Determination of the physic and mechanical characteristics of isotropic pyrolitic graphite by dynamic indentation method
Source abstract
Abstract
The ability to evaluate the physic and mechanical characteristics (elastic modulus, hardness, and strength) of isotropic pyrographite by dynamic indentation has been shown. The reliability of the technique was confirmed by independent tests with the use of the ultrasonic method. The correlation between the physic and mechanical characteristics determined by dynamic indentation and those estimated by the standard destructive tests has been established. The proposed method not only allows one to omit the preparation of the standard samples; it also allows the inspection of the final isotropic pyrographite-based products during their use without violating their integrity.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Advanced materials and composites · High-Velocity Impact and Material Behavior · Advanced ceramic materials synthesis
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (12)
Show source-provided references
1. www.himekb.ru/pirografit-izotropnyi.doc.
2. GOST (State standard) no. 2999-75: Metals and Alloys. The Vickers Method for Hardness Measurements, 1987.
3. GOST (State standard) no. 9550-81: Plastics. Methods for Determination of Elastic Modulus at Tension, Compression and Bending, 2004.
4. GOST (State standard) no. 4651-82: Plastics. Methods for Compression Tests, 1998.
5. Kren, A.P. and Naumov, A.O., Determination of the relaxation function for viscoelastic materials at low velocity impact. Int. J. of Impact Eng., 2010, vol. 37, no. 2, pp. 170–176.
6. Kren, A.P., Determination of the critical stress intensity factor of glass under conditions of elastic contact by the dynamic indentation method. Strength of Mater., 2009, vol. 41, no. 6, pp. 628–636.
7. ISO no. 14577: Metallic Materials. Instrumented Indentation Test for Hardness and Materials Parameters, 2002.
8. Oliver, W.C. and Pharr, G.M. Measurement of hardness and elastic modulus by instrumented indentation: Advances in understanding and refinements to methodology. J. Mater. Res., 2004, vol. 19, no. 1, pp. 3–20.
9. Sneddon, I.N. The relation between load and penetration in the axisymmetric Boussinesq problem for a punch of arbitrary profile. Int. J. Eng. Sci., 1965, no. 3, pp. 47–57.
10. Popov, V.L. Kontaktmechanik und Reibung. Ein Lehr- und Anwendungsbuch von der Nanotribologiebiszurnumerischen Simulation, Berlin: Springer, 2009.
11. GOST (State standard) no. 1497-84: Metals. Methods for Tension Tests, 2005.
12. GOST (State standard) no. 22761-77: Metals and Alloys. The Brinell Method for Hardness Measurements by Portable Static Hardmeters, 2003.