Effect of the composition and structure of silicon carbide composites on wear mechanisms
Source abstract
Abstract
The tribotechnical characteristics of SiC–Al2O3 and SiC–Al2O3–ZrO2 ceramic composites are studied during dry plane-on-plane friction in a wide range of velocities (2–7 m/sec) and loadings (1– 7 MPa). This testing pattern allows modeling the performance of composites as sealing elements for centrifugal pumps. The influence of 20, 50, and 80 wt.% aluminum oxide in silicon carbide on the wear rate and wear mechanisms is analyzed. It is shown that higher alumina content of the SiC–Al2O3 ceramics changes the wear mechanisms: oxidative–adhesive wear takes place in materials containing 20 wt.% Al2O3 and mechanochemical wear in SiC–80 wt.% Al2O3. The tribotechnical characteristics of SiC–Al2O3–ZrO2 (SIAL-Z) ceramics have been studied. The ratio of aluminum and zirconium oxides in this material is eutectic, which substantially decreases the hot pressing temperature and promotes a fine-grained structure. Oxidative wear takes place in friction of the SIAL-Z ceramics against a steel counterface. This composite has the highest tribotechnical characteristics among the materials of interest.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Tribology and Wear Analysis · Mechanical Systems and Engineering · Advanced ceramic materials synthesis
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (4)
Show source-provided references
1. O. P. Umanskii, A. G. Dovgal’, V. I. Subotin, and O. D. Kostenko, “Development of ceramic wear-resistant material based on silicon carbide for high-velocity friction units,” Visn. Nats. Aviat. Univ., No. 1, 65–71 (2011).
2. A. G. Dovgal’, O. P. Umanskii, O. A. Tamargazin, et al., Composite Wear-Resistant Materials Based on Silicon Carbide [in Ukrainian], Ukrainian Patent 53010, IPC C22C 29/02, Bulletin No. 18, Inst. Probl. Materialoved. (patent holder); No. 201001338; appl. February 9, 2010; publ. September 27 (2010), p. 6.
3. E. T. Mamykin, M. K. Kovpak, A. I. Yuga, et al., “A set of machines and a method for determining the bearing characteristics of materials under sliding friction conditions,” Powder Metall. Met. Ceram., 12, No. 1, 55–58 (1973).10.1007/BF00803978 ↗
4. A. A. Fotiev, L. L. Surat, V. G. Dobosh, and V. G. Mizin, “Analysis of phase ratios in systems containing V2O3, Fe2O3, Cr2O3, Al2O3, TiO2, and SiO2,” Zh. Neorg. Chim., 29, No. 5, 1277–1279 (1984).