journal article·2020-10

Radiation induced photocurrent in the active volume of P3HT/PCBM BHJ photodiodes

Michael A. Hupman, Irina Valitova, Ian G. Hill, Alasdair Syme

Publisher page

Abstract

Abstract The purpose of this work is to fabricate and characterize the response of a P3HT/PCBM bulk heterojunction organic photodiode to photon beams with respect to dose rate, total dose, and energy. A bulk heterojunction (BHJ) organic photodiode was fabricated by spin coating a blend of P3HT and PCBM onto an ITO-coated glass substrate and then depositing aluminum top contacts. Control devices were made by spin coating polystyrene instead of the P3HT/PCBM layer. The devices were irradiated with a 6 MV photon beam with dose rates of 100–600 cGy/min. Energy dependence was measured for energies of 100, 180, and 300 kVp and 6 and 10 MV. Photocurrent in the BHJ was calculated by subtracting the average current measured using the four PS devices from that measured with each of the four BHJ diodes to correct for current collected by the electrodes and the wires/connectors. The sensitivities of the four BHJ devices were within the range of 3.7–4.3 pC/cGy. The range of values is mostly due to inter-device variation and not due to variation between readings on the ITO and Al electrodes of a single device. The diodes exhibit an energy dependence with more than 4 times the response at 100 kVp than at 6 MV. The direction and magnitudes of the measured currents after correction for the electrode/lead currents were consistent with photocurrent. The photocurrents increased linearly with dose rate indicating they could be suitable in radiation sensing applications.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Organic Electronics and Photovoltaics · Conducting polymers and applications · Organic Light-Emitting Diodes Research

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (18)

Show source-provided references
1. Organic electroluminescent diodes10.1063/1.98799 ↗
2. Organic thin film transistors for large area electronics10.1002/1521-4095(20020116)14:2<99::AID-ADMA99>3.0.CO;2-9 ↗
3. A brief history of the development of organic and polymeric photovoltaics10.1016/j.solmat.2004.02.021 ↗
4. Ambient fabrication of flexible and large-area organic light-emitting devices using slot-die coating10.1038/ncomms2002 ↗
5. Stretchable, large‐area organic electronics10.1002/adma.200904054 ↗
6. Low‐power flexible organic light‐emitting diode display device10.1002/adma.201101066 ↗
7. Preliminary characterization of the response of an organic field effect transistor to ionizing radiation10.1016/j.radmeas.2018.08.008 ↗
8. Flexible radiation dosimeters incorporating semiconducting polymer thick films
9. Direct detection of 6 MV x-rays from a medical linear accelerator using a semiconducting polymer diode10.1088/0031-9155/58/13/4471 ↗
10. Characterization of thick film poly (triarylamine) semiconductor diodes for direct x-ray detection10.1063/1.3225909 ↗
11. Stability of X-ray detectors based on organic photovoltaic devices10.1109/JSTQE.2010.2048557 ↗
12. Enhanced x-ray detection sensitivity in semiconducting polymer diodes containing metallic nanoparticles10.1088/0022-3727/46/27/275102 ↗
13. Organic semiconducting single crystals as next generation of Low‐Cost, Room‐Temperature electrical X‐ray detectors10.1002/adma.201200283 ↗
14. Polymeric solar cells based on P3HT: PCBM: Role of the casting solvent10.1016/j.solmat.2011.07.039 ↗
15. Effect of P3HT: PCBM concentration in solvent on performances of organic solar cells10.1016/j.solmat.2009.01.019 ↗
16. A quantitative study of PCBM diffusion during annealing of P3HT: PCBM blend films10.1021/ma901444u ↗
17. Energy and angular distributions of photons from medical linear accelerators10.1118/1.595680 ↗
18. Evaluation of a dual bias dual metal oxide‐silicon semiconductor field effect transistor detector as radiation dosimeter10.1118/1.597314 ↗