journal article·2020-01

Effect of Scandium on the Structure and Corrosion Properties of Vapor-Deposited Nanostructured Quasicrystalline Al–Cu–Fe Films

S.I. Ryabtsev, V.A. Polonskyy, O.V. Sukhova

Powder Metallurgy and Metal Ceramics· Volume 58· Issue 9-10
Publisher page

Abstract

The structure and corrosion properties of quasicrystalline Al–Cu–Fe and Al–Cu–Fe–Sc films 200–260 nm thick produced by three-electrode ion-plasma sputtering of assembled targets were studied. The structural and phase composition of the films was determined by transmission and scanning electron microscopy, electron microprobe analysis, and X-ray diffraction. The corrosion properties were examined in 3, 5, and 16% aqueous NaCl solutions (pH = 6.9) at room temperature. An icosahedral fine quasicrystalline phase was found to form in the films deposited. The sizes of coherent scattering domains indicate that the coatings are nanostructured. The addition of 0.5 at.% Sc to the quasicrystalline Al–Cu–Fe films increases their corrosion resistance as evidenced by measurements of stationary potentials in saline solutions of different concentrations.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Quasicrystal Structures and Properties · Mineralogy and Gemology Studies · X-ray Diffraction in Crystallography

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (26)

Show source-provided references
1. O.V. Sukhova, “Influence of mechanisms of structure formation of interfaces in composites on their properties,” Metallofiz. Noveish. Technol., 31, No. 7, 1001–1012 (2009). 574
2. I.M. Spiridonova, E.V. Sukhovaya, S.B. Pilyaeva, and O.G. Bezrukavaya, “The use of composite coatings during metallurgical equipment parts repair,” Metall. Min. Ind., No. 3, 58–61 (2002).
3. E.V. Sukhovaya, “Structural approach to the development of wear-resistant composite materials,” J. Superhard Mater., 35, No. 5, 277–283 (2013).10.3103/S106345761305002X ↗
4. I.M. Spyrydonova, O.V. Sukhova, and G.V. Zinkovskij, “Thin films and composites based on quasicrystal Al–Cu–Fe alloy,” Metall. Min. Ind., 4, No. 4, 2–5 (2012).
5. E. Huttunen-Saarivirta, “Microstructure, fabrication and properties of quasicrystalline Al–Cu–Fe alloys: a review,” J. Alloys Compd., 363, No. 1–2, 150–174 (2004).
6. N.A. Spurr, P.J. Pinhero, D.J. Sordelet, K.R. Hebert, and P.A. Thiel, “Electrochemical pitting and repassivation on icosahedral Al–Cu–Fe, and comparison with crystalline phases,” Mater. Res. Soc. Symp. Proc., 553, 275–280 (1999).10.1557/PROC-553-275 ↗
7. E. Huttunen-Saarivirta and T. Tiainen, “Corrosion behavior of Al–Cu–Fe alloys containing a quasicrystalline phase,” Mater. Chem. Phys., 85, No. 2–3, 383–395 (2004).10.1016/j.matchemphys.2004.01.025 ↗
8. O.V. Sukhova, V.A. Polonskyy, and K.V. Ustinova, “The influence of Si and B on the structure and corrosion properties of quasicrystal Al–Cu–Fe alloys in saline solutions,” Metallofiz. Noveish. Technol., 40, No. 11, 1475–1487 (2018).10.15407/mfint.40.11.1475 ↗
9. O.V. Sukhova, V.A. Polonskyy, and K.V. Ustinova, “Microstructure and corrosion properties of quasicrystal Al–Cu–Fe alloys alloyed with Si and B in acidic solutions,” Vopr. Khim. Khim. Technol., No. 6, 77–83 (2018).
10. A. Rudiger and U. Koster, “Corrosion behavior of Al–Cu–Fe quasicrystals,” Mater. Sci. Eng., A294–296, 890–893 (2018).
