journal article·2025-12

Magnetic Properties of Low-Carbon Steel Plate under Elastic Bending

A. N. Stashkov, A. M. Matosyan, A. P. Nichipuruk, N. V. Gordeev

Publisher page

Abstract

Abstract Experimental field dependences of the measuring coil signal, proportional to the reversible magnetic permeability, were obtained on an elastically deformed (by bending) plate made of low-carbon steel 20 during its remagnetization along the major hysteresis loop by a U-shaped attached electromagnet (AEM). Additionally, during magnetization, a local area of the plate was subjected to a variable magnetic field using a flat coil placed between the poles of the AEM. The measuring coil, located on the same frame as the bias coil, was in contact with the plate surface. Magnetic property measurements were taken from both sides of the plate in its central part. It was established that the curves measured with the AEM installed on the top and bottom of the deformed plate differ significantly. On the curves measured from the top side of the plate, where the surface experiences maximum compressive stresses, one central peak in the region of the coercive force and two additional infections (peaks) on both sides of it are observed. On the curves measured from the tension side of the plate, additional infections were observed only at low frequencies of the bias field, when the signal from the measuring coil also contained information about the compressed layers of the plates. The fields at which the inflections occur depend both on the applied load (magnitude of stresses) and on the frequency of the bias field generated by the primary transducer coil. The dependence of the average field of the peaks on the load applied to the plate is close to linear.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Magnetic Properties and Applications · Non-Destructive Testing Techniques · Material Properties and Failure Mechanisms

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (41)

