article·1985-08-16

Work-hardening rates during the steady-state creep of aluminum and alloys determined from stress-change tests

D. O. Northwood, I. O. Smith

Publisher page

Abstract

Work-hardening rates of aluminum and selected aluminum alloys during steady-state creep at 300 °C are determined from the instantaneous strains on sudden stress changes (increments and decrements). Alloys examined included Al-0.4% Li, Al-0.3% Li (in three different irradiated conditions), Al-2.73 at% Mg and Al-4.2 at% Mg. Work hardening rates, h, varied from about 0.1 to about 1 times Young's modulus, E. h/E decreases with increasing creep stress, σ. At a given value of σ, h/E is the lowest for polycrystalline aluminum and highest for the irradiated Al-0.3% Li alloys. Although the values for h/E are comparable to previously determined values for the creep of f.c.c., b.c.c. and h.c.p. metals, they are higher than strain-hardening rates determined from tensile tests. These differences are rationalized in terms of the dependence of work (strain) hardening on the strain rate.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Aluminum Alloys Composites Properties · Aluminum Alloy Microstructure Properties · High Temperature Alloys and Creep

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References

Reference metadata was not supplied for this record.