Effect of reinforcement content on the density, mechanical and tribological properties of Ti 3 SiC 2 /Al 2 O 3 hybrid reinforced copper-matrix pantograph slide
Source abstract
Abstract
Abstract As an important part of the pantograph and catenary system, the pantograph slide receives increasing attention from investigators, mainly focused on the interfacial bonding and characteristics, electrical conductivity, and friction and wear characteristics under current-carrying circumstances. In the article, hybrid reinforcements of titanium silicon carbide (Ti 3 SiC 2 ) and nano-alumina (nano-Al 2 O 3 ) particles pretreated by electroless plating process were firstly blended with copper powders and then prepressed and vacuum hot pressed to fabricate the hybrid reinforced copper-matrix pantographs (HRCPs). The relative density, mechanical and electrical properties of Ti 3 SiC 2 /Al 2 O 3 HRCPs were calculated and measured. The tribological performance of the HRCPs reinforced with 1 wt%~5 wt% of alumina particles and 20 wt%~40 wt% of Ti 3 SiC 2 reinforcements was also analyzed.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Electrical Contact Performance and Analysis · MXene and MAX Phase Materials · Mechanical stress and fatigue analysis
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
Affiliations
College of Material Science and Technology , Nanjing University of Aeronautics and Astronautics , Nanjing 211106 , P.R. China
Department of Mechanical and Electronic Engineering , Jiangsu Polytechnic of Finance and Economics , Huai’an, Jiangsu 223003 , China
Funding
National Natural Science Foundation of China
References (23)
Show source-provided references
1. Zhang WH, Zeng J, Li Y. Int. J. Dyn. Control 2013, 1, 81–97.10.1007/s40435-013-0005-110.1007/s40435-013-0005-1 ↗
2. Tuissi A, Bassani P, Casati R, Bocciolone M, Collina A, Carnevale M, Lo Conte A, Previtali B. J. Mater. Eng. Perform. 2009, 18, 612–619.10.1007/s11665-009-9453-310.1007/s11665-009-9453-3 ↗
3. Zhang WH, Zhou N, Li RP, Mei GM, Song DL. J. Mod. Transport. 2011, 9, 7–11.10.1007/BF03325734 ↗
4. Shi XL, Wang M, Xu ZS, Zhai WZ, Zhang QX. Mater. Design 2013, 45, 365–376.10.1016/j.matdes.2012.08.06910.1016/j.matdes.2012.08.069 ↗
5. Barsoum MW, Raghy TE. J. Am. Ceram. Soc. 1996, 79, 1953–1956.10.1111/j.1151-2916.1996.tb08018.x10.1111/j.1151-2916.1996.tb08018.x ↗
6. Zhang HB, Bao YW, Zhou YC. J. Mater. Sci. Technol. 2009, 25, 1–38.10.1179/174328409X397247
7. Sun Z, Zhou Y, Li M. Acta Mater. 2001, 49, 4347–4353.10.1016/S1359-6454(01)00247-610.1016/S1359-6454(01)00247-6 ↗
8. Ngai TL, Zheng W, Li YY. Prog. Nat. Sci. Mater. Int. 2013, 23, 70–76.10.1016/j.pnsc.2013.01.01110.1016/j.pnsc.2013.01.011 ↗
9. Gupta S, Filimonov D, Palanisamy T, Barsoum MW. Wear 2008, 265, 560–565.10.1016/j.wear.2007.11.01810.1016/j.wear.2007.11.018 ↗
10. Barsoum MW, El-Raghy T. J. Am. Ceram. Soc. 1996, 79, 1953–1956.10.1111/j.1151-2916.1996.tb08018.x10.1111/j.1151-2916.1996.tb08018.x ↗
11. Sun ZM, Zhou YC, Li S. J. Mater. Sci. Technol. 2002, 18, 142–145.10.1093/oq/18.1.142 ↗
12. Zhang Y, Ding GP, Zhou YC, Cai BC. Mater. Lett. 2002, 55, 285–289.10.1016/S0167-577X(02)00379-810.1016/S0167-577X(02)00379-8 ↗
13. Shi XL, Zhai WZ, Wang M, Xu ZS, Yao J, Song SY, Qamaruddin A, Zhang QX. Wear 2013, 303, 244–254.10.1016/j.wear.2013.03.034
14. Sun ZM, Zhou YC. J. Mater. Sci. Technol. 2002, 18, 142–145.10.1093/oq/18.1.142 ↗
15. Barsoum MW, Zhen T, Kalidindi SR, Radovic M, Murugaiah A. Nat. Mater. 2003, 2, 107–111.10.1038/nmat81410.1038/nmat814 ↗
16. Chin YL, Tuan WH. Mater. Sci. Eng. A 2011, 528, 3270–3274.10.1016/j.msea.2010.12.08410.1016/j.msea.2010.12.084 ↗
17. Lu JR, Zhou Y, Zheng Y, Li HY, Li SB. Adv. Appl. Ceram. 2015, 114, 39–44.10.1179/1743676114Y.000000018510.1179/1743676114Y.0000000185 ↗
18. Zhou Y, Chen B, Wang X, Yan C. Mater. Sci. Technol. 2004, 20, 661–665.10.1179/02670830422501658110.1179/026708304225016581 ↗
19. Zhang Y, Sun ZM, Zhou YC. Mater. Res. Innov. 1999, 3, 80–84.10.1007/s10019005012910.1007/s100190050129 ↗
20. Kothalkar A, Cerit A, Proust G, Basu S, Radovic M, Karaman I. Mater. Sci. Eng. A 2015, 622, 168–177.10.1016/j.msea.2014.10.03310.1016/j.msea.2014.10.033 ↗
21. Alexandrov IV, Islamgaliev RK, Valiev RZ, Zhu YT, Lowe TC. Metall. Mater. Trans. A 1998, 29, 2253–2260.10.1007/s11661-998-0103-410.1007/s11661-998-0103-4 ↗
22. Coble RL. J. Appl. Phys. 1961, 32, 787–792.10.1063/1.173610710.1063/1.1736107 ↗
23. Mazahery A, Shabani MO. Compos. Part B-Eng. 2012, 43, 1302–1308.10.1016/j.compositesb.2012.01.01110.1016/j.compositesb.2012.01.011 ↗