Comparative study of flexural and physical properties of graphite-filled immiscible polypropylene/epoxy and high-density polyethylene/epoxy blends

Polypropylene/epoxy/synthetic graphite (PP/EP/SG) and high-density polyethylene (HDPE/EP/SG) composites were prepared by melt mixing followed by compression molding. The immiscibility of the polyolefins with epoxy was confirmed by thermogravimetric analysis. Scanning electron microscopy (SEM) studies showed that HDPE/EP blend exhibits inferior interfacial adhesion between the component polymers compared to PP/EP blend. Also, the effect of SG content on flexural properties, density, moldability, water absorption, and porosity of the PP/EP/SG and HDPE/EP/SG composites was investigated. For both PP/EP/SG and HDPE/EP/SG composites, flexural modulus, density, and porosity increased with increase in SG content. For PP/EP/SG composites, the water absorption decreased from 0.154% at 30 wt% SG to 0.072% at 70 wt% SG. Further increase in SG content to 80 wt% caused an increase in water absorption. On the other hand, water absorption for HDPE/EP/SG increased with SG content all through. At the same filler loadings, PP/EP/SG composites showed lower density and porosity and performed better in terms of flexural modulus and water absorption compared to HDPE/EP/SG composites.