Show source-provided references
1. Hellier, C., Handbook of Nondestructive Evaluation, New York: McGraw-Hill, 2003.
2. Doig, P. and Flewitt, P.E.J., Non-destructive stress measurement using X-ray diffraction methods, NDT Int., 1978, vol. 11, no. 3, pp. 127–131.10.1016/0308-9126(78)90022-6 ↗
3. Murayam, R. and Misumi, K., Development of a non-contact stress measurement system during tensile testing using the electromagnetic acoustic transducer for a Lamb wave, NDT & E Int., 2006, vol. 39, no. 4, pp. 299–303.10.1016/j.ndteint.2005.08.009 ↗
4. Crecraft, D.I., The measurement of applied and residual stresses in metals using ultrasonic waves, J. Sound Vib., 1967, vol. 5, no. 1, pp. 173–192.10.1016/0022-460X(67)90186-1 ↗
5. Haugwitz, C., Schardt, A., Hahn-Jose, T., et al., Non-contact ultrasonic stress measurement using lamb waves, NDT & E Int., 2025, vol. 155, p. 103419.10.1016/j.ndteint.2025.103419 ↗
6. Fagan, P., Ducharne, B., Daniel, L., Skarlatos, A., Domenjoud, M., and Reboud, C., Effect of stress on the magnetic Barkhausen noise energy cycles: A route for stress evaluation in ferromagnetic materials, Mater. Sci. Eng., B, 2022, vol. 278, p. 115650.10.1016/j.mseb.2022.115650 ↗
7. Su, F., Methodology for the stress measurement of ferromagnetic materials by using magneto acoustic emission, Exp. Mech., 2014, vol. 54, no. 8, pp. 1431–1439.10.1007/s11340-014-9920-0 ↗
8. Gauthier, J., Krause, T.W., and Atherton, D.L., Measurement of residual stress in steel using the magnetic Barkhausen noise technique, NDT & E Int., 1998, vol. 31, no. 1, pp. 23–31.10.1016/S0963-8695(97)00023-6 ↗
9. Stewart, D.M., Stevens, K.J., and Kaiser, A.B., Magnetic Barkhausen noise analysis of stress in steel, Curr. Appl. Phys., 2004, vol. 4, nos. 2–4, pp. 308–311.10.1016/j.cap.2003.11.035 ↗
10. Krause, T.W., Clapham, L., and Atherton, D.L., Characterization of the magnetic easy axis in pipeline steel using magnetic Barkhausen noise, J. Appl. Phys., 1994, vol. 75, no. 12, pp. 7983–7988.10.1063/1.356561 ↗
11. Ducharne, B., Gupta, B., Hebrard, Y., and Coudert, J.B., Phenomenological model of Barkhausen noise under mechanical and magnetic excitations, IEEE Trans. Magn., 2018, vol. 54, no. 11, pp. 1–6.10.1109/TMAG.2018.2833419 ↗
12. Vengrinovich, V., Vintov, D., Prudnikov, A., Podugolnikov, P., and Ryabtsev, V., Magnetic Barkhausen effect in steel under biaxial strain/stress: Influence on stress measurement, J. Nondestr. Eval., 2019, vol. 38, no. 2, p. 52.10.1007/s10921-019-0576-7 ↗
13. Wu, J., Liu, C., Li, E., Zhu, J., Ding, S., and Wang, Y., Motion-induced magnetic Barkhausen noise for evaluating applied stress in pipelines, J. Nondestr. Eval., 2020, vol. 39, no. 4, p. 83.10.1007/s10921-020-00729-7 ↗
14. Deng, D.G. and Wu, X.J., Feasibility study of determining axial stress in ferromagnetic bars using reciprocal amplitude of initial differential susceptibility obtained from static magnetization by permanent magnets, J. Magn. Magn. Mater., 2018, vol. 449, pp. 243–256.10.1016/j.jmmm.2017.10.039 ↗
15. Chen, Z.J., Jiles, D.C., and Kameda, J., Estimation of fatigue exposure from magnetic coercivity, J. Appl. Phys., 1994, vol. 75, no. 10, pp. 6975–6977.10.1063/1.356746 ↗
16. Daniel, L., An analytical model for the effect of multiaxial stress on the magnetic susceptibility of ferromagnetic materials, IEEE Trans. Magn., 2013, vol. 49, no. 5, pp. 2037–2040.10.1109/TMAG.2013.2239264 ↗
17. Altpeter, I., Dobmann, G., Kröning, M., Rabung, M., and Szielasko, S., Micro-magnetic evaluation of micro residual stresses of the IInd and IIIrd order, NDT & E Int., 2009, vol. 42, no. 4, pp. 283–290.10.1016/j.ndteint.2008.11.007 ↗
18. Stefanita, C.G., Atherton, D.L., and Clapham, L., Plastic versus elastic deformation effects on magnetic Barkhausen noise in steel, Acta Mater., 2000, vol. 48, no. 13, pp. 3545–3551.10.1016/S1359-6454(00)00134-8 ↗
19. Gorkunov, E.S. and Mushnikov, A.N., Magnetic methods for assessing elastic stresses in ferromagnetic steels (review), Kontrol’ Diagn., 2020, vol. 23, no. 12, p. 270.
20. Kulak, S.M. and Novikov, V.F., Monitoring of mechanical stresses in steel structures and facilities experiencing multiaxial strains, Kontrol’ Diagn., 2016, no. 5, pp. 55–60.10.14489/td.2016.05.pp.055-060 ↗
