Coatings Deposited by the High-Velocity Flame Spraying Method
Source abstract
Abstract
The properties (porosity, hardness, wear resistance) of coatings obtained by high-velocity flame spraying were studied. It was shown that high-velocity spraying produces highly dense coatings (porosity below 3%) which have good abrasion resistance under extreme conditions: resistance to abrasive-erosion was 10-12 times better than that of uncoated steel. Abrasive wear resistance at low attack angles was obtained in coatings of maximum hardness, i.e., hardness above that of the abrasive. At high attack angles an optimum ratio of hardness to ductility is desired. The optimal structure for WC ― Co coatings is the so-called twice cemented hard alloy structure, in which granules or particles of WC ― Co are included within the cobalt binder. At large attack angles the concentration of carbide phase should exceed 50%, and at normal angles is optimally 20-30%.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Surface Treatment and Coatings · Advanced materials and composites · Metal Alloys Wear and Properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (10)
Show source-provided references
1. P. Kallas, P. Kulu, J. Pirso, and A. Tymanok, Deformation and Fracture in Structural Materials, Proc. Int. Conf., Bratislava (1996), pp. 199-209.
2. A. Tymanok, P. Kulu, D. Goldanjin, and S. Roshtsin, The Recycling of Metals, Proc. III ASM Int. Conf. and Exhibition, Barcelona (1997), pp. 513-522.
3. P. Kula, A. Tymanok, and D. Arensburger, et al., Proc. Estonian Acad. Sci. Eng., Nos. 1-2, 49-60 (1996).10.3176/eng.1996.1.06 ↗
4. P. Kulu, A. Tymanok, and S. Zimakov, Proc. of IV Int. Conf. and Exhibition on the Recycling of Metals, Vienna (1999), pp. 319-327.
5. P. Kulu, T. Pihl, and S. Zimakov, Proc. of Int. Conf. BALTTRIB 99, Kaunas (1999), pp. 311-318.
6. P. Kulu, “Tribologia,” Finnish J. Tribology, 8, No.4, 12-25 (1989).
7. P. Kulu and J. Halling, J. Thermal Spray Technology, 7, No. 2, 173-178 (1998).10.1361/105996398770350882 ↗
8. P.J. Kallas, Wear, 198, 77-85 (1996).10.1016/0043-1648(96)06941-4 ↗
9. S. Daillaire, J. G. Legoux, and H. Levert, Thermal Spray Technology, 4, No. 2, 163-168 (1995).10.1007/BF02646107 ↗
10. J. Jacobs, M. Hyland, and M. DeBonte, Thermal Spray Technology, 7, No. 2, 213-218 (1998).10.1361/105996398770350954 ↗