journal article·2005-05

Influence of the Composition and Structure of B4C - Al2O3 Ceramic on the Tribotechnical Characteristics in Friction Against Steel

Yu. G. Tkachenko, V. T. Varchenko, V. F. Britun, D. Z. Yurchenko

Powder Metallurgy and Metal Ceramics· Volume 44· Issue 5-6
Publisher page

Abstract

The morphology and phase composition of friction surfaces and the tribotechnical properties of the (B4C - Al2O3)-steel 45 system are studied under dry friction at various sliding velocities and contact loads. We have found that fine-grained secondary structures are formed on the friction surfaces. The morphology and phase composition of these structures depend on the ceramic composition and on the test conditions. A comprehensive investigation of friction surfaces, using x-ray, electron-diffraction electron-probe, and electron-microscopy analysis, has shown that the structure and morphology of the secondary phases determine the tribotechnical properties of ceramic-steel couples. The maximum wear resistance of B4C ceramics containing 5-20 mass% Al2O3 is determined by the formation of dense secondary-phase thin films on the friction surface.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Surface Treatment and Coatings · Aluminum Alloys Composites Properties · Mechanical Systems and Engineering

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (6)

Show source-provided references
1. T. A. Libach, P. C. Becker, and S. K. Rhee, “Dry friction and wear of toughened aluminas against steel,” Wear, 110, Nos.4–5, 263–283 (1986).
2. Yu. G. Gogotsi, A. M. Koval'chenko, I. A. Kossko, and V. P. Yaroshenko, “Friction interaction of ceramic based on nonmetallic refractory compounds against steel,” Trenie i Iznos, 11, No.4, 660–667 (1990).
3. A. M. Koval'chenko, I. I. Osipova, Yu. G. Gogotsi, et al., “Influence of sliding velocity on the wear of a ceramic-steel pair without lubrication,” Trenie i Iznos, 13, No.4, 654–663 (1992).
4. A. G. Evans and T. G. Langedon, Structural Ceramics, Pergamon Press, New York (1976).
5. A. G. Evans and E. A. Charles, “Fracture toughness determination by indentation,” J. Amer. Ceram. Soc. 59, Nos.7–8, 371–372 (1977).
6. V. V. Polotai, “Friction and wear testing machines,” Tekhnol. Organiz. Proizvodstva, No. 6, 86–88 (1970).