11. D.S. Shaitura and A.A. Enaleeva, “Fabrication of quasicrystalline coatings: a review,” Crystallogr. Rep., 52, No. 6, 945–952 (2007).10.1134/S1063774507060041 ↗
12. I.M. Spiridonova, E.V. Sukhovaya, V.F. Butenko, A.P. Zhudra, A.I. Litvinenko, and A.I. Belyi, “Structure and properties of boron-bearing iron granules for composites,” Powder Metall. Met. Ceram., 32, No. 2, 139–141 (1993).10.1007/BF00560039 ↗
13. I.M. Spiridonova, E.V. Sukhovaya, and V.P. Balakin, “Structure and deformation peculiarities of Fe(B, C) crystals,” Metallurgia, 35, No. 2, 65–68 (1996).
14. Y. Kang, C. Zhou, S. Gong, and H. Xu, “Corrosion of Al–Cu–Fe–Cr quasicrystalline coating,” Mater. Sci. Forum, 475–479, 3355–3358 (2005).10.4028/www.scientific.net/MSF.475-479.3355 ↗
15. D.M. Rampulla, C.M. Mancinelli, I.F. Brunell, and A.J. Gellman, “Oxidative and tribological properties of amorphous and quasicrystalline approximant Al–Cu–Fe thin films,” Langmuir, No. 21, 4547–4553 (2005).10.1021/la0469093 ↗
16. E.J. Widjaja and L.D. Marks, “In situ studies of magnetron sputtered Al–Cu–Fe–Cr quasicrystalline thin films,” Thin Solid Films, No. 420–421, 295–299 (2002).10.1016/S0040-6090(02)00809-X ↗
17. J.L. Joulaud, C. Diot, and P. Donnadieu, “Structural analysis of quasicrystalline coatings obtained by cathodic sputtering,” in: Proc. 5th Int. Conf. Quasicrystals, World Scientific, Singapore (1995), pp. 726–729.
18. T. Eisenhammer, A. Mahr, A. Haugeneder, T. Reichhelt, and W. Assmann, “Deposition of thin quasicrystalline AlCuFe films for solar selective absorbers,” in: Proc. 5th Int. Conf. Quasicrystals, World Scientific, Singapore (1995), pp. 758–765.
19. B.S. Phillips and J.S. Zabinski, “Steam and water lubrication of quasicrystalline films,” Tribology Lett., 17, No. 3, 429–434 (2004).10.1023/B:TRIL.0000044519.31110.db ↗
20. S. Ryabtsev, P. Gusevik, V. Bashev, and F. Dotsenko, “A structure and physical properties of Ni films in metastable states,” J. Mater. Sci. Eng., A2, No. 9, 648–653 (2012).
21. F. F. Dotsenko and V. F. Bashev, “Physical preconditions of nonequilibrium state formation and estimation of deposited alloys composition,” Visn. DU. Phys. Radioelectron., No. 7, 8–17 (2001).
22. V.G. Efremenko, K. Shimizu, T.V. Pastukhova, Yu.G. Сhabak, K. Kusumoto, and A.V. Efremenko, “Effect of bulk heat treatment and plasma surface hardening on the microstructure and erosion wear resistance of complex-alloyed cast irons with spheroidal vanadium carbides,” J. Frict. Wear, 38, No. 1, 58–64 (2017). 575
23. W.A. Grant, A. Ali, L.T. Chadderton, P.J. Grundi, and E. Johnson, “Preparation of amorphous alloys by ion implantation,” in: Rapidly Quenched Metals [in Russian], Metallurgiya, Moscow (1983), pp. 52–57.
24. D. Holland-Moritz, J. Schroers, B. Grushko, D.M. Herlach, and K. Urban, “Dependence of phase selection and microstructure of quasicrystal-forming Al–Cu–Fe alloys on the processing and solidification conditions,” Mater. Sci. Eng., A226–228, 976–980 (1997).10.1016/S0921-5093(96)10830-3 ↗
25. M.V. Karpets and Yu.V. Milman, “Diffraction in-situ study of Al–Cu–Fe–X quasicrystalline powders for thermal-sprayed coatings,” Phys. Chem. Solid State, 6, No. 2, 203–206 (2005).
26. S.I. Ryabtsev, “Structure and properties of ion-plasma-deposited films of Fe–(Ag, Bi) alloys,” Phys. Met. Metallogr., 108, No. 3, 226–231 (2009).10.1134/S0031918X09090026 ↗