Influence of durability properties on life-cycle carbon reduction of low-carbon mortar with similar compressive strength
Source abstract
Abstract
The imperative for carbon reduction in the construction industry is gaining momentum. A pivotal strategy in this endeavor is the adoption of low-carbon cementitious materials and the enhancement of concrete structures' service life. The chloride-induced corrosion and water ingress in reinforced concrete is a pervasive issue, often resulting in premature structural failure and substantial economic loss. This study focuses on four low-carbon cementitious materials: calcium sulphoaluminate cement (CSA), CO 2 cured calcium sulphoaluminate cement (CSA-C), alkali-activated slag (AAS), and limestone calcined clay cement (LC 3 ). Different types of low-carbon mortars with similar compressive strength were used for mercury intrusion porosimetry, hydration phase analysis, chloride ion diffusion, and water permeability tests. The results reveal that AAS and LC 3 possess superior or similar chloride diffusion and water permeation resistance compared with Portland cement (PC) mortar. Life cycle assessment (LCA) and carbon emission analyses show that AAS and LC 3 produce markedly lower carbon emissions during production compared to PC. The expected repair time from the chloride ion diffusivity and water permeability suggests that LC 3 and AAS have extended repair time and reduced annual carbon emissions, underscoring their viability as PC alternatives. It is highlighted that the annual carbonation emissions taking concrete durability into consideration is a more appropriate index for assessing the environmental performance of low-carbon cementitious materials, rather than the total carbon emissions. • Durability of four low-carbon concrete under same strength was investigated. • CO 2 curing enhances pore structure and strength of CSA mortar. • LC 3 mortar has much lower chloride diffusivity and moderate water permeability. • AAS has the lowest total carbon emission from concrete production. • LC 3 and AAS have lower annual carbon emissions than PC.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Concrete and Cement Materials Research · Innovative concrete reinforcement materials · Building materials and conservation
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (42)
Show source-provided references
1. Alkali-activated materials10.1016/j.cemconres.2017.02.009 ↗
2. Synthesis of belite cements at low temperature from silica fume and natural commercial zeolite10.1016/j.mseb.2017.12.020 ↗
3. Solidification/stabilization of gold mine tailings using calcium sulfoaluminate-belite cement10.1016/j.jclepro.2019.118008 ↗
4. Effect of fly ash on properties evolution of cement based materials10.1016/j.conbuildmat.2014.07.029 ↗
5. Influences of limestone particle size distributions and contents on blended cement properties10.1016/j.conbuildmat.2014.08.004 ↗
6. Effect of water and nano-silica solution on the early stages cement hydration10.1016/j.conbuildmat.2016.11.009 ↗
7. Role of calcium on chloride binding in hydrated Portland cement–metakaolin–limestone blends10.1016/j.cemconres.2017.02.003 ↗
8. Fabrication and engineering properties of concretes based on geopolymers/alkali-activated binders - A review10.1016/j.jclepro.2020.120896 ↗
9. Investigation of mechanical properties and carbonation of concretes with construction and demolition waste and fly ash10.1016/j.conbuildmat.2017.07.143 ↗
10. Properties of alkali-activated slag mortar and prediction of its compressive strength10.1016/j.asej.2023.102536 ↗
11. Water vapor sorption isotherms, pore structure, and moisture transport characteristics of alkali-activated and Portland cement-based binders10.1016/j.cemconres.2018.07.006 ↗
12. Industrially interesting approaches to “low-CO2 ” cements10.1016/j.cemconres.2004.01.021 ↗
13. Calcium sulfoaluminate cement blended with OPC: a potential binder to encapsulate low-level radioactive slurries of complex chemistry10.1016/j.cemconres.2009.05.016 ↗
14. Hydration studies of calcium sulfoaluminate cements blended with fly ash10.1016/j.cemconres.2013.07.010 ↗
15. Study on the chloride ion binding rate of sulfoaluminate cement mortars containing different mineral admixtures
16. Cement substitution by a combination of metakaolin and limestone10.1016/j.cemconres.2012.09.006 ↗
17. Evaluation of test procedures for durability and permeability assessment of concretes containing calcined clay
18. Influence of cement replacement by limestone calcined clay pozzolan on the engineering properties of mortar and concrete10.1680/jadcr.18.00073 ↗
19. Superior CO2 uptake and enhanced compressive strength for carbonation curing of cement-based materials via flue gas10.1016/j.conbuildmat.2022.128364 ↗
20. Microstructural densification and CO2 uptake promoted by the carbonation curing of belite-rich Portland cement10.1016/j.cemconres.2016.01.001 ↗
21. Advancements in low-carbon concrete as a construction material for the sustainable built environment
22. Life cycle assessment (LCA) applied to the manufacturing of common and ecological concrete: a review10.1016/j.conbuildmat.2016.07.125 ↗
23. Durability of concrete coupled with life cycle assessment: review and perspective10.1016/j.cemconcomp.2023.105041 ↗
24. Service life and life cycle assessment of reinforced concrete systems with limestone calcined clay cement (LC3)10.1016/j.cemconres.2018.11.019 ↗
25. Full probabilistic service life prediction and life cycle assessment of concrete with fly ash and blast-furnace slag in a submerged marine environment: a parameter study10.1504/IJESD.2012.049141 ↗
26. Investigations on water vapor adsorption–desorption of cementitious materials and its induced permeability under isothermal steady-state flow10.1061/JMCEE7.MTENG-16442 ↗
27. GB/T 2419-2005, Test method for fluidity of cement mortar. 2005.
28. GB/T 17671-2021, Test method of cement mortar strength. 2021.
29. Atmospheric chloride-induced corrosion of steel-reinforced concrete beam exposed to real marine-environment for 7 years10.1016/j.oceaneng.2023.115675 ↗
30. A closed-form equation for predicting the hydraulic conductivity of unsaturated soils10.2136/sssaj1980.03615995004400050002x ↗
31. Environmental and technical assessment to support sustainable strategies for limestone calcined clay cement production in Brazil10.1016/j.conbuildmat.2021.125261 ↗
32. Emission characteristics of condensable particulate matter during the production of solid waste-based sulfoaluminate cement: compositions, heavy metals, and preparation impacts10.1016/j.chemosphere.2024.141871 ↗
33. Integrated petroleum coke and natural gas polygeneration process with zero carbon emissions10.1016/j.energy.2015.08.056 ↗
34. Limestone and class C fly ash blends activated with binary alkalis of Na2CO3–NaOH and MgO–NaOH: reaction products and environmental impact10.1016/j.cemconcomp.2023.104949 ↗
35. GB/T 51366-2019. Standard for building carbon emission calculation. 2019.
36. A closed-loop life cycle assessment of recycled aggregate concrete utilization in China10.1016/j.wasman.2016.05.031 ↗
37. Quantifying CO 2 emissions from China’s cement industry10.1016/j.rser.2015.05.031 ↗
38. A novel pore structure tortuosity concept based on nitrogen sorption hysteresis data10.1021/ie000626y ↗
39. Statistical analysis of chloride concentration distribution in concrete by a meso-scale model considering irregular shape aggregates10.1016/j.conbuildmat.2021.126143 ↗
40. GB/T 51438-2021. Standard for design of shield tunnel engineering. 2021.
41. Microstructure of cement paste subject to early carbonation curing10.1016/j.cemconres.2011.09.010 ↗
42. Flue gas carbonation curing of cement paste and concrete at ambient pressure10.1016/j.jclepro.2021.127943 ↗