency silicon heterojunction solar cells: a review10.1515/green-2011-0018 ↗
2. Current losses at the front of silicon heterojunction solar cells10.1109/JPHOTOV.2011.2174967 ↗
3. Infrared light management in high-efficiency silicon heterojunction and rear-passivated solar cells10.1063/1.4772975 ↗
4. Numerical analysis of electrical TCO / a-Si:H(p) contact properties for silicon heterojunction solar cells10.1016/j.egypro.2013.07.330 ↗
5. Damage at hydrogenated amorphous/crystalline silicon interfaces by indium tin oxide overlayer sputtering10.1063/1.4764529 ↗
6. Transparent electrodes in silicon heterojunction solar cells: influence on contact passivation10.1109/JPHOTOV.2015.2484962 ↗
7. Design and fabrication of a SiOx/ITO double-layer anti-reflective coating for heterojunction silicon solar cells10.1016/j.solmat.2013.05.044 ↗
8. Hydrogen doping of indium tin oxide due to thermal treatment of hetero-junction solar cells10.1016/j.tsf.2015.12.027 ↗
9. Hydrogen-doped indium oxide/indium tin oxide bilayers for high-efficiency silicon heterojunction solar cells10.1016/j.solmat.2013.03.024 ↗
10. Cerium oxide and hydrogen co-doped indium oxide films for high-efficiency silicon heterojunction solar cells10.1016/j.solmat.2016.01.005 ↗
11. S. Herasimenka, B. Dauksher, C. Tracy, K. Ghosh, V. Sharma, M. Bailly, S. Bowden, Surface preparation and optimization of amorphous silicon deposition for silicon heterojunction solar cells, in: Proceedings of the 28th European Photovoltaic Solar Energy Conference, 2013, pp. 1943–1946
12. S.Y. Herasimenka, W.J. Dauksher, C.J. Tracy, J. Lee, A. Augusto, H. Jain, K. Tyler, Z. Kiefer, P. Balaji, S. Bowden, C. Honsberg, Front- and rear-emitter screen printed silicon heterojunction solar cells with >20% efficiency, in: Proceedings of the 31st European Photovoltaic Solar Energy Conference, 2015, pp. 761–764.
13. Characterization and comparison of silicon nitride films deposited using two novel processes10.1116/1.3687423 ↗
14. K.R. McIntosh, S.C. Baker-Finch, OPAL 2: rapid optical simulation of silicon solar cells, in: Proceedings of the 38th IEEE Photovoltaic Specialists Conference (PVSC), 2012, pp. 000265–000271. 〈http://dx.doi.org/10.1109/PVSC.2012.6317616〉10.1109/PVSC.2012.6317616 ↗
15. Silicon heterojunction rear emitter solar cells: Less restrictions on the optoelectrical properties of front side TCOs10.1016/j.solmat.2013.11.029 ↗