21. Bozorth, R.M., Ferromagnetism, New York: Wiley, 1993.10.1109/9780470544624 ↗
22. Vonsovskii, S.V. and Shur, Ya.S., Ferromagnetizm (Ferromagnetism), Moscow: OGIZ, 1948.
23. Brown, W.F., Influence of field and stress on magnetization changes, Phys. Rev., 1949, vol. 75, pp. 147–158.10.1103/PhysRev.75.147 ↗
24. Bulte, D.P. and Langman, R.A., Origins of the magnetomechanical effect, J. Magn. Magn. Mater., 2002, vol. 251, no. 2, pp. 229–243.10.1016/S0304-8853(02)00588-7 ↗
25. Chikazumi, S., Physics of Ferromagnetism, International Series of Monographs on Physics, vol. 94, Oxford: Clarendon, 1978.
26. Jiles, D.C., Theory of the magnetomechanical effect, J. Phys. D: Appl. Phys., 1995, vol. 28, no. 8, p. 1537.10.1088/0022-3727/28/8/001 ↗
27. Atherton, D.L. and Jiles, D.C., Effects of Stress on the Magnetization of Steel, IEEE Trans. Magn., 1983, vol. 19, no. 5, pp. 2021–2023.10.1109/TMAG.1983.1062784 ↗
28. Kuleev, V.G. and Tsar’kova, T.P., Effect of plastic deformations and heat treatment on the behavior of the coercive force under load, Phys. Metals Metallogr., 2007, vol. 104, pp. 461–468.10.1134/S0031918X0711004X ↗
29. Kuleev, V.G., Tsar’kova, T.P., and Kazantseva, Z.V., Effect of plastic deformations on the dependence of the remanence of steels on elastic tensile stresses, Phys. Metals Metallogr., 2009, vol. 107, pp. 435–438.10.1134/S0031918X09050032 ↗
30. Stashkov, A.N., Nichipuruk, A.P., and Shchapova, E.A., Mobile magnetometric complex for monitoring residual mechanical stresses in steel structures, Nauchn. Priborostr., 2019, vol. 29, no. 1, pp. 47–54.10.18358/np-29-1-i4754 ↗
31. Stashkov, A.N., Schapova, E.A., Nichipuruk, A.P., and Korolev, A.V., Magnetic incremental permeability as indicator of compression stress in low-carbon steel, NDT & E Int., 2021, vol. 118, pp. 102398–102402.10.1016/j.ndteint.2020.102398 ↗
32. Wang, N., Li, P., Li, T., Wang, Y., He, C., and Liu, X., Quantitative characterization of tensile stress in electroplated nickel coatings with a magnetic incremental permeability sensor, Sens. Actuators, A, 2024, vol. 368, p. 115082.10.1016/j.sna.2024.115082 ↗
33. Makar, J.M. and Atherton, D.L., Effect of Uniaxial Stress on the Reversible and Irreversible Permeabilities of 2% Mn Pipeline Steel, IEEE Trans. Magn., 1994, vol. 30, no. 4, pp. 1380–1387.10.1109/20.305536 ↗
34. Novikov, V.F., Zakharov, V.A., Ul’yanov, A.I., et al., The influence of biaxial elastic deformation on the coercive force and local remanent magnetization of construction steels, Russ. J. Nondestr. Test., 2010, vol. 46, pp. 520–526.10.1134/S1061830910070065 ↗
35. Kostin, V.N., Kadrov, A.V., and Kuskov, A.E., Magnetic properties of a material used to estimate elastic and plastic strains of ferrite-pearlite steels, Russ. J. Nondestr. Test., 2005, vol. 41, pp. 632–639.10.1007/s11181-006-0014-7 ↗
36. Aginei, R.V. and Leonov, I.S., Study of the change in coercive force and hardness parameters of pipe walls during bending deformation, Truboprovodn. Transp.: Teor. Prakt., 2012, no. 3, pp. 39–42.
37. Malakhov, I.S., Sokolov, R.A., and Muratov, K.R., Investigation of the influence of biaxial mechanical loading on the magnetic characteristics and harmonic spectrum of spring steel 65G, Zavod. Lab., Diagn. Mater., 2025, vol. 91, no. 5, pp. 31–37.
38. Mushnikov, A.N., Povolotskaya, A.M., Zadvorkin, S.M., and Kryucheva, K.D., The influence of biaxial symmetric tension on the magnetic properties of a composite specimen made of two steel plates with different mechanical and magnetic properties, Russ. J. Nondestr. Test., 2024, vol. 60, pp. 1015–1027.10.1134/S1061830924700773 ↗
39. Myznov, K.E., Kenofontov, D.G., Afanas’ev, S.V., Vasilenko, O.N., Kostin, V.N., Bondina, A.N., Topori-shchev, A.S., Kukushkin, S.S., and Salomatin, A.S., Determination of magnetic properties of pipe steels during bending tests, Defektoskopiya, 2025, no. 6, pp. 70–74.10.7868/S3034498025060073 ↗
40. Bershtein, M.L. and Zaimovskii, V.A., Mekhanicheskie svoistva metallov (Mechanical Properties of Metals), Moscow: Metallurgiya, 1979.
41. Mikheev, M.N., Topography of magnetic induction in products during their local magnetization by attached electromagnets, Izv. Akad. Nauk SSSR. Otd. Tekh. Nauk, 1943, nos. 3–4, pp. 68–77.