article·1992-07-16

Initial and Steady-State Creep

Longquan Shi, D. O. Northwood

Publisher page

Abstract

Creep tests on pure polycrystalline magnesium and an AISI type 310 stainless steel show that the creep rate ratio, F, between the initial creep rate, \documentclass{article}\pagestyle{empty}\begin{document}$ \dot \varepsilon \rm i $\end{document}, and the steady-state creep rate, \documentclass{article}\pagestyle{empty}\begin{document}$ \dot \varepsilon \rm S $\end{document}, is temperature and applied stress dependent. At lower test temperatures and/or applied stresses, F is large with values up to about 100, while at higher temperatures and/or applied stresses, it tends to unity. These observed temperature and stress dependencies of F provide support for Li's dislocation mechanism model for creep, in that the general creep equation can be reduced to two formulations, one with a large F ratio and one with F = 1. The apparent activation energy for creep, Qc, for both materials is also measured, and it is found that at the onset of the creep deformation (creep strain around 10−4), the measured Qc value is smaller than that measured in steady-state. The origins of this high creep rate ratio, F, and the low apparent activation energy, Qc, upon loading are discussed in terms of internal stress, a generalised deformation equation, and recent refinements to network creep theories.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: High Temperature Alloys and Creep · Magnesium Alloys: Properties and Applications · Aluminum Alloys Composites Properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References

Reference metadata was not supplied for this record.