Thermal conductivity and conditioning of grey expanded polystyrene foams

This article focuses on the thermal conductivity of 50 mm thick silver grey (infrared absorbing) expanded polystyrene (EPS) foam boards blown with pentane. The effect of short-term ageing from the point of production, by ambient conditioning at 23°C/50% RH, is compared to conditioning at an elevated temperature of 70°C. The declared thermal properties of the product and CE certification are fulfilled by the requirements of the European EPS product standard and SG19 Guidance. Measured thermal conductivity levels within 1% of the final value are acceptable and considered representative throughout the economic life of the product. Levels within the criteria were determined for 50 mm silver EPS after conditioning for 5 days at an elevated temperature of 70°C, whereas for conditioning at 23°C/50% RH the time taken was 23 days. The latter time is in good accord with retesting retained grey EPS boards of similar density and up to 9 years old, after initial testing 22 days from production, and conditioning at 23°C/50% RH. Elevated temperature conditioning increases the rate of diffusion of the blowing agent, but there has been concern about EPS beads softening above 60°C. Although there is little evidence from scanning electron microscopy of significant increase in perforation of the cell membranes at elevated temperatures, there is some indication of a small increase in wrinkling of the walls and intercell skeletal strands at 60°C and 70°C. It takes longer to eliminate the pentane gas by conditioning at 23°C/50% RH but there is no risk of material change from heat conditioning.