Strength recovery of thermally damaged high-performance concrete subjected to post-fire carbonation curing
Source abstract
Abstract
This study investigates the efficacy of post-fire curing using carbonation with a 20% carbon dioxide concentration and a relative humidity cycle set between 40% and 90% for restoring the mechanical properties of thermally damaged high-performance concrete (HPC) specimens containing 0%–40% silica fume. The HPC specimens were exposed to temperatures of 600, 800, and 1000 °C for 1 h, and the compressive strength recovery was measured. The microstructure, porosity, pore size distribution, and chemical composition of the HPC specimens were analyzed to explore the strength recovery mechanism. After exposure to elevated temperatures, the average compressive strength of samples without silica fume decreased by 49.2 MPa. Subsequent carbonation recuring resulted in a significant recovery of 73.9 MPa in the average compressive strength. This recovery surpassed the original strength for the samples heated to 600 and 800 °C, attributable to the filling and coalescing effects of calcium carbonate polymorphs formed through the carbonation of residual cement particles and β-C2S. The samples containing 20% silica fume exhibited the second highest average strength recovery of 34.1 MPa. However, the strength recovery for the samples with 40% silica fume exposed to 800 and 1000 °C was negligible, as the microcracks exceeding 1 μm in width had barely been restored by the carbonation of the low-calcium calcium silicates with low reactivity. Overall, this study presents an exciting future prospect for the labor and cost-effective restoration of thermally damaged concrete structures through the use of carbonation curing.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Fire effects on concrete materials · Concrete and Cement Materials Research · Concrete Properties and Behavior
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (72)
Show source-provided references
1. Bažant · 1996
2. Deterioration and recovery of FRC after high temperature exposure10.1016/j.cemconcomp.2018.07.020 ↗
3. Concrete at high temperatures—a general review10.1016/0379-7112(88)90033-1 ↗
4. Effects of cement dosage and cooling regimes on the compressive strength of concrete after post-fire-curing from 800 °C10.1016/j.conbuildmat.2017.03.053 ↗
5. Physicochemical and mechanical changes of thermally damaged cement pastes and concrete for re-curing conditions10.1016/j.cemconres.2019.105831 ↗
6. Mechanical properties of concrete at high temperature—a review10.1016/j.conbuildmat.2015.05.131 ↗
7. Effects of post-fire curing conditions on the restoration of material properties of fire-damaged concrete10.1016/j.conbuildmat.2015.09.015 ↗
8. Deterioration and recovery of metakaolin blended concrete subjected to high temperature10.1023/A:1021775110075 ↗
9. Comparison of the strength and durability performance of normal-and high-strength pozzolanic concretes at elevated temperatures10.1016/S0008-8846(01)00580-4 ↗
10. Assessment and repair of fire-damaged concrete structures-an update
11. Allen · 1992
12. Repair of fire damaged circular reinforced concrete columns with FRP composites10.1016/j.conbuildmat.2010.06.017 ↗
13. Strengthening fire-damaged concrete by confinement with fibre-reinforced polymer wraps10.1016/j.engstruct.2011.07.002 ↗
14. Structural Rehabilitations with Ultra-High Performance Fibre Reinforced Concretes (UHPFRC)/Strukturelle Instandsetzung von Betonbrücken mit Ultra-hochleistungsfähigem Faserfeinkornbeton (UHFB)
15. Strength and durability recovery of fire-damaged concrete after post-fire-curing10.1016/S0008-8846(01)00582-8 ↗
16. Microstructures of fire-damaged concrete
17. Analysis of the effect of heating and re-curing on the microstructure of high-strength concrete using X-ray CT10.1016/j.conbuildmat.2013.11.007 ↗
18. The effect of post-fire-curing on strength–velocity relationship for nondestructive assessment of fire-damaged concrete strength10.1016/j.firesaf.2011.01.006 ↗
19. Rehydration activity of hydrated cement paste exposed to high temperature10.1002/fam.1067 ↗
20. Effects of geometry and fraction of polypropylene fibers on permeability of ultra-high performance concrete after heat exposure10.1016/j.cemconres.2018.11.009 ↗
21. Influence of aggregate size and inclusion of polypropylene and steel fibers on the hot permeability of ultra-high performance concrete (UHPC) at elevated temperature10.1016/j.conbuildmat.2018.01.105 ↗
22. Microscopic features of non-hydraulic calcium silicate cement paste and mortar10.1016/j.cemconres.2017.07.001 ↗
23. Changes in mineral composition, growth of calcite crystal, and promotion of physico-chemical properties induced by carbonation of β-C2S10.1016/j.jcou.2019.06.005 ↗
24. Reactivity and strength development of CO2 activated non-hydraulic calcium silicates10.1016/0008-8846(79)90095-4 ↗
25. Microstructural densification and CO2 uptake promoted by the carbonation curing of belite-rich Portland cement10.1016/j.cemconres.2016.01.001 ↗
26. Carbonation of cement paste: understanding, challenges, and opportunities10.1016/j.conbuildmat.2016.04.138 ↗
27. Modelling of carbonation, de-carbonation and re-carbonation processes of structural concrete subjected to high temperature heating10.1016/j.cemconcomp.2022.104493 ↗
28. Effect of further water curing on compressive strength and microstructure of CO2-cured concrete10.1016/j.cemconcomp.2016.05.026 ↗
29. Mater · 2011
30. Investigation of the structure of heated Portland cement paste by using various techniques10.1016/j.conbuildmat.2012.09.071 ↗
31. Odler · 1998
32. Influence of water-cement ratio and cement content on the properties of polymer-modified mortars10.1016/S0008-8846(99)00060-5 ↗
33. Effects of heating followed by water quenching on strength and microstructure of ultra-high performance concrete10.1016/j.conbuildmat.2019.02.123 ↗
34. Heat deformations of cement paste phases and the microstructure of cement paste10.1007/BF02473981 ↗
35. Effect of elevated temperature on physico-mechanical properties of blended cement concrete10.1016/j.conbuildmat.2010.06.078 ↗
36. Thermal induced stress and associated cracking in cement-based composite at elevated temperatures––Part I: thermal cracking around single inclusion10.1016/S0958-9465(03)00086-6 ↗
37. Thermo-mechanical assessment of concrete microcracking damage due to early-age temperature rise10.1016/j.conbuildmat.2014.12.126 ↗
38. Effect of high temperatures on high performance steel fibre reinforced concrete10.1016/j.cemconres.2006.03.024 ↗
39. Hewlett · 2019
40. Effect of post-fire curing and silica fume on permeability of ultra-high performance concrete10.1016/j.conbuildmat.2021.123175 ↗
41. The use of rice husk ash as reactive filler in ultra-high performance concrete10.1016/j.cemconres.2018.09.004 ↗
42. A time-dependent chloride diffusion model for predicting initial corrosion time of reinforced concrete with slag addition10.1016/j.cemconres.2021.106455 ↗
43. Effect of alkali cation type on strength endurance of fly ash geopolymers subject to high temperature exposure10.1016/j.matdes.2018.05.023 ↗
44. Permeability and pore structure evolution of silicocalcareous and hematite high-strength concretes submitted to high temperatures10.1007/BF02482129 ↗
45. Thermal stability and decomposition mechanisms of ettringite at < 120 °C10.1016/S0008-8846(01)00558-0 ↗
46. Phase transformation on heating of an aged cement paste10.1016/j.tca.2003.11.057 ↗
47. Effect of high temperatures on the microstructure of cement paste
48. In situ X-ray pair distribution function analysis of accelerated carbonation of a synthetic calcium–silicate–hydrate gel10.1039/C5TA00348B ↗
49. Investigation of the carbonation mechanism of CH and C-S-H in terms of kinetics, microstructure changes and moisture properties10.1016/j.cemconres.2013.11.015 ↗
50. Worsfold · 2019
51. Effect of supplementary cementitious materials on carbonation of cement pastes10.1016/j.cemconres.2021.106358 ↗
52. Carbonation of ternary building cementing materials10.1016/j.cemconcomp.2012.06.016 ↗
53. Investigation of the carbonation front shape on cementitious materials: effects of the chemical kinetics10.1016/j.cemconres.2007.04.002 ↗
54. Multi-scale investigation on mechanical behavior and microstructural alteration of CSH in carbonated Alite paste10.1016/j.cemconres.2021.106448 ↗
55. Microstructure and properties of fly ash/cement-based pastes activated with MgO and CaO under hydrothermal conditions10.1016/j.cemconcomp.2020.103739 ↗
56. Determination of thermal properties of some supplementary cementing materials used in cement and concrete10.1016/j.conbuildmat.2004.10.001 ↗
57. Effect of polyacrylamide on the carbonation behavior of cement paste10.1016/j.cemconres.2022.106756 ↗
58. Activation of gypsum anhydrite-slag mixtures10.1016/0008-8846(95)00018-6 ↗
59. Dolomitic lime: thermal decomposition of nesquehonite10.1016/j.tca.2004.04.007 ↗
60. Microstructure development and mechanism of hardened cement paste incorporating graphene oxide during carbonation10.1016/j.cemconcomp.2018.08.016 ↗
61. Carbonization of porous concrete and its main binding components10.1016/0008-8846(71)90019-6 ↗
62. Elucidating the accelerated carbonation products of calcium silicates using multi-technique approach10.1016/j.jcou.2017.11.003 ↗
63. Carbonation of CH and C–S–H in composite cement pastes containing high amounts of BFS10.1016/j.cemconres.2009.10.020 ↗
64. Investigation of the carbonation mechanism of CH and CSH in terms of kinetics, microstructure changes and moisture properties10.1016/j.cemconres.2013.11.015 ↗
65. Carbonation of C–S–H and C–A–S–H samples studied by 13C, 27Al and 29Si MAS NMR spectroscopy10.1016/j.cemconres.2015.01.019 ↗
66. Structural features of C–S–H (I) and its carbonation in air—a Raman spectroscopic study. Part II: carbonated phases10.1111/j.1551-2916.2006.01429.x ↗
67. Effect of carbonation curing regime on strength and microstructure of Portland cement paste10.1016/j.jcou.2019.05.034 ↗
68. Experimental studies and thermodynamic modeling of the carbonation of Portland cement, metakaolin and limestone mortars10.1016/j.cemconres.2016.06.006 ↗
69. Solubility of amorphous calcium carbonate10.1016/0022-0248(89)90168-1 ↗
70. The formation and transformation mechanism of calcium carbonate in water10.1016/0016-7037(87)90155-4 ↗
71. Multi-scale investigation on mechanical behavior and microstructural alteration of C-S-H in carbonated Alite paste10.1016/j.cemconres.2021.106448 ↗
72. Mechanisms of carbonation hydration hardening in Portland cements10.1016/j.cemconres.2021.106687 